Engineering topics
Publications and source records attributed to Westover, Andrew.
A high temperature multibeam-optical-stress sensor (HTMOSS) was used to characterize the coefficient of thermal expansion (CTE) and yield stress of 1-micron thick Lipon films.
The development of a solid electrolyte that can impede dendrite growth while still maintaining an appropriate level of conductivity is essential for improving performance of solid-state Li-ion battery. In this paper, we report the synthesis of single Li-ion conducting hairy nanoparticle (NP) materials that improved the cycling stability of lithium bis(trifluoromethanesulfonyl)imide (LiTFSI)-doped poly(ethylene oxide) (PEO) solid electrolyte without significant reduction in conductivity. To unveil mechanisms leading to improved cycling stability, several characterization techniques including broadband dielectric spectroscopy, differential scanning calorimetry, small angle X-ray scattering, transmission electron microscopy, and shear rheology were used to study properties of polymer composites (PC) with added hairy NPs. It was found that hairy NPs influenced the Li/electrolyte interface and improved mechanical properties of bulk composites, all of which contributed to homogenous Li plating and stripping. The improved performance has been found in composites with concentrations of 4.8 and 9.1 weight % of added hairy NPs, which enabled Li cycling stability at 0.2 mA cm–2 critical current density (>300 h) that was otherwise not possible in either PEO-LiTFSI alone or PEO-LiTFSI composites containing a polymer identical to that attached to hairy NPs. Based on the discovered ability of hairy NP to influence bulk and interfacial properties of solid electrolyte, their use as additives is expected to be equally effective in reducing dendrite formation in other electrolytes relevant for the design of solid-state battery.
Integrating sulfide separators into solid-state batteries (SSBs) containing high energy cathodes typically requires one or more materials and engineering solutions including: (i) applying interfacial coatings to mitigate electrolyte decomposition, (ii) applying high stack pressures to form robust solid-solid contacts, and (iii) using alloying anodes to avoid Li dendrite formation. Despite the promise of these approaches, a lack of standardized testing protocols makes it difficult to directly compare results among different studies. To address this problem, the present work benchmarks the performance of SSBs containing β-Li 3 PS 4 (LPS) separators and composite cathodes. By systematically varying the anode/cathode composition and stack pressure, this work demonstrates that cathode design is a major bottleneck for solid-state cells cycled at low rates (<100 µA cm -2 ). Operando stack pressure measurements show that, while mechanical confinement generally promotes higher active material utilization and cycling stability, this strategy alone does not address interfacial reactivity between LPS and high voltage cathodes. Here, these results also demonstrate that stress evolution during cycling is dominated by volume changes at the Li metal anode. Finally, we show that FeS 2 cathodes with moderate operating voltages (<3 V vs Li/Li + ) exhibit superior cycling performance compared to high voltage cathodes by facilitating formation of stable cathode/electrolyte interfaces.