Engineering Papers⌕ Search

Engineering topics

Wenzinger, Carl J

Publications and source records attributed to Wenzinger, Carl J.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1937

Pressure distribution over an airfoil section with a flap and tab

Report presents the results of wind tunnel tests made in the NACA 7 by 10-foot wind tunnel of a Clark Y airfoil with a flap and an inset tab. The pressures were measured on both the upper and lower surfaces at one chord section. Calculations were made of the normal-force and pitching-moment coefficients of the airfoil section with flap section with tab, and the normal-force and hinge-moments coefficients of the tab alone. In addition, comparisons were made of the theoretical and experimental values for an airfoil with a multiply hinged flap system.

Wenzinger, Carl J↗
NASA NTRS1937

Wind-tunnel investigation of tapered wings with ordinary ailerons and partial-span split flaps

Report presents the results of an investigation made in the NACA 7 by 10-foot wind tunnel to determine the aerodynamic properties of tapered wings having partial-span flaps for high lift and ordinary ailerons for lateral control. Each of two Clark-y wings, tapered 5:1 and 5:3, was equipped with partial-span split flaps of two lengths and with ordinary ailerons extending from the outboard ends of the flap to the wing tips. Measurements of wing forces and moments and of aileron hinge moments were made for the two conditions of flaps neutral and deflected.

Wenzinger, Carl J↗
NASA NTRS1935

Wind-tunnel research comparing lateral control devices, particularly at high angles of attack XII : upper-surface ailerons on wings with split flaps

This report covers the twelfth of a series of tests conducted to compare different lateral control devices with particular reference to their effectiveness at high angles of attack. The present wind tunnel tests were made with two sizes of upper-surface ailerons on rectangular Clark Y wing models equipped with full span split flaps. The tests showed the effect of the upper-surface ailerons and of the split flaps on the general performance characteristics of the wings, and on the lateral controllability and stability characteristics. The results are compared with those for plain wings with ordinary ailerons of similar sizes.

Weick, Fred E↗
NASA NTRS1934

The effects of full-span and partial-span split flaps on the aerodynamic characteristics of a tapered wing

The investigation was made to determine the effects of full-span and of partial-span split flaps on the aerodynamic characteristics of a tapered wing. Aerodynamic force tests were made in the N.A.C.A. 7 by 10 foot wind tunnel on a highly tapered Clark Y wing equipped with various split flaps. Two sizes of tapered-chord flaps were tested as full-span flaps, and a narrow tapered-chord flap was tested as a partial-span flap by cutting off portions first from the tip and then from the center. The investigation showed that with full-span split flaps the lift and drag characteristics of the tapered wing up to the stall are similar to those of a rectangular wing with flaps of comparable size, but that the stall of the tapered wing with full-span flaps occurs at progressively lower angles of attack with increasing flap deflection up to that for maximum lift. For partial-span tapered split flaps on a tapered wing it was found that the maximum lift is greater, and the lift-drag ratio at maximum lift is less, when the partial-span flap is located at the center of the wing than when it is located at the tip portion.

Wenzinger, Carl J↗
NASA NTRS1933

The effect of partial-span split flaps on the aerodynamic characteristics of a Clark Y wing

Aerodynamic force tests were made in the N.A.C.A. 7 by 10 foot wind tunnel on a model Clark Y wing with a 20 percent chord split flap deflected 60 degrees downward. The tests were made to determine the effect of partial-span split flaps, located at various positions along the wing span on the aerodynamic characteristics of the wing-and-flap combination. The different lengths and locations of the flaps were obtained by cutting off portions of a full-span flap, first from the tips and then from the center. The results are given in the form of curves of lift, drag, and center of pressure. They show that with partial-span split flaps both the lift and drag are less than with full-span flaps; that the lift for a given length of flap is somewhat greater when the partial span is located at the center of the wing than when it is located at the tip portion, and that the drag for a given length of flap is the same regardless of the location over the flap with respect to the wing span.

Wenzinger, Carl J↗
NASA NTRS1933

Wind tunnel research concerning lateral control devices, particularly at high angles of attack VII : Handley Page tip and full-span slots with ailerons and spoilers

Tests were made with ordinary ailerons and different sizes of spoilers on rectangular Clark Y wing models with Handley Page tip and full span slots. The tests showed the effect of the control devices on the general performance of the wings as well as on the lateral control and lateral stability characteristics.

Weick, Fred E↗
NASA NTRS1933

The characteristics of a Clark y wing model equipped with several forms of low-drag fixed slots

This investigation was undertaken to develop a low-drag fixed slot for an airplane wing which would avoid the complications and maintenance difficulties of the present movable-type Handley Page slot. Tests were conducted on a series of fixed slots in an attempt to reduce the minimum drag coefficient without decreasing the maximum lift coefficient or the stalling angle of the slotted wing. The tests were made in the NACA 5-foot vertical wind tunnel on a Clark Y basic section having a 10-inch chord.

Weick, Fred E↗
NASA NTRS1933

Wind-tunnel research comparing lateral control devices, particularly at high angles of attack I : ordinary ailerons on rectangular wings

This report is the first in a series in which it is intended to compare the relative merits of all ordinary and some special forms of ailerons and other lateral control devices in regard to their effect on lateral controllability, lateral stability, and airplane performance. The comparisons are based on wind-tunnel test data, all the control devices being fitted to model wings having the same span, area, and airfoil section, and being subjected to the same series of force and rotation tests. The results are given for five different aileron movements: one with equal up-and-down deflection, one with average and one with extreme differential motion, one with upward deflection only, and one with the ailerons arranged to float with respect to the wing.

Weick, Fred E↗
NASA NTRS1933

Wind-tunnel research comparing lateral control devices, particularly at high angles of attack III : ordinary ailerons rigged up 10 degrees when neutral

This report presents the results of wind-tunnel tests made on three model wings having different sizes of ordinary ailerons rigged up 10 degrees when neutral, the same models having previously been tested with the ailerons rigged even with the wings in the usual manner. One of the wings had ailerons of medium size, 25 per cent of the wing chord by 40 per cent of the semispan, one had long, narrow ailerons, and one had short, wide ones. These tests are part of a general investigation on lateral control devices, with particular reference to the control at high angles of attack, in which all the devices are being subjected to the same series of tests in the 7 by 10 foot wind tunnel of the National Advisory Committee for Aeronautics. Force tests of the usual type, free-autorotation tests, and forced-rotation tests were made showing the effect of the ailerons on the general performance of the wing, on the lateral controllability, and on the lateral stability.

Weick, Fred E↗
NASA NTRS1932

Effect of length of Handley Page tip slots on the lateral-stability factor, damping in roll

Tests have been made in the NACA 7 by 10 foot wind tunnel on a Clark Y wing model equipped with various lengths of Handley Page slots extending inward from the wing tips. The slot lengths tested ranged from 20 to 100 per cent of the semi span. The effect of slot lengths on damping in roll was determined by means of both free-autorotation and forced-rotation test. In addition, the maximum lift coefficient was found with each slot length. The optimum length of slot for satisfactory damping in roll over a large range of angles of attack was found to be slightly over 50 per cent of the semispan for the form of slot tested.

Weick, Fred E↗
NASA NTRS1932

Preliminary investigation of rolling moments obtained with spoilers on both slotted and plain wings

A wind-tunnel study has been made to determine the possibility of developing spoilers suitable for providing the lateral control for airplanes in place of the usual ailerons. The first tests were made on a model wing with a fixed tip slot, but when it was found that the effectiveness of the spoilers did not depend to any great extent on the slot, tests were made on a plain wing also. In both cases certain spoiler positions were found which were free from the usual adverse rolling moments with small deflections. Five different forms of spoiler were tested, the best ones being simple plates, either straight or slightly curved to fit the contour of the airfoil when not deflected. Sufficient rolling moment can probably be obtained from spoilers of reasonable size to provide satisfactory lateral control for certain types of airplanes.

Weick, Fred E↗
NASA NTRS1932

Pressure Distribution Over a Thick, Tapered and Twisted Monoplane Wing Model-NACA 81-J

This reports presents the results of pressure distribution tests on a thick, tapered and twisted monoplane wing model. The investigation was conducted for the purpose of obtaining data on the aerodynamic characteristics of the new wing and to provide additional information suitable for use in the design of tapered cantilever wings. The tests included angles of attack up to 90 degrees. The span loading over the wing was approximately of elliptical shape, which gave rise to relatively small bending moments about the root. The angle of zero lift for all sections along the span varied only within plus or minus 0.4 degree of the angle of zero lift for the whole wing, resulting in small leading edge loads for the high-speed condition of flight. The results also add to the available information for the study of large angles of attack.

Wenzinger, Carl J↗
NASA NTRS1932

Rolling Moments Due to Rolling and Yaw for Four Wing Models in Rotation

This report presents the results of a series of autorotation and torque tests on four different rotating wing systems at various rates of roll and at several angles of yaw. The investigation covered an angle of attack range up to 90 degrees and angles of yaw of 0 degree, 5 degrees, 10 degrees, and 20 degrees. The tests were made in a 5-foot, closed-throat atmospheric wind tunnel. The object of the tests was primarily to determine the effects of various angles of yaw on the rolling moments of the rotating wings up to large angles of attack. It was found that at angles of attack above that of maximum lift the rolling moments on the wings due to yaw (or side slip) from 5 degrees to 20 degrees were roughly of the same magnitude as those due to rolling. There was a wide variation in magnitude of the rolling moment due to yaw angle. The rates and ranges of stable autorotation for the monoplane models were considerably increased by yaw, whereas for an unstaggered biplane they were little affected. The immediate cause of the rolling moment due to yaw is apparently the building up of large loads on the forward wing tip and the reduction of loads on the rearward wing tip.

Knight, Montgomery↗
NASA NTRS1932

The Aerodynamic Characteristics of a Slotted Clark Y Wing as Affected by the Auxiliary Airfoil Position

Aerodynamic force tests on a slotted Clark Y wing were conducted in a vertical wind tunnel to determine the best position for a given auxiliary airfoil with respect to the main wing. A systematic series of 100 changes in location of the auxiliary airfoil were made to cover all the probable useful ranges of slot gap, slot width, and slot depth. The results of the investigation may be applied to the design of automatic or controlled slots on wings with geometric characteristics similar to the wing tested. The best positions of the auxiliary airfoil were covered by the range of the tests, and the position for desired aerodynamic characteristics may easily be obtained from charts prepared especially for the purpose.

Wenzinger, Carl J↗
NASA NTRS1931

The Vertical Wind Tunnel of the National Advisory Committee for Aeronautics

The vertical open-throat wind tunnel of the National Advisory Committee for Aeronautics is described in this report. The tunnel was built mainly for studying the spinning characteristics of airplane models, but may be used as well for the usual types of wind-tunnel tests. A special spinning balance is being developed to measure the desired forces and moments with the model simulating the spin of an airplane. Satisfactory air flow has been attained with a velocity that is uniform over the jet to within plus or minus 0.5 per cent. The turbulence present in the tunnel has been compared with that of several other tunnels by means of the results of sphere drag tests and was found to average well with the values of those tunnels. Included also in the report are comparisons of results of stable autorotation and of rolling-moment test obtained both in the vertical tunnel and in the old horizontal 5-foot atmospheric tunnel. (author)

Wenzinger, Carl J↗
NASA NTRS1930

The Effect of Wing Tip Floating Ailerons on the Autorotation of a Monoplane Wing Model

The preliminary tests described here were made to determine the extent to which wing tip floating ailerons might be effective in reducing airplane spinning tendencies. The tests showed that initial spinning tendencies and rates of stable spinning could doubtless be reduced by the use of tip floating ailerons on an airplane. It also appears to be desirable to reduce to a minimum the interference between wing and aileron. This would serve to maintain uniformity of action at all angles of attack and enable calculation of the aileron characteristics.

Knight, Montgomery↗