Engineering topics

Welander, A.

Publications and source records attributed to Welander, A..

8 records

DOE OSTI2025

Designing a validation experiment for radio frequency condensation

Abstract Theoretical studies have suggested that nonlinear effects can lead to ‘radio frequency (RF) condensation’, where an initially broad current profile can coalesce in islands when they reach sufficient width. In suitable conditions, RF condensation can ‘self-focus’ the driven current to the center of an island, improving stabilization efficiency and reducing control complexity. In unsuitable conditions, the effect can prematurely deplete the RF energy before it reaches the island center, impairing stabilization. It is predicted that the RF condensation effect can significantly impact reactor-scale tokamaks. This paper presents a set of simulations investigating the conditions under which RF condensation might be encountered in present-day tokamaks. For concreteness, the calculations use equilibrium reconstructions for two shots from DIII-D and AUG. The Current Condensation Amid Magnetic Islands (OCCAMI) simulation code has been used for this investigation. The code takes as its input a numerically specified axisymmetric EFIT equilibrium solution, and it perturbatively constructs a 3D field with an island embedded at the appropriate rational surface. In the OCCAMI code, the GENRAY code is used for ray tracing and for calculating the power deposition along a ray trajectory, and GENRAY is coupled self-consistently to a solution of the thermal diffusion equation in the island. The simulation results described in the paper illuminate the conditions required for experimental validation of the theory of RF condensation. The simulations also provide an explanation of why the effect was not noticed in experiments prior to the publication of theoretical papers on the subject.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2024

Novel intrinsic helical cores and MHD dynamo flux pumping evidence in DIII-D

Evidence of a MHD dynamo brought about by intrinsic helical core structures in negative triangularity (NT) and ITER baseline scenario (IBS) plasmas demonstrates paths to operating tokamaks without seeds for deleterious global MHD modes. A stationary sawtooth- and edge localized mode-free state maintains high performance for long durations in a strong NT shape in the DIII-D tokamak. Disparity between minimum safety factor values predicted by magnetic flux diffusion theory and derived from experiment suggests anomalous flux diffusion by an MHD dynamo, driven by flows associated with quasi-interchange modes. Stability calculations with the GATO code find NT and IBS experimental equilibria unstable to quasi-interchange modes, in agreement with observed saturated activity. IBS discharges with similar magnetic winding structure occupy robust helical core states following a transition from sawtooth instabilities. These states agree with prior modeling of helical core bifurcation thresholds with the VMEC equilibrium code.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2024

NSTX-U research advancing the physics of spherical tokamaks

Abstract The objectives of NSTX-U research are to reinforce the advantages of STs while addressing the challenges. To extend confinement physics of low- A , high beta plasmas to lower collisionality levels, understanding of the transport mechanisms that set confinement performance and pedestal profiles is being advanced through gyrokinetic simulations, reduced model development, and comparison to NSTX experiment, as well as improved simulation of RF heating. To develop stable non-inductive scenarios needed for steady-state operation, various performance-limiting modes of instability were studied, including MHD, tearing modes, and energetic particle instabilities. Predictive tools were developed, covering disruptions, runaway electrons, equilibrium reconstruction, and control tools. To develop power and particle handling techniques to optimize plasma exhaust in high performance scenarios, innovative lithium-based solutions are being developed to handle the very high heat flux levels that the increased heating power and compact geometry of NSTX-U will produce, and will be seen in future STs. Predictive capabilities accounting for plasma phenomena, like edge harmonic oscillations, ELMs, and blobs, are being tested and improved. In these ways, NSTX-U researchers are advancing the physics understanding of ST plasmas to maximize the benefit that will be gained from further NSTX-U experiments and to increase confidence in projections to future devices.

74 ATOMIC AND MOLECULAR PHYSICS↗

DOE OSTI2024

Real-time plasma equilibrium reconstruction and shape control for the MAST Upgrade tokamak

Real-time magnetic control has been developed to deliver precise control of multiple plasma shape parameters for advanced divertor configurations, including double-null, Super-X, X-point target and X-divertor for the first time on the MAST Upgrade (MAST-U) spherical tokamak. Successful real-time magnetic equilibrium control of different plasma shape variables has been accomplished in the 2022–2023 MAST-U experimental campaign for the advanced MAST-U divertor configurations. Application of the MAST-U boundary reconstruction algorithm, LEMUR, is described and compared with off-line equilibrium reconstruction and diagnostic measurements. The process of design and verification of the axisymmetric magnetic control schemes using a suite of control analysis tools (known collectively as TokSys) is also described.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Vertical control of DIII-D discharges with strong negative triangularity

Through predictive modeling validated by a series of experiments on DIII-D, the vertical stability of low β diverted plasmas with strong negative triangularity (NT) ($\delta\sim-0.6$) is assessed. As a result of their unique magnetic geometry, NT plasmas feature larger Shafranov shifts and more elongated inner flux surfaces than positive triangularity counterparts, typically leading to enhanced vertical instability growth rates. However, coupling with the non-conformal vessel DIII-D wall reduces these growth rates to controllable values, providing a path forward for stabilizing strongly NT plasma with a diverted geometry. These discharges are used to validate GSdesign (part of the TokSys code suite) stability calculations in strong NT plasmas on DIII-D, with errors of no more than ~20% observed between modeled and experimentally measured growth rates. Additions of diagnostic noise and power supply tuning to the TokSys model are needed to accurately capture the time dependence of DIII-D NT discharges, assisting with the design of control schemes specific to the DIII-D poloidal field coils. Lastly, implications of these results on a future NT reactor are briefly described.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2021

Passive deconfinement of runaway electrons using an in-vessel helical coil

A helical coil designed to passively generate non-axisymmetric fields during a plasma disruption is shown (via electromagnetic analysis, linear MHD modeling, and relativistic drift orbit tracing) to be effective at deconfining runaway electrons (REs) on a time scale significantly faster than the plasma current quench. Magnetic equilibria from DIII-D RE-producing scenarios are used to calculate the toroidal electric field generated during the current quench phase of a disruption, which in turn drives current in the proposed n = 1 in-vessel helical coil, without the need for any external power supplies or disruption detection or prediction techniques. Simulations of the plasma evolution using the TokSys GS Evolve code predict the inductive coupling of coil currents up to 12% of the pre-disruption plasma current into the helical coil. The coil geometry is parametrically varied to maximize both the non-resonant and resonant components of the 3D magnetic perturbation, resulting in δB/B ≈ 10 –2 and a vacuumisland overlapwidth of up to 0.7ψ N . The REORBIT module of the MARS-F code is used to model the full non-axisymmetric magnetic field and trace RE drift orbits to determine the effect on RE deconfinement, with up to 70% of the RE orbits lost after 0.2 ms. A two-stage evolution of the RE orbit loss fraction is observed to be caused by resonant trapping between multiple magnetic island chains. Finally, electromagnetic and thermal stresses on the coil are calculated to be within operational limits for installation in DIII-D, and scale favorably to a reactor-size device. Furthermore, these findings motivate future experimental study of the helical coil concept in DIII-D or other tokamaks.

3D coil↗

DOE OSTI2021

Real-time estimation and control of divertor surface heat flux on the DⅢ-D tokamak

We report Future tokamaks will require robust technologies for the mitigation of heat exhaust onto the plasma-facing components. As a first step towards this development, a system has been developed at DIII-D that estimates and controls in real-time the heat flux to the PFCs. Real-time estimation of the peak power flux from this model-based approach is validated with off-line infra-red measurements for various DIII-D plasma discharges. A nonlinear free-boundary simulation code (GSevolve) is used for simulating the closed loop response and for the off-line determination of the control parameters. The implementation and first experimental results of the application during the DIII-D plasma campaign are reported.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Plasma flux expansion control on the DIII-D tokamak

A new controller has been developed with help of the flexible divertor poloidal-field coil set of the DIII-D tokamak, to aid in the precise control of the flux expansion in the scrape-off layer (SOL). Here, the single-input multiple-output (SIMO) architecture ensures flexibility through a complementary set of orthogonal actuator direction to guarantee minimum effect on existing controlled variables, e.g. radial and vertical position control of the X-point. A non-linear free-boundary simulation code (GSevolve) is used for simulating the closed-loop response and for verifying the implementation of the control algorithm on the DIII-D plasma control system (PCS). First results of the experimental commissioning of the new controller during 2020 DIII-D campaign are also presented.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗