Engineering Papers⌕ Search

Engineering topics

Weick, Fred E

Publications and source records attributed to Weick, Fred E.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1931

The Effect of Reduction Gearing on Propeller-body Interference as Shown by Full-Scale Wind-Tunnel Tests

This report presents the results of full-scale tests made on a 10-foot 5-inch propeller on a geared J-5 engine and also on a similar 8-foot 11-inch propeller on a direct-drive J-5 engine. Each propeller was tested at two different pitch settings, and with a large and a small fuselage. The investigation was made in such a manner that the propeller-body interference factors were isolated, and it was found that, considering this interference only, the geared propellers had an appreciable advantage in propulsive efficiency, partially due to the larger diameter of the propellers with respect to the bodies, and partially because the geared propellers were located farther ahead of the engines and bodies.

Weick, Fred E↗
NASA NTRS1931

Full-Scale Wind-Tunnel Tests with a Series of Propellers of Different Diameters on a Single Fuselage

Aerodynamic tests were made with four geometrically similar metal propellers of different diameters, on a Wright "Whirlwind" J-5 engine in an open cockpit fuselage. The results show little difference in the characteristics of the various propellers, the only one of any importance being an increase of efficiency of the order of 1 per cent for a 5 per cent increase of diameter, within the range of the tests.

Weick, Fred E↗
NASA NTRS1931

Working Charts for the Selection of Aluminum Alloy Propellers of a Standard Form to Operate with Various Aircraft Engines and Bodies

Working charts are given for the convenient selection of aluminum alloy propellers of a standard form, to operate in connection with six different engine-fuselage combinations. The charts have been prepared from full-scale test data obtained in the 20-foot propeller research tunnel of the National Advisory Committee for Aeronautics. An example is also given showing the use of the charts.

Weick, Fred E↗
NASA NTRS1931

Full-Scale Wind-Tunnel Tests on Several Metal Propellers Having Different Blade Forms

This report gives the full-scale aerodynamic characteristics of five different aluminum alloy propellers having four different blade forms. They were tested on an open cockpit fuselage with a radial air-cooled engine having conventional cowling. The results show that (1) the differences in propulsive efficiency due to the differences in blade form were small; (2) the form with the thinnest airfoil sections had the highest efficiency; (3) it is advantageous as regards propulsive efficiency for a propeller operating in front of a body, such as a radial engine, to have its pitch reduced toward the hub.

Weick, Fred E↗
NASA NTRS1930

Drag and Cooling with Various Forms of Cowling for a "Whirlwind" Radial Air-Cooled Engine I

This report presents the results of an investigation undertaken in the 20-foot Propeller Research Tunnel at Langley Field on the cowling of radial air-cooled engines. A portion of the investigation has been completed, in which several forms and degrees of cowling were tested on Wright "Whirlwind" J-5 engine mounted in the nose of a cabin fuselage. The cowlings varied from the one extreme of an entirely exposed engine to the other in which the engine was entirely inclosed. Cooling tests were made and each cowling modified, if necessary, until the engine cooled approximately as satisfactorily as when it was entirely exposed. Drag tests were then made with each form of cowling, and the effect of the cowling on the propulsive efficiency determined with a metal propeller. The propulsive efficiency was found to be practically the same with all forms of cowling. The drag of the cabin fuselage with uncowled engine was found to be more than three times as great as the drag of the fuselage with engine removed and nose rounded. The conventional forms of cowling, in which at least the tops of the cylinder heads and valve gear are exposed, reduce the drag somewhat, but the cowling entirely covering the engine reduces it 2.6 times as much as the best conventional one. The decrease in drag due to the use of spinners proved to be almost negligible. The use of the cowling completely covering the engine seems entirely practical as regards both cooling and maintenance under service conditions. It must be carefully designed, however, to cool properly. With cabin fuselages its use should result in a substantial increase in high speed over that obtained with present forms of cowling on engines similar in contour to the J-5. (author)

Weick, Fred E↗
NASA NTRS1930

Drag and Cooling with Various Forms of Cowling for a "Whirlwind" Radial Air-cooled Engine II

This report gives the results of the second portion of an investigation in the twenty-foot Propeller Research Tunnel of the National Advisory Committee for Aeronautics, on the cowling and cooling of a "Whirlwind" J-5 radial air-cooled engine. The first portion pertains to tests with a cabin fuselage. This report covers tests with several forms of cowling, including conventional types, individual fairings behind the cylinders, individual hoods over the over the cylinders, and the new N. A. C. A. complete cowling, all on an open cockpit fuselage. Drag tests were also made with a conventional engine nacelle, and with a nacelle having the new complete cowling. In the second part of the investigation the results found in the first part were substantiated. It was also found that the reduction in drag with the complete cowling over that with conventional cowling is greater with the smaller bodies than with the cabin fuselage; in fact, the gain in the case of the completely cowled nacelle is over twice that with the cabin fuselage. The individual fairings and hoods did not prove effective in reducing the drag. The results of flight tests on AT-5A airplane has been analyzed and found to agree very well with the results of the wind tunnel tests. (author)

Weick, Fred E↗
NASA NTRS1929

Full Scale Investigation of the Drag of a Wing Radiator

Tests were made on the 1927 Williams racer in order to determine the effect of the wing radiator on the airfoil characteristics. It was found that the radiator doubled the minimum drag of the portion of the wing it covered, and also reduced the lift somewhat.

Weick, Fred E↗
NASA NTRS1929

The Twenty-Foot Propeller Research Tunnel of the National Advisory Committee for Aeronautics

This report describes in detail the new propeller research tunnel of the National Advisory Committee for Aeronautics at Langley Field, Va. This tunnel has an open jet air stream 20 feet in diameter in which velocities up to 110 M. P. H. Are obtained. Although the tunnel was built primarily to make possible accurate full-scale tests on aircraft propellers, it may also be used for making aerodynamic tests on full-size fuselages, landing gears, tail surfaces, and other aircraft parts, and on model wings of large size. (author)

Weick, Fred E↗
NASA NTRS1929

Full Scale Tests of Wood Propellers on a VE-7 Airplane in the Propeller Research Tunnel

The investigation described in this report was made primarily to afford a comparison between propeller tests in the new propeller research tunnel and flight tests and small model tests on propellers. Three wood propellers which had been previously tested in flight on a VE-7 airplane, and of which models had also been tested in a wind tunnel, were tested again on a VE-7 airplane in the propeller research tunnel. The results of these tests are in fair agreement with those of the flight and model tests. Tests were also made with the tail surfaces removed, and with both the wing and tail surfaces removed. It was found that the effect of the tail surfaces on the propeller characteristics was negligible, but that the wings reduced the maximum propulsive efficiency about 5 percent. (author)

Weick, Fred E↗
NASA NTRS1929

Full Scale Tests on a Thin Metal Propeller at Various Tip Speeds

This report describes an investigation made in order to determine the effect of tip speed on the characteristics of a thin-bladed metal propeller. The propeller was mounted on a VE-7 airplane with a 180-HP E-2 engine, and tested in the 20-foot propeller research tunnel of the National Advisory Committee for Aeronautics. It was found that the effect of tip speed on the propulsive efficiency was negligible within the range of the tests, which was from 600 to 1,000 feet per second (about 0.5 to 0.9 the velocity of sound in air). (author)

Weick, Fred E↗
NASA NTRS1929

Full-Scale Wind-Tunnel Tests of a Series of Metal Propellers on a VE-7 Airplane

An adjustable blade metal propeller was tested at five different angle settings, forming a series varying in pitch. The propeller was mounted on a VE-7 airplane in the twenty-foot propeller research tunnel of the National Advisory Committee for Aeronautics. The efficiencies were found to be from 4 to 7 per cent higher than those of standard wood propellers operating under the same conditions. The results are given in convenient form for use in selecting propellers for aircraft.

Weick, Fred E↗
NASA NTRS1928

The Drag of a J-5 Radial Air-Cooled Engine

This note describes tests of the drag due to a Wright "Whirlwind" (J-5) radial air-cooled engine mounted on a cabin type airplane. The tests were made in the 20-foot Propeller Research Tunnel of the National Advisory Committee for Aeronautics. The drag was obtained with three different types of exhaust stacks: Short individual stacks, a circular cross section collector ring, and a streamline cross section collector ring.

Weick, Fred E↗
NASA NTRS1928

A Comparison of Propeller and Centrifugal Fans for Circulating the Air in a Wind Tunnel

The tests described in this paper afford a direct comparison of the efficiency and smoothness of flow obtained with propeller fan and multiblade centrifugal fan drives in the same wind tunnel. The propeller fan was found to be superior to the centrifugal fan in that the efficiency was about twice as great, and the flow much smoother.

Weick, Fred E↗
NASA NTRS1928

Full Scale Drag Tests on Various Parts of Sperry Messenger Airplane

The drag of a Sperry Messenger airplane with the wings removed, and also the drag of its various component parts, was measured in the 20-foot air stream of the N.A.C.A. propeller research tunnel at air speeds from 50 to 100 m.p.h. It was found that the three-cylinder radial air-cooled engine nearly doubled the drag of the bare fuselage, and the drag of the landing gear was about the same as that of the fuselage and engine combined.

AIRPLANES - WIND TUNNEL TESTS DRAG TESTS - SPERRY ↗
NASA NTRS1928

The Effect of the Sperry Messenger Fuselage on the Air Flow at the Propeller Plane

In order to study the effect of the fuselage, landing gear, and engine on the air flow through the propeller, a survey was made in the plane of the Sperry Messenger propeller with the propeller removed. The tests were made in the 20-foot air stream of the propeller research tunnel of the National Advisory Committee for Aeronautics at Langley Field, Virginia. The variation of the velocity with distance from the center in the propeller plane was found to be appreciable and well worth consideration in the design of propellers. It was also found that the velocity through the propeller plane was affected by the presence of the engine, and that the velocity in front of the landing gear was lower than that at other points in the propeller plane having the same radius.

Weick, Fred E↗