Engineering PapersSearch

Engineering topics

Webb, Frank

Publications and source records attributed to Webb, Frank.

26 records · Page 2

Mission Implementation Constraints on Planetary Muon Radiography

Cost: Use heritage hardware, especially use a tested landing system to reduce cost (Phoenix or MSL EDL stage). The sky crane technology delivers higher mass to the surface and enables reaching targets at higher elevation, but at a higher mission cost. Rover vs. Stationary Lander: Rover-mounted instrument enables tomography, but the increased weight of the rover reduces the allowable payload weight. Mass is the critical design constraint for an instrument for a planetary mission. Many factors that are minor factors or do not enter into design considerations for terrestrial operation are important for a planetary application. (Landing site, diurnal temperature variation, instrument portability, shock/vibration)

entry, descent, and landing (EDL)

Monitoring Volcanoes by Use of Air-Dropped Sensor Packages

Sensor packages that would be dropped from airplanes have been proposed for pre-eruption monitoring of physical conditions on the flanks of awakening volcanoes. The purpose of such monitoring is to gather data that could contribute to understanding and prediction of the evolution of volcanic systems. Each sensor package, denoted a volcano monitoring system (VMS), would include a housing with a parachute attached at its upper end and a crushable foam impact absorber at its lower end (see figure). The housing would contain survivable low-power instrumentation that would include a Global Positioning System (GPS) receiver, an inclinometer, a seismometer, a barometer, a thermometer, and CO2 and SO2 analyzers. The housing would also contain battery power, control, data-logging, and telecommunication subsystems. The proposal for the development of the VMS calls for the use of commercially available sensor, power, and telecommunication equipment, so that efforts could be focused on integrating all of the equipment into a system that could survive impact and operate thereafter for 30 days, transmitting data on the pre-eruptive state of a target volcano to a monitoring center. In a typical scenario, VMSs would be dropped at strategically chosen locations on the flanks of a volcano once the volcano had been identified as posing a hazard from any of a variety of observations that could include eyewitness reports, scientific observations from positions on the ground, synthetic-aperture-radar scans from aircraft, and/or remote sensing from aboard spacecraft. Once dropped, the VMSs would be operated as a network of in situ sensors that would transmit data to a local monitoring center. This network would provide observations as part of an integrated volcano-hazard assessment strategy that would involve both remote sensing and timely observations from the in situ sensors. A similar strategy that involves the use of portable sensors (but not dropping of sensors from aircraft) is already in use in the Volcano Disaster Assistance Program (VDAP), which was developed by the U.S. Geological Survey and the U.S. Office of Foreign Disaster Assistance to respond to volcanic crises around the world. The VMSs would add a greatly needed capability that would enable VDAP response teams to deploy their volcano-monitoring equipment in a more timely manner with less risk to personnel in the field.

Kedar, Sharon

Rate Change Observed at JPLM after the Northridge Earthquake

Geodetic time series detemined with the Global Positioning System indicate that the geodetic rate of a permanent site in Pasadena, Califonia (JPLM) changed significantly after the 17 January 1994 Northridge California earthquake.

Northridge

Repeat Pass Aircraft Interferometry Results at Portage Lake, Maine and Innisfail, Australia

The NASA/JPL AIRSAR/TOPSAR instruments have the capability of collecting fully polarimetric radar data at three wavelengths (C, L, and P-bands) and dual antenna interferometry at C-band, and more recently, L-band. In order to understand frequency and baseline dependent scattering effects in vegetated regions, repeat pass interferometry data was collected for two vegetated regions in 1993. Portage Lake, Maine is a primarily coniferous forested region with some clear cutting from logging activities in the region. The second site at Innisfail, Australia borders a tropical rain forest and is situated adjacent to some major clear cut regions and banana plantations. Preliminary analysis of repeat pass data collected in these areas shows that the smaller the wavelength the greater the temporal decorrelation between passes, the longer the wavelength the greater the penetration depth for some types of vegetation canopy, yet for some vegetation canopy types, in particular for a banana plantation, there appears to be no frequency dependent penetration into the canopy.

Hensley, Scott

Repeat Pass Aircraft Interferometry Results at Portage Lake, Maine and Innisfail, Australia

The NASA/JPL AIRSAR/TOPSAR instruments have the capability of collecting fully polarimetric radar data at three wavelengths (C, L and P-Bands) and dual antenna interferometry at C-Band, and more recently L-Band. In order to understand frequency and baseline dependent scattering effects in vegetated regions repeat pass interferometry data was collected for two vegetated regions in 1993. Portage Lake, Maine is a primarily coniferous forested region with some clear cutting from logging activities in the region. The second site at Innisfail, Australia borders a tropical rain forest and is situated adjacent to some major clear cut regions and banana plantations. Preliminary analysis of repeat pass data collected in these areas shows that the smaller the wavelength the greater the temporal decorrelation between passes, the longer the wavelength the greater the penetration depth for some types of vegetation canopy, yet for some vegetation canopy types, in particular for a banana plantation there appears to be no frequency dependent penetration into the canopy.

Hensley, Scott

Repeat Pass Aircraft Interferometry Results at Portage Lake, Maine, and Innisfail, Australia

The NASA/JPL AIRSAR/TOPSAR instruments have the capability fo collecting fully polarimetric radar data at three wavelengths (C, L and P-Bands) and dual antenna interferometry at C-Band, and more recently, L-Band. In order to understand frequency and baseline dependent scattering effects in vegetated regions, repeat pass interferometry data was collected for two vegetated regions in 1993....Preliminary analysis if the data show that the smaller the wavelength, the greater the temporal decorrelation between passes, and the longer the wavelength, the greater the penetration depth for some types of vegetation canopies...

AIRSAR/TOPSAR

Global geodesy using GPS without fiducial sites

Baseline lengths and geocentric radii have been determined from GPS data without the use of fiducial sites. Data from the first GPS experiment for the IERS and Geodynamics (GIG '91) have been analyzed with a no-fiducial strategy. A baseline length daily repeatability of 2 mm + 4 parts per billion was obtained for baselines in the Northern Hemisphere. Comparison of baseline lengths from GPS and the global VLBI solution GLB659 (Caprette et al. 1990) show rms agreement of 2.1 parts per billion. The geocentric radius mean daily repeatability for all sites was 15 cm. Comparison of geocentric radii from GPS and SV5 (Murray et al. 1990) show rms agreement of 3.8 cm. Given n globally distributed stations, the n(n - 1)/2 baseline lengths and n geocentric radii uniquely define a rigid closed polyhedron with a well-defined center of mass. Geodetic information can be obtained by examining the structure of the polyhedron and its change with time.

Heflin, Michael