Engineering topics

Weaver, W. R.

Publications and source records attributed to Weaver, W. R..

26 records · Page 2

NASA NTRS1974

The minimum free-stream wind speed for initiating motion of surface material on Mars

Estimates of the minimum free-stream wind speed that is required for initiating the motion of surficial material on Mars have ranged from 30 to about 200 meters per second. Thus the best value for this quantity is not well established. Graphical comparison of much of the pertinent data taken in the laboratory and in the field on Earth provides a minimum value for the Bagnold coefficient of 0.08 and this in turn provides a minimum value for the threshold friction velocity of 1.3 meters per second for initiating motion of particulate matter on Mars at low elevations where the pressure is 7 millibars. The most appropriate value of the ratio of friction velocity to free-stream velocity for putative unstable condition appears to be 0.026. Thus the minimum free-stream wind speed for initiating motion is obtained as 50 meters per second. If the surface material on Mars, however, is less cohesive than that on earth, the minimum value may be smaller.

Wood, G. P.↗

NASA NTRS1974

Values of the photometric parameters of Mars and their interpretation

Photometric data for the Martian disk obtained by Thorpe from television-camera pictures taken by Mariner 9 were used to derive values for the parameters in the photometric function. The photometric function can be applied to Mars and to the design of cameras for photography of Mars. Values of the parameters are for one wavelength only, 0.56 micros and are average or effective values for the Martian disk. The values derived were interpreted to provide semi-quantitative information on the soil. The results do not disagree with other indications that the effective mean diameter of the surface particles is about 400 micros. Another result is that the mean intercenter spacing of adjacent particles may be about 4/3 of the mean diameter.

Weaver, W. R.↗

NASA NTRS1971

Development and initial operating characteristics of the 20 megawatt linear plasma accelerator facility

A 20-megawatt linear plasma accelerator facility, a steady flow, Faraday-type plasma accelerator facility for high velocity aerodynamic testing, was constructed, developed, and brought to an operational status. The accelerator has a 63.5-mm-square and 0.5-meter-long channel and utilizes nitrogen-seeded with 2 % mole fraction of cesium vapor. Modification of the original accelerator design characteristics and the improvements necessary to make the arc heater a suitable plasma source are described. The measured accelerator electrode current distribution and the electrode-wall potential distributions are given. The computed and the measured values are in good agreement. Measured pitot pressure indicates that an accelerator exit velocity of 9.2 km/sec, is obtained with 30 of the 36 electrode pairs powered and corresponds to a velocity increase to about 2 1/4 times the computed entrance velocity. The computed stagnation enthalpy at the accelerator exit is 92 MJ/kg, and the mass density corresponds to an altitude of about 58 km. The 92 MJ/kg stagnation enthalpy corresponds to a kinetic energy content at low temperature equivalent to a velocity of 13.6 km/sec.

Carter, A. F.↗

NASA NTRS1970