Engineering topics

Warner, Edward P

Publications and source records attributed to Warner, Edward P.

At least 19 records

NASA NTRS1927

Approximations for column effect in airplane wing spars

The significance attaching to "column effect" in airplane wing spars has been increasingly realized with the passage of time, but exact computations of the corrections to bending moment curves resulting from the existence of end loads are frequently omitted because of the additional labor involved in an analysis by rigorously correct methods. The present report represents an attempt to provide for approximate column effect corrections that can be graphically or otherwise expressed so as to be applied with a minimum of labor. Curves are plotted giving approximate values of the correction factors for single and two bay trusses of varying proportions and with various relationships between axial and lateral loads. It is further shown from an analysis of those curves that rough but useful approximations can be obtained from Perry's formula for corrected bending moment, with the assumed distance between points of inflection arbitrarily modified in accordance with rules given in the report. The discussion of general rules of variation of bending stress with axial load is accompanied by a study of the best distribution of the points of support along a spar for various conditions of loading.

Warner, Edward P↗

NASA NTRS1926

Wing spar stress charts and wing truss proportions

In order to simplify the calculation of beams continuous over three supports, a series of charts have been calculated giving the bending moments at all the critical points and the reactions at all supports for such members. Using these charts as a basis, calculations of equivalent bending moments, representing the total stresses acting in two bay-wing trusses of proportions varying over a wide range, have been determined, both with and without allowance for column effect. This leads finally to the determination of the best proportions for any particular truss or the best strut locations in any particular airplane. The ideal proportions are found to vary with the thickness of the wing section used, the aspect ratio, and the ratio of gap to chord.

Warner, Edward P↗

NASA NTRS1925

Wind tunnel tests of fuselages and windshields

The tests described herein were made in 1918, in the old four-foot wind tunnel at the Massachusetts Institute of Technology and at the request of the Engineering Division of the U.S. Army Air Service. The results were given circulation only in official circles at that time. The interest of the work appears sufficient to justify its wider distribution even at this very late date.

Warner, Edward P↗

NASA NTRS1925

The estimation of airplane performance from wind tunnel tests on conventional airplane models

Calculations of the magnitude of the correction factors and the range of their variations for wind tunnel models used in making aircraft performance predictions were made for 23 wind tunnel models. Calculated performances were compared with those actually determined for such airplanes as have been built and put through flight test. Except as otherwise noted, all the models have interplane struts and diagonal struts formed to streamwise shape. Wires were omitted in all cases. All the models were about 18 inches in span and were tested in a 4-foot wind tunnel. Results are given in tabular form.

Warner, Edward P↗

NASA NTRS1925

The calculation of wing float displacement in single-float seaplanes

Explore the source record for details and available documents.

Warner, Edward P↗

NASA NTRS1924

Comparing the performance of geometrically similar airplanes

This note has been prepared for the National Advisory Committee for Aeronautics. It deals with the model rules relating to aeronautical problems, and shows how the characteristics of one airplane can be determined from those of another airplane of different weight or size, and of similar type. If certain rules for the ratios of the dimensions, the weights and the horsepower are followed, a small low-powered airplane can be used for obtaining information as to performance, stability, controllability and maneuverability of a larger prototype, and contrariwise.

Munk, Max M↗

NASA NTRS1924

Specializing for record-breaking

This report seeks to determine what constitutes airplane performance and what line should be followed in seeking to break records if the designer is given a free hand.

Warner, Edward P↗

NASA NTRS1923

Factors of safety

Factors of safety serve three purposes: provides against trouble arising from unexpectedly large loads, allows for imperfections of workmanship, represents a depreciation allowance.

FACTORS OF SAFETY↗

NASA NTRS1923

Wind tunnel tests of five strut sections in yaw

In the first series of wind tunnel tests, the drag and cross wing force of all the struts were measured at a wind speed of 30 mph and at angles of yaw from 0 degrees to 20 degrees. To determine the magnitude of the VL effect, each strut was tested at zero yaw and at a series of speeds ranging from 15 to 38 mph. Although designed as fairings for cables, part of these sections gave such high crosswind forces that they seemed to have possibilities as airfoils. Therefore, the lift (identical with the crosswind force) and drag coefficients were recalculated for four sections on the basis of broadside area to make them comparable with wing coefficients. The general conclusion that the best fineness ratio for a strut is a function of the Reynolds number, decreasing steadily as that quality increases, has of course been reached many times, both by theory and experiment. It was confirmed here once more, and the effect of form on sensitiveness to VL is also strikingly shown. It seems probable that this effect of form is largely due to interaction between the nose and tail, and to the influence which the form of the nose exerts over the whole flow around the strut.

PROPELLERS, METAL↗

NASA NTRS1923

Monoplanes or biplanes?

This article presents a discussion of the relative merits between monoplanes and biplanes.

MONOPLANES VS BIPLANES↗

NASA NTRS1923

Shortening the landing run

Methods for shortening the landing run are discussed as well as the need for more emergency landing fields that will, by necessity, have to be short fields.

AIRPLANES - PERFORMANCE↗

NASA NTRS1923

The effect of bow stiffeners in nonrigid airships

It is now well known that all nonrigid airships constructed at the present time have bow stiffeners consisting of battens curved to the form of the envelope and designed to hold the nose of the ship in its true form despite the very large pressure which exists at the extreme forward point. The effect of the stiffeners is to reduce considerably the apparent pressure which has to be maintained inside the envelope in order to prevent the nose from caving in.

AIRSHIP NOSES - STIFFENING↗

NASA NTRS1923