Engineering Papers⌕ Search

Engineering topics

Warner, D. N., Jr.

Publications and source records attributed to Warner, D. N., Jr..

13 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

Fuel conservative guidance for shipboard landing of powered-lift STOL aircraft

A computer-simulation study was undertaken to investigate the application of Fuel Conservative Guidance (FCG) techniques, developed at NASA Ames Research Center, to improve the fuel efficiency and minimize recovery time of powered-lift short-takeoff-and-landing (STOL) airplanes operating from aircraft carriers at sea. The FCG system consists of a set of algorithms whose coefficients and parameters limits match those of the Quiet Short-Haul Research Aircraft. When a flightpath is specified by a set of initial conditions for the aircraft and a set of positional waypoints with associated airspeeds, the FCG synthesizes the necessary guidance commands to capture the specified path at any specified waypoint and to optimize fuel consumption and time fo fly along the path. Closed-form expressions are developed for calculating the altitude profile synthesized by the algorithm. Results of this simulation study show that when restrictions on the approach flightpath imposed for manual operation are removed completely, fuel consumption during the approach was reduced by as much as 38 percent (434 lb of fuel) and the time required to fly the flightpath was reduced by as much as 28 percent (209 sec). Savings because of FCG were produced by: (1) shortening the total flight time and distance, and (2) keeping the airspeed high as long as possible to minimize time spent flying in a powered-lift mode.

Warner, D. N., Jr.↗
NASA NTRS1984

Fuel conservative guidance concept for shipboard landing of powered-life aircraft

A simulation study was undertaken to investigate the application of energy conservative guidance (ECG) software, developed at NASA Ames Research Center, to improve the time and fuel efficiency of powered lift airplanes operating from aircraft carriers at sea. When a flightpath is indicated by a set of initial conditions for the aircraft and a set of positional waypoints with associated airspeeds, the ECG software synthesizes the necessary guidance commands to optimize fuel and time along the specified path. A major feature of the ECG system is the ability to synthesize a trajectory that will allow the aircraft to capture the specified path at any waypoint with the desired heading and airspeed from an arbitrary set of initial conditions. Five paths were identified and studied. These paths demonstrate the ECG system's ability to save flight time and fuel by more efficiently managing the aircraft's capabilities. Results of this simulation study show that when restrictions on the approach flightpath imposed for manual operation are removed completely, fuel consumption during the approach was reduced by as much as 49% (610 lb fuel) and the time required to fly the flightpath was reduced by as much as 41% (5 min). Savings due to ECG were produced by: (1) shortening the total flight time; (2) keeping the airspeed high as long as possible to minimize time spent flying in a regime in which more engine thrust is required for lift to aid the aerodynamic lift; (3) minimizing time spent flying at constant altitude at slow airspeeds; and (4) synthesizing a path from any location for a direct approach to landing without entering a holding pattern or other fixed approach path.

Warner, D. N., Jr.↗
NASA NTRS1983

Flight-test of the glide-slope track and flare-control laws for an automatic landing system for a powered-lift STOL airplane

An automatic landing system was developed for the Augmentor Wing Jet STOL Research Airplane to establish the feasibility and examine the operating characteristics of a powered-lift STOL transport flying a steep, microwave landing system (MLS) glide slope to automatically land on a STOL port. The flight test results address the longitudinal aspects of automatic powered lift STOL airplane operation including glide slope tracking on the backside of the power curve, flare, and touchdown. Three different autoland control laws were evaluated to demonstrate the tradeoff between control complexity and the resulting performance. The flight test and simulation methodology used in developing conventional jet transport systems was applied to the powered-lift STOL airplane. The results obtained suggest that an automatic landing system for a powered-lift STOL airplane operating into an MLS-equipped STOL port is feasible. However, the airplane must be provided with a means of rapidly regulation lift to satisfactorily provide the glide slope tracking and control of touchdown sink rate needed for automatic landings.

Watson, D. M.↗
NASA NTRS1981

MLS vertical guidance and navigation for a STOL airplane landing on an elevated STOLport

In contrast to CTOL landing operations, STOL airplanes landing on short STOLport runways typically begin the flare maneuver before reaching the runway surface. Vertical guidance procedures were developed to allow an autoland flight control system for a STOL airplane to use Microwave Landing System (MLS) signals as altitude and sink rate references for flare initiation, with a transition to radar altimeter after the airplane is over the runway. The implementation has minimum impact on the control system and landing performance. Data are presented which show validation of the concepts in a simulator.

Warner, D. N., Jr.↗
NASA NTRS1981

A method for determining landing runway length for a STOL aircraft

Based on data obtained from flight tests of the augmentor wing jet STOL research aircraft, a method is proposed for determining the length of the landing runway for powered-lift STOL aircraft. The suggested method determines runway landing length by summing three segments: the touchdown-dispersion distance, the transition distance from touchdown to application of brakes, and the stopping distance after brakes are applied. It is shown how the landing field length can be reduced either through improved autoland system design or by providing the pilot with appropriate information to allow him to identify a "low probability" long or short landing and to execute a go-around. The proposed method appears to determine a safe runway landing length for the STOL application and offers the potential for reducing runway length if great emphasis is placed on a short-runway capability. FAR Parts 25 and 121 appear conservative and suitable for the situation where no great emphasis is placed on reducing the runway length requirement.

Watson, D. M.↗
NASA NTRS1977

A flight investigation of a 4D area navigation system concept for STOL aircraft in the terminal area

A digital avionics system referred to as STOLAND was test flown in the NASA CV-340 aircraft to obtain performance data for time controlled guidance in the manual flight director mode. The advanced system components installed in the cockpit included an electronic attitude director indicator and an electronic multifunction display. Navigation guidance and control computations were performed on a digital computer. A detailed 4D area navigation systems description is given. The pilot/system interface and systems operation and performance are also described. Approach flightpaths were flown which included a 180 deg turn and a 1-min, 5 deg straight-in approach to 30 m altitude, at which point go-around was initiated. Results are presented for 19 approaches.

Neuman, F.↗
NASA NTRS1976

Flight evaluation of advanced flight control systems and cockpit displays for powered-lift STOL Aircraft

A flight research program was conducted to assess the improvements, in longitudinal path control during a STOL approach and landing, that can be achieved with manual and automatic control system concepts and cockpit displays with various degrees of complexity. NASA-Ames powered-lift Augmentor Wing Research Aircraft was used in the research program. Satisfactory flying qualities were demonstrated for selected stabilization and command augmentation systems and flight director combinations. The ability of the pilot to perform precise landings at low touchdown sink rates with a gentle flare maneuver was also achieved. The path-control improvement is considered to be applicable to other powered-lift aircraft configurations.

Franklin, J. A.↗
NASA NTRS1974

A STOL terminal area navigation system

The mechanization and performance of a STOL terminal area navigation system are described. The purpose of the navigation system is to allow flying with precision 4D-guidance along complex flight paths in the terminal area, and to develop requirements for STOL operations in the 1980s. The navigation aids include an experimental microwave landing system, MODILS. The systems description begins with the navigation aids. It is shown how the data are transformed and combined with other data to obtain position and velocity estimates. Also presented are some of the design changes and other features that were introduced as a result of flight testing. The various ways of displaying navigation-derived data are given. Finally, simulator and flight test results are discussed.

Neuman, F.↗