Engineering topics
Publications and source records attributed to Wannamaker, Phil.
The Utah Frontier Observatory for Research in Geothermal Energy (FORGE) attempted a stimulation at well 16A(78)-32 during April and May 2022. We recorded telluric and magnetotelluric (MT) data before, during, and after the well stimulation experiment using the FORGE Telluric Monitoring (FTM) array to constrain transients in the Earth's electrical structure caused by the stimulation.
This data was acquired as part of the Subsurface Science, Technology and Engineering Research, and Development (SubTER) Crosscut which is a collaboration across the Department of Energy offices involved in research activities in energy production/extraction, subsurface storage, and environmental remediation. The contents of this zip contains the ZTEM survey measured and processed results for the Mineral Mountains area, Utah. The data were acquired through subcontract to Geotech Inc of Aurora, ON, Canada and their narrative report is included. There are also two readme.txt file included that further describe the data.
New high-quality tensor MT data at 122 sites, including the vertical magnetic field and utilizing ultra-remote referencing, have been acquired over the Utah FORGE project area. The results will be used to delineate the densities of faults and fractures in crystalline basement rocks, to define the heat sources, and to derive baseline 3D resistivity structure for later MT monitoring of temporal changes in resistivity structure following well stimulation in the EGS reservoir. There are three files here related to Utah FORGE magnetotelluric (MT) data acquisition and processing. The FORGE MT EDIs zip file contains the observed MT responses in industry-standard EDI format. For each site, there is an EDI response file that utilized a local independent reference for noise cancellation, and a file that utilized a distant reference cancelling noise associated with the DC transmission line of the Delta IPP passing down the west side of Milford Valley. These two site files could be merged as appropriate. The FORGE Model Cell Center file contains the model volume of the 3D Forge MT inversion for characterizing the resistivity structure in the project area. It was derived using finite element inversion methodology described in Wannamaker et al, in the attached FORGE Phase3 Geophysics paper, from the MT observation EDI files. It is ASCII format (.dat) and entries are defined at top of the file in a simple x-y-z-Rho listing in UTM coordinates. The element layers drape the topography so the Rho value layers are not purely horizontal slices. This greatly simplifies the listing.