Engineering Papers⌕ Search

Engineering topics

Wang, S.

Publications and source records attributed to Wang, S..

At least 163 records · Page 9

Phase 1 Free Air CO2 Enrichment Model-Data Synthesis (FACE-MDS): Model Output Data (2015)

These datasets comprise the model output from phase 1 of the FACE-MDS. These include simulations of the Duke and Oak Ridge experiments and also idealised long-term (300 year) simulations at both sites (please see the modelling protocol for details). Included as part of this dataset are modelling and output protocols. The model datasets are formatted according to the output protocols. Phase 1 datasets are reproduced here for posterity and reproducibility although the model output for the experimental period have been somewhat superseded by the Phase 2 datasets.

54 ENVIRONMENTAL SCIENCES↗

Strain and localization effects in InGaAs(N) quantum wells: Tuning the magnetic response

We investigated effects of localization and strain on the optical and magneto-optical properties of diluted nitrogen III–V quantum wells theoretically and experimentally. High-resolution x-ray diffraction, photoluminescence (PL), and magneto-PL measurements under high magnetic fields up to 15 T were performed at low temperatures. Bir-Pikus Hamiltonian formalism was used to study the influence of strain, confinement, and localization effects. The circularly polarized magneto-PL was interpreted considering localization aspects in the valence band ground state. An anomalous behavior of the electron-hole pair magnetic shift was observed at low magnetic fields, ascribed to the increase in the exciton reduced mass due to the negative effective mass of the valence band ground state.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Contactless electroreflectance and theoretical studies of band gap and spin-orbit splitting in InP{sub 1−x}Bi{sub x} dilute bismide with x ≤ 0.034

Contactless electroreflectance is applied to study the band gap (E{sub 0}) and spin-orbit splitting (Δ{sub SO}) in InP{sub 1−x}Bi{sub x} alloys with 0 < x ≤ 0.034. The E{sub 0} transition shifts to longer wavelengths very significantly (−83 meV/% Bi), while the E{sub 0} + Δ{sub SO} transition shifts very weakly (−13 meV/% Bi) with the rise of Bi concentration. These changes in energies of optical transitions are discussed in the context of the valence band anticrossing model and ab initio calculations. Shifts of E{sub 0} and E{sub 0} + Δ{sub SO} transitions, obtained within ab-initio calculations, are −106 and −20 meV per % Bi, respectively, which is in a good agreement with experimental results.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Point defect balance in epitaxial GaSb

Positron annihilation spectroscopy in both conventional and coincidence Doppler broadening mode is used for studying the effect of growth conditions on the point defect balance in GaSb:Bi epitaxial layers grown by molecular beam epitaxy. Positron annihilation characteristics in GaSb are also calculated using density functional theory and compared to experimental results. We conclude that while the main positron trapping defect in bulk samples is the Ga antisite, the Ga vacancy is the most prominent trap in the samples grown by molecular beam epitaxy. The results suggest that the p–type conductivity is caused by different defects in GaSb grown with different methods.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Seeking to quantify the ferromagnetic-to-antiferromagnetic interface coupling resulting in exchange bias with various thin-film conformations

Ni{sub 3}Fe/(Ni, Fe)O thin films with bilayer and nanocrystallite dispersion morphologies are prepared with a dual ion beam deposition technique permitting precise control of nanocrystallite growth, composition, and admixtures. A bilayer morphology provides a Ni{sub 3}Fe-to-NiO interface, while the dispersion films have different mixtures of Ni{sub 3}Fe, NiO, and FeO nanocrystallites. Using detailed analyses of high resolution transmission electron microscopy images with Multislice simulations, the nanocrystallites' structures and phases are determined, and the intermixing between the Ni{sub 3}Fe, NiO, and FeO interfaces is quantified. From field-cooled hysteresis loops, the exchange bias loop shift from spin interactions at the interfaces are determined. With similar interfacial molar ratios of FM-to-AF, we find the exchange bias field essentially unchanged. However, when the interfacial ratio of FM to AF was FM rich, the exchange bias field increases. Since the FM/AF interface ‘contact’ areas in the nanocrystallite dispersion films are larger than that of the bilayer film, and the nanocrystallite dispersions exhibit larger FM-to-AF interfacial contributions to the magnetism, we attribute the changes in the exchange bias to be from increases in the interfacial segments that suffer defects (such as vacancies and bond distortions), that also affects the coercive fields.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Ultrafast X-ray Auger probing of photoexcited molecular dynamics

Here, molecules can efficiently and selectively convert light energy into other degrees of freedom. Disentangling the underlying ultrafast motion of electrons and nuclei of the photoexcited molecule presents a challenge to current spectroscopic approaches. Here we explore the photoexcited dynamics of molecules by an interaction with an ultrafast X-ray pulse creating a highly localized core hole that decays via Auger emission. We discover that the Auger spectrum as a function of photoexcitation—X-ray-probe delay contains valuable information about the nuclear and electronic degrees of freedom from an element-specific point of view. For the nucleobase thymine, the oxygen Auger spectrum shifts towards high kinetic energies, resulting from a particular C–O bond stretch in the ππ* photoexcited state. A subsequent shift of the Auger spectrum towards lower kinetic energies displays the electronic relaxation of the initial photoexcited state within 200 fs. Ab-initio simulations reinforce our interpretation and indicate an electronic decay to the nπ* state.

74 ATOMIC AND MOLECULAR PHYSICS↗

Statistical study of free magnetic energy and flare productivity of solar active regions

Photospheric vector magnetograms from the Helioseismic and Magnetic Imager on board the Solar Dynamic Observatory are utilized as the boundary conditions to extrapolate both nonlinear force-free and potential magnetic fields in solar corona. Based on the extrapolations, we are able to determine the free magnetic energy (FME) stored in active regions (ARs). Over 3000 vector magnetograms in 61 ARs were analyzed. We compare FME with the ARs' flare index (FI) and find that there is a weak correlation (<60%) between FME and FI. FME shows slightly improved flare predictability relative to the total unsigned magnetic flux of ARs in the following two aspects: (1) the flare productivity predicted by FME is higher than that predicted by magnetic flux and (2) the correlation between FI and FME is higher than that between FI and magnetic flux. However, this improvement is not significant enough to make a substantial difference in time-accumulated FI, rather than individual flare, predictions.

79 ASTRONOMY AND ASTROPHYSICS↗

Exchange bias magnetism in films of NiFe/(Ni,Fe)O nanocrystallite dispersions

Ni{sub 3}Fe/(Ni,Fe)O thin films having a nanocrystallite dispersion morphology were prepared by a reactive ion beam-assisted deposition technique. The crystallite sizes of these dispersion-based films were observed to decrease from 8.4 ± 0.3 nm to 3.4 ± 0.3 nm as the deposition flow-rate increased from 2.78% to 7.89% O{sub 2}/Ar. Thin film composition was determined using selective area electron diffraction images and Multislice simulations. Through a detailed analysis of high resolution transmission electron microscopy images, the nanocrystallites were determined to be Ni{sub 3}Fe (a ferromagnet), NiO, and FeO (both antiferromagnets). It was determined that the interfacial molar Ni{sub 3}Fe ratio in the nanocrystallite dispersions increased slightly at first, then decreased as the oxygen content was increased; at 7.89% O{sub 2}/Ar, the interfacial molar ratio was essentially zero (only NiO and FeO remained). For nanocrystallite dispersion films grown with O{sub 2}/Ar flow-rate greater than 7.89%, no interfacial (intermixed) Ni{sub 3}Fe phase was detected, which resulted in no measurable exchange bias. Comparing the exchange bias field between the nanocrystallite dispersion films at 5 K, we observed a decrease in the magnitude of the exchange bias field as the nanocrystallite size decreased. The exchange bias coupling for all samples measured set in at essentially the same temperature (i.e., the exchange bias blocking temperature). Since the ferromagnetic/anti-ferromagnetic (FM/AFM) contact area in the nanocrystallite dispersion films increased as the nanocrystallite size decreased, the increase in the magnitude of the exchange bias could be attributed to larger regions of defects (vacancies and bond distortions) which occupied a significant portion of the FM/AFM interfaces in the nanocrystallite dispersion films.

36 MATERIALS SCIENCE↗

Orientation dependence of the dislocation microstructure in compressed body-centered cubic molybdenum

The orientation dependence of the deformation microstructure has been investigated in commercial pure molybdenum. After deformation, the dislocation boundaries of compressed molybdenum can be classified, similar to that in face-centered cubic metals, into three types: dislocation cells (Type 2), and extended planar boundaries parallel to (Type 1) or not parallel to (Type 3) a (110) trace. However, it shows a reciprocal relationship between face-centered cubic metals and body-centered cubic metals on the orientation dependence of the deformation microstructure. The higher the strain, the finer the microstructure is and the smaller the inclination angle between extended planar boundaries and the compression axis is. - Highlights: • A reciprocal relationship between FCC metals and BCC metals is confirmed. • The dislocation boundaries can be classified into three types in compressed Mo. • The dislocation characteristic of different dislocation boundaries is different.

36 MATERIALS SCIENCE↗

Defect studies in MBE grown GaSb{sub 1−x}Bi{sub x} layers

Positron annihilation spectroscopy in Doppler broadening mode is used to study epitaxial layers of GaSb{sub 1−x}Bi{sub x} on undoped GaSb. The samples were grown by Molecular Beam Epitaxy at different temperatures and with different Bi/Sb beam equivalent pressure ratios resulting in Bi concentrations of 0–0.7 %. The results show a relationship between the growth parameters and Doppler broadening parameters. Incorporating Bi into GaSb decreases the vacancy concentration in the epitaxial layers compared to the sample with no Bi in the epitaxial layer.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

When and how does a prominence-like jet gain kinetic energy?

A jet is a considerable amount of plasma being ejected from the chromosphere or lower corona into the higher corona and is a common phenomenon. Usually, a jet is triggered by a brightening or a flare, which provides the first driving force to push plasma upward. In this process, magnetic reconnection is thought to be the mechanism to convert magnetic energy into thermal, nonthermal, and kinetic energies. However, most jets could reach an unusual high altitude and end much later than the end of its associated flare. This fact implies that there is another way to continuously transfer magnetic energy into kinetic energy even after the reconnection. The picture described above is well known in the community, but how and how much magnetic energy is released through a way other than reconnection is still unclear. By studying a prominence-like jet observed by SDO/AIA and STEREO-A/EUVI, we find that the continuous relaxation of the post-reconnection magnetic field structure is an important process for a jet to climb up higher than it could through only reconnection. The kinetic energy of the jet gained through the relaxation is 1.6 times that gained from the reconnection. The resultant energy flux is hundreds of times larger than the flux required for the local coronal heating, suggesting that such jets are a possible source to keep the corona hot. Furthermore, rotational motions appear all the time during the jet. Our analysis suggests that torsional Alfvén waves induced during reconnection could not be the only mechanism to release magnetic energy and drive jets.

79 ASTRONOMY AND ASTROPHYSICS↗

New flow boiling heat transfer model for hydrocarbons evaporating inside horizontal tubes

Hydrocarbons have high thermodynamic performances, belong to the group of natural refrigerants, and they are the main components in mixture Joule-Thomson low temperature refrigerators (MJTR). New evaluations of nucleate boiling contribution and nucleate boiling suppression factor in flow boiling heat transfer have been proposed for hydrocarbons. A forced convection heat transfer enhancement factor correlation incorporating liquid velocity has also been proposed. In addition, the comparisons of the new model and other classic models were made to evaluate its accuracy in heat transfer prediction.

42 ENGINEERING↗