Engineering Papers⌕ Search

Engineering topics

Wang, Peng

Publications and source records attributed to Wang, Peng.

At least 55 records · Page 3

Corrosion behavior of ferritic FeCrAl alloys in simulated BWR normal water chemistry

Ferritic iron-chromium-aluminum (FeCrAl) alloys with varying Cr content were subjected to in-situ irradiation-corrosion with energetic protons or electron beams in pure water with various oxygen concentrations. Oxide microstructure and composition were characterized to compare the corrosion under irradiation with the thermal corrosion in the same water conditions. The dominant effect seems to be the production of H 2 O 2 at the surface by the intense proton and electron beams. The corrosion potential of FeCrAl under BWR-NWC condition is somewhat above the Cr 2 O 3 /CrO 4 2- phase boundary, oxidizing the Cr(III) to Cr(VI) in the outer part of the film, but with some Cr(III) remaining in the interior of the oxide. The beam increases the corrosion potential, significantly reducing Cr(III) content throughout the oxide. Finally, the crystallites on the surface, which form by re-precipitation from solution, do not contain Cr because at low potential Cr(III) is not soluble, and at high potential Cr(VI) is quite soluble.

36 MATERIALS SCIENCE↗

Characterization of Connected Lighting System Potential for Grid Services Under Real-Time Pricing

Increasingly over the last decade, the management of end-use electricity demand has been examined as a potential source of services for the electric power grid beyond contracts with large commercial and industrial customers. Lighting represents about 17\% of U.S. commercial building annual electricity consumption; however, its potential rapid speed of response may position it to uniquely contribute to services that improve the reliability and resilience of the grid. Connected lighting systems (CLS), which build upon solid-state lamp technology, can change state by adjusting power demand more quickly than most other building electricity end uses and could be used as a platform to monitor lighting electricity use and space conditions. But the potential of CLS to provide grid services has not been extensively studied. In this paper, we describe initial research to evaluate the potential of CLS for grid services. We develop a model for CLS using a set of parameters to represent operation behaviors and constraints: maximal power, minimal power, nominal power, ramp rate, and time delay. Parameter values are generated for representative building types. CLS demand curves are constructed, indirectly capturing building occupant preferences for lighting as functions of electricity price. The CLS model and the demand curves are incorporated into a Transactive Control and Coordination (TCC) Platform to simulate CLS providing grid services. Previous research has shown TCC to be a powerful tool to enable end uses to provide grid services through a hybrid economic-control approach. Initial quantitative results will be provided for CLS grid services potential.

Wang, Peng↗

First-principles study of the topological surface states of α-Sn(111)

α-Sn is on the boundary of a couple of distinct topological phases. It will transform into a topological insulator under a suitable strain. However, a clear picture of its topological surface states (TSSs) is still lacking. Furthermore we perform first-principles calculations on the electronic structure of α-Sn(111) surface to identify its TSSs and reveal their properties. The results show that the presence of valence band reorganizes the TSSs in the inverted sp gap into two Dirac cones. The lower one is in the valence band continuum; the upper one resides in the gap between the valence and conduction bands. We also demonstrate the transformation of the surface states by switching on or off of strain and/or spin-orbit coupling. Without spin-orbit coupling, only the TSSs associated with the lower Dirac cone survive, and they are spin unpolarized. The results are useful for understanding and engineering the topological properties of α-Sn.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Multi-hydrophilic functional network enables porous membranes excellent anti-fouling performance for highly efficient water remediation

Membrane technology is believed as a cost-effective approach for solving the water issues, where as it suffers from serious membrane fouling. Surface grafting and surface coating have been proved to be effective in abating the membrane fouling; however, these processes always need additional procedures and compromise the initial permeance of the membranes. Herein, we developed a kind of highly permeable polyacrylonitrile (PAN) membranes with excellent anti-fouling performance through one-step phase inversion of the PAN casting solution containing water-soluble active additives. During the process, the water-soluble active additives could segregate towards the membrane surface and pore walls; thereby finely tailoring the pore structures of the PAN-based membranes. Moreover, the active additives could react with each other to form crosslinked networks containing multi-hydrophilic functional groups including CH2-O-CH2, -OH or-Si-OH. Consequently, the PAN-based membranes exhibited surprising superhydrophilicity with water contact angle below 10. even after soaking in water for one week and the anti-fouling permeance of the membranes increased significantly with permeance recovery rate above 93%. Interestingly, the modified membranes also demonstrated both high permeances and high separation efficiency, thereby showing strong promise in water environmental remediation including wastewater treatment and oil/water emulsion separation.

Anti-fouling↗

Scheduling and Control of Flexible Building Loads for Grid Services Based on a Virtual Battery Model

This paper presents a framework for modeling, scheduling, and controlling residential thermostatically controlled loads (TCLs) to provide multiple grid services, such as energy shifting, peak load reduction, and ancillary services. A modeling method is proposed to characterize the aggregate flexibility from heterogeneous TCLs using a battery-equivalent model. Based on the flexibility model, a multi-period optimal scheduling formulation is developed to best utilize the flexibility from building loads and maximize total benefits from stacked value streams. An algorithm is proposed to control individual TCLs to follow the desired power consumption in real-time. The proposed methods are illustrated and validated through simulations.

Wu, Di↗

Flexibility Estimation and Control of Thermostatically Controlled Loads with Lock Time for Regulation Service

A virtual battery model is a simple and general method to quantify aggregate flexibility from thermostatically controlled loads (TCLs), enabling grid operators to effectively coordinate a large number of flexible building loads with supplyside resources in power systems. Lockout controls are designed to avoid wear and tear resulting from short-cycling of hardware. The lock on/off time could significantly affect aggregate flexibility from TCLs to provide ancillary services and may even fail control algorithms designed without considering the lock time constraints. This paper focuses on flexibility estimation and control design for TCLs with lock time constraints to provide frequency regulation service. We first investigate the potential impacts of lock time on TCLs’ aggregate flexibility and control performance. Both control-dependent and control-independent power bounds are derived, based on either previous TCL switching operations or regulation signals. While the control-dependent method provides aggregate flexibility for a given control method, the control-independent method calculates the theoretical maximum of power bounds. Two control algorithms are proposed to better distribute flexibility over time and thereby improve signal tracking performance. The proposed methods are illustrated and validated through simulations.

Wang, Peng↗

Probing the electrical double layer by operando X‐ray photoelectron spectroscopy through a graphene‐carbon nanotube composite window

Abstract The electrical double layer is known to spontaneously form at the electrode‐electrolyte interface, impacting many important chemical and physical processes as well as applications including electrocatalysis, electroorganic synthesis, nanomaterial preparation, energy storage, and even emulsion stabilization. However, it has been challenging to study this fundamental phenomenon at the molecular level because the electrical double layer is deeply “buried” by the bulk electrolyte solution. Here, we report a quantitative probing of the electrical double layer of ionic liquids from the solid side of a photoelectron‐transparent graphene‐carbon nanotube hybrid membrane electrode using X‐ray photoelectron spectroscopy. The membrane window is ultrathin (1‐1.5 nm), large (~1 cm 2 ), and robust, enabling a tight seal of the electrolyte and quantitative measurement with excellent photoelectron signals. By operando monitoring the population changes of cations and anions in response to the applied electrical potentials, we experimentally resolve the chemical structure and dynamics of the electrical double layer, which corroborate results from molecular dynamics simulations. image

Wang, Peng↗

Frequency-domain Flexibility Characterization of Heterogeneous End-use Loads for Grid Services

Demand response, based on flexible loads, has been a novel and important proposal for smart grids. A population of small loads can be aggregated to provide ancillary services to the grid and generate value for the owners. In this paper, we investigate the flexibility of such populations from the frequency-domain perspective. We propose a methodology to characterize the frequency-dependent flexibility of heterogeneous populations of loads considering practical constraints. The resultant frequency-domain characterization can help flexible load aggregators assess the capability of contracted populations. System operators can also benefit from a better understanding of the capabilities of the service providers. The effectiveness of the methodology is demonstrated by simulations.

Wang, Dexin↗

Persistent Heavy Winter Nitrate Pollution Driven by Increased Photochemical Oxidants in Northern China

Nitrate is an increasingly important component of fine particulate matter (PM2.5) during winter in northern China. Past emission control has been ineffective in reducing winter nitrate. Here, we use extensive observations and a model with state-of-theart nitrogen chemistry to identify the key factors that control the nitrate formation in the heavily polluted North China Plain (NCP). In contrast to the previous view of weak winter photochemistry, we show that the O3 and OH productions are sufficiently high in winter to facilitate fast gas-phase and heterogeneous conversion of NOX to nitrate over the NCP. Increasing O3 and OH productions from higher precursor levels and fast ROX cycling accelerate the nitrate generation during heavy pollution. We find that the 31.8% reduction of NOX emissions from 2010 to 2017 in the NCP lowers surface nitrate by only 0.2% and even increases nitrate in some polluted areas. This is mainly due to the increase of O3 and OH (by~30%), which has subsequently increased the conversion efficiency of NOX to HNO3 (by 38.7%). Future control strategies for the winter haze should also aim to lower photochemical oxidants, via larger and synchronized NOX and VOCs emissions reduction, to overcome the effects of nonlinear photochemistry and aerosol chemical feedback.

Fu, Xiao↗

Synthesis of Synergistic Nitrogen-Doped NiMoO 4 /Ni 3 N Heterostructure for Implementation of an Efficient Alkaline Electrocatalytic Hydrogen Evolution Reaction

Electrochemical water splitting is considered as an effective and promising method to produce the ideal hydrogen energy to solve the energy crisis and environmental pollution problems. In this paper, we successfully synthesized the N-doped NiMoO 4 /Ni 3 N heterostructure, which exhibited an efficient HER performance with a lower overpotential of 51 mV at 10 mA cm -2 and a lower Tafel slope value of 45.47 mV dec -1 compared with those of NiMoO 4 , N-doped NiMoO 4 , or Ni 3 N owing to the synergistic effect of N doping and construction of the superior heterostructure. When the N-doped NiMoO 4 /Ni 3 N heterostructure is used as a cathode and the well-recognized excellent OER material (NiFe-LDH) is used as an anode to construct the two-electrode electrolyzer, the system requires only 1.506 and 1.559 V to achieve the current densities of 10 and 20 mA cm -2 , respectively, which are lower than those of the commercial Pt/C//RuO 2 system (1.573 and 1.634 V, respectively) or many other reported systems. At the same time, this two-electrode system demonstrates excellent durability in electrocatalytic water splitting. This design method paved the way for the development of another electrocatalytic system.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗