Engineering Papers⌕ Search

Engineering topics

Wang, J

Publications and source records attributed to Wang, J.

At least 217 records · Page 12

Dark Current Simulation for Linear Collider Accelerator Structures

The dynamics of field-emitted electrons in the traveling wave fields of a constant gradient (tapered) disk-loaded waveguide is followed numerically. Previous simulations have been limited to constant impedance (uniform) structures for sake of simplicity since only the fields in a unit cell is needed. Using a finite element field solver on a parallel computer, the fields in the tapered structure can now be readily generated. We will obtain the characteristics of the dark current emitted from both structure types and compare the two results with and without the effect of secondary electrons. The NLC and JLC detuned structures are considered to study if dark current may pose a problem for high gradient acceleration in the next generation of Linear Colliders.

43 PARTICLE ACCELERATORS↗

Impact of plug-in hybrid electric vehicles on power systems with demand response and wind power.

This paper uses a new unit commitment model which can simulate the interactions among plug-in hybrid electric vehicles (PHEVs), wind power, and demand response (DR). Four PHEV charging scenarios are simulated for the Illinois power system: (1) unconstrained charging, (2) 3-hour delayed constrained charging, (3) smart charging, and (4) smart charging with DR. The PHEV charging is assumed to be optimally controlled by the system operator in the latter two scenarios, along with load shifting and shaving enabled by DR programs. The simulation results show that optimally dispatching the PHEV charging load can significantly reduce the total operating cost of the system. With DR programs in place, the operating cost can be further reduced.

17 WIND ENERGY↗

Aerosol concentration and size distribution measured below, in, and above cloud from the DOE G-1 during VOCALS-REx

During the VOCALS Regional Experiment, the DOE G-1 aircraft was used to sample a varying aerosol environment pertinent to properties of stratocumulus clouds over a longitude band extending 800 km west from the Chilean coast at Arica. Trace gas and aerosol measurements are presented as a function of longitude, altitude, and dew point in this study. Spatial distributions are consistent with an upper atmospheric source for O{sub 3} and South American coastal sources for marine boundary layer (MBL) CO and aerosol, most of which is acidic sulfate in agreement with the dominant pollution source being SO{sub 2} from Cu smelters and power plants. Pollutant layers in the free troposphere (FT) can be a result of emissions to the north in Peru or long range transport from the west. At a given altitude in the FT (up to 3 km), dew point varies by 40 C with dry air descending from the upper atmospheric and moist air having a BL contribution. Ascent of BL air to a cold high altitude results in the condensation and precipitation removal of all but a few percent of BL water along with aerosol that served as CCN. Thus, aerosol volume decreases with dew point in the FT. Aerosol size spectra have a bimodal structure in the MBL and an intermediate diameter unimodal distribution in the FT. Comparing cloud droplet number concentration (CDNC) and pre-cloud aerosol (Dp > 100 nm) gives a linear relation up to a number concentration of {approx}150 cm{sup -3}, followed by a less than proportional increase in CDNC at higher aerosol number concentration. A number balance between below cloud aerosol and cloud droplets indicates that {approx}25% of aerosol in the PCASP size range are interstitial (not activated). One hundred and two constant altitude cloud transects were identified and used to determine properties of interstitial aerosol. One transect is examined in detail as a case study. Approximately 25 to 50% of aerosol with D{sub p} > 110 nm were not activated, the difference between the two approaches possibly representing shattered cloud droplets or unknown artifact. CDNC and interstitial aerosol were anti-correlated in all cloud transects, consistent with the occurrence of dry in-cloud areas due to entrainment or circulation mixing.

54 ENVIRONMENTAL SCIENCES↗

High-sensitivity strain mapping around epitaxial oxide nanostructures using scanning x-ray nanodiffraction.

The generation and presence of strain around nanostructures of oxides is a key to their growth, properties, and functions, but it has been a challenge to experimentally measure its sign, magnitude, and spatial distribution. Combining diffuse scattering with scanning x-ray nanodiffraction, we have mapped the strain distribution in an oxide-on-oxide nanopatterned structure with a high sensitivity (10{sup -4}) and a submicrometer spatial resolution. An edge-induced strain distribution is observed from a sample of CoFe{sub 2}O{sub 4} nanolines epitaxially grown on MgO substrate, which agrees quantitatively with the numerical simulations.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

Enhancement of injection and acceleration of electrons in a laser wakefield accelerator by using an argon-doped hydrogen gas jet and optically preformed plasma waveguide

A systematic experimental study on injection of electrons in a gas-jet-based laser wakefield accelerator via ionization of dopant was conducted. The pump-pulse threshold energy for producing a quasi-monoenergetic electron beam was significantly reduced by doping the hydrogen gas jet with argon atoms, resulting in a much better spatial contrast of the electron beam. Furthermore, laser wakefield electron acceleration in an optically preformed plasma waveguide based on the axicon-ignitor-heater scheme was achieved. It was found that doping with argon atoms can also lower the pump-pulse threshold energy in this experimental configuration.

43 PARTICLE ACCELERATORS↗

Experimental Studies of Ion Beam Neutralization: Preliminary Results

A testing platform is designed to study ion beam neutralization in the mesothermal, collisionless region. In the experimental setup, argon neutrals were ionized in a microwave cavity and accelerated by a plasma lens system which was biased to 2500 V above the system ground. Electrons were boiled off from two hot tungsten filaments to neutralize the ion beam. The plasma is diagnosed using Langmuir probe and Faraday probe. A 3-D traversing system and a complete data acquisition loop were developed to efficiently measure 3-D beam profile. Preliminary measurements of beam profiles are presented for different operating conditions.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Kinetic Simulations of Ion Beam Neutralization

Full particle PIC simulations are performed to study the neutralization of an ion beam in the cohesionless, mesothermal regime. Simulations further confirmed that neutralization is achieved through interactions between the trapped electrons and the potential well established by the propagation of the beam front along the beam direction and is not through plasma instabilities as previous studies suggested. In the transverse direction, the process is similar to that of the expansion of mesothermal plasma into vacuum. Parametric simulations are also performed to investigate the effects of beam radius and domain boundary condition on the neutralization process. The results suggests that, while the qualitative behavior may be similar in ground tests, quantitative parameters such as the beam potential will be affected significantly by the vacuum chamber because of the limits imposed on the expansion process by the finite chamber space.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

High-performance metamorphic InGaAs resonant cavity enhanced photodetector grown on GaAs substrate

In this letter, we demonstrated a top illuminated 1.55 {mu}m metamorphic InGaAs resonant-cavity-enhanced p-i-n photodetector grown on GaAs substrate. The photodetectors were grown by a solid-source molecular beam epitaxy system. The high quality linearly graded In{sub x}Al{sub 0.4}Ga{sub 1-x-0.4}As metamorphic buffer layer enabled photodiodes to achieve ultralow dark current densities of 2.3x10{sup -6} A/cm{sup 2} at 0 V and 4.2x10{sup -5} A/cm{sup 2} at a reverse bias of 5 V. A high quantum efficiency of 84.4% at resonant wavelength of 1542 nm, a full width at half maximum about 14 nm, and a -3 dB bandwidth up to 13 GHz were also obtained.

36 MATERIALS SCIENCE↗

FY 2010 Second Quarter Report Evaluation of the Liu-Daum-McGraw (LDM) Drizzle Threshold Parameterization using Measurements from the VAMOS Ocean-Cloud-Atmosphere Land Study (VOCALS) Field Campaign

Metric for Quarter 2: Evaluate LDM (Liu, Daum, McGraw) drizzle threshold parameterization for a range of cloud conditions by comparing the threshold function computed using measurements of cloud droplet number concentration and cloud liquid water content to measurements of drizzle droplet number concentrations and/or drizzle water content.

54 ENVIRONMENTAL SCIENCES↗

Characterization of an SRF gun: a 3D full wave simulation

We characterized a BNL 1.3GHz half-cell SRF gun is tested for GaAs photocathode. The gun already was simulated several years ago via two-dimensional (2D) numerical codes (i.e., Superfish and Parmela) with and without the beam. In this paper, we discuss our investigation of its characteristics using a three dimensional (3D) full-wave code (CST STUDIO SUITE{trademark}).The input/pickup couplers are sited symmetrically on the same side of the gun at an angle of 180{sup o}. In particular, the inner conductor of the pickup coupler is considerably shorter than that of the input coupler. We evaluated the cross-talk between the beam (trajectory) and the signal on the input coupler compared our findings with published results based on analytical models. The CST STUDIO SUITE{trademark} also was used to predict the field within the cavity; particularly, a combination of transient/eigenmode solvers was employed to accurately construct the RF field for the particles, which also includes the effects of the couplers. Finally, we explored the beam's dynamics with a particle in cell (PIC) simulation, validated the results and compare them with 2D code result.

43 PARTICLE ACCELERATORS↗

SOURCE OF MICROBUNCHING AT BNL NSLS SOURCE DEVELOPMENT LABORATORY

We report experimental studies of the origins of electron beam microbunching instability at BNL Source Development Laboratory (SDL). We eliminated laser-induced microbunching by utilizing an ultra-short photocathode laser. The measurements of the resulting electron beam led us to conclude that, at SDL, microbunching arising from shot noise is not amplified to any significant level. Our results demonstrated that the only source of microbunching instability at SDL is the longitudinal modulation of the photocathode laser pulse. Our work shows that assuring a longitudinally smoothed photocathode laser pulse allows mitigating microbunching instability at a typical FEL injector with a moderate microbunching gain. In this paper we investigated the source of microbunching instability at the SDL. To distinguish microbunching induced by shot noise from that arising from the longitudinal modulation of the photocathode laser, we studied the beam created by a very short laser pulse, thus eliminating the possibility of laser-induced microbunching. While the measured energy spectra of compressed beam did reveal severe longitudinal fragmentation, an analysis of the beam dynamics proved this to be due to self-fields acting on a beam with an initially smooth longitudinal profile, and not due to microbunching instability. Such fragmentation only was possible with the very short bunch chosen for these studies, and is absent in routine SDL operations. Our experiment shows that in the absence of the initial laser-induced beam modulation, microbunching instability at the SDL is not observed, and must be well below the levels that would limit the FEL performance. This result agrees with assumption of previous SDL studies that (when present under different machine conditions) microbunching instability at the SDL was laser-induced. Microbunching instability gain at the SDL is moderate. This is mainly because the SDL utilizes a single stage bunch compressor as well as due to the small compression ratio. Since the design of the SDL injector is typical of the majority of FEL injectors, our experiment proves that one possible way to control microbunching instability in such machines (that by design have a moderate microbunching gain) is to maintain a sufficiently smooth longitudinal profile of the photo-cathode laser. We note that the general principles for designing a machine with a moderate microbunching instability gain are presented in [12]. In conclusion, our experiment demonstrates that microbunching instability can be eliminated from a typical FEL injector with single stage bunch compressor (and operating without a laser heater) as long as the photocathode laser is longitudinally smooth. For machines with multi-stage bunch compressors, our results offer an important benchmark to establish a minimal laser heater power for instability-free operation.

43 PARTICLE ACCELERATORS↗

Relativistic birefringence induced by a high-intensity laser field in a plasma

Field-induced birefringence, also known as cross-polarization wave generation, has played an important role in ultrafast nonlinear optics. In this paper we analyze birefringence induced by relativistic collective motion of electrons driven by a high-intensity laser field. An analytical expression for the phase difference between the parallel and perpendicular polarizations of a weak probe pulse with respect to the polarization of a strong pump pulse as a function of intensity, density, and wavelengths is derived. It is shown that under typical experimental conditions of high-field physics, the effect is well above detection threshold. The analysis is compared with particle-in-cell simulations, and the agreement provides good support for the theory.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Mutual Ferromagnetic-Ferroelectric Coupling in Multiferroic Copper-Doped ZnO

A mutual ferromagnetic and ferroelectric coupling (multiferroic behavior) in Cu-doped ZnO is demonstrated via deterministic control of Cu doping and defect engineering. The coexistence of multivalence Cu ions and oxygen vacancies is important to multiferroic behaviors in ZnO:Cu. The samples show clear ferroelectric and ferromagnetic domain patterns. These domain structures may be written reversibly via electric and magnetic bias.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Mapping Diffuse Seismicity Using Empirical Matched Field Processing Techniques

The objective of this project is to detect and locate more microearthquakes using the empirical matched field processing (MFP) method than can be detected using only conventional earthquake detection techniques. We propose that empirical MFP can complement existing catalogs and techniques. We test our method on continuous seismic data collected at the Salton Sea Geothermal Field during November 2009 and January 2010. In the Southern California Earthquake Data Center (SCEDC) earthquake catalog, 619 events were identified in our study area during this time frame and our MFP technique identified 1094 events. Therefore, we believe that the empirical MFP method combined with conventional methods significantly improves the network detection ability in an efficient matter.

15 GEOTHERMAL ENERGY↗