Engineering Papers⌕ Search

Engineering topics

Wang, Fei

Publications and source records attributed to Wang, Fei.

At least 127 records · Page 7

Modeling of Multi-Loops Related Device Turn-On Overvoltage in 3L-ANPC Converters

An analytical model for the device drain-source turn-on overvoltage in three-level active neutral point clamped (3L-ANPC) converters is established in this paper. Considering the two commutation loops in the converter, the relationship between the turn-on overvoltage and the loop inductances is evaluated. The line switching frequency device usually exhibits higher overvoltage, while the high switching frequency device is not strongly influenced by the multiple loops. A 500 kVA 3L-ANPC converter using SiC MOSFETs is tested, and the model is verified with the experimental results.

Gui, Handong↗

Novel amorphous SiOC dispersion-strengthened austenitic steels.

Here, a novel amorphous silicon oxycarbide dispersion-strengthened (SiOC-DS) austenitic steel has been fabricated via a powder metallurgy process. The microstructure of dispersion particles has been characterized by transmission electron microscopy (TEM) and electron backscatter diffraction (EBSD), revealing that amorphous SiOC nanoparticles with an average particle size of 30 nm were homogeneously distributed in the austenite grains with a sub-micrometer grain size. The high strength and hardness of SiOC-DS may be attributed to grain boundary strengthening, as well as dispersion strengthening via dislocation–particle interactions that were revealed by TEM investigations. In situ ion irradiation experiments showed that amorphous SiOC particles were stable after irradiation of 3.7 dpa, and the SiOC/steel interface can be an effective sink for the annihilation of irradiation defects. The excellent mechanical and irradiation properties of SiOC-DS austenitic steel make it a promising structural material for nuclear applications.

36 MATERIALS SCIENCE↗

Tuning Anionic Chemistry To Improve Kinetics of Mg Intercalation

Rechargeable Mg batteries (RMBs) hold great promise for high energy density in consumer electronics because of the high theoretical volumetric capacity and dendrite-free stripping/plating of Mg. Their development, however, is severely limited by the sluggish diffusion of Mg 2+ in inorganic cathodes, mainly induced by strong interaction between Mg 2+ and host anions. In this paper, for the first time, we systematically investigate how anionic chemistry (O, S, and Se) affects Mg 2+ migration in layered MX 2 (M = Ti and V; X = O, S, and Se), by combining theoretical density functional theory (DFT) calculations with electrochemical characterizations. At room temperature, TiSe 2 and VSe 2 achieve much better electrochemical performance than TiS 2 and VS 2 , due to the faster migration of Mg 2+ in selenide than in sulfide and oxide, as demonstrated by electrochemical kinetic characterizations and DFT calculations. The improved kinetics of selenide can be attributed to three criteria: (i) larger diffusion channel, (ii) weaker interaction between Mg 2+ and anion lattice, and (iii) higher electronic conductivity. Finally, the three criteria might not only be applicable to layered materials but also be generalizable to materials with other structures, like Chevrel phase, spinel, olivine, etc., which paves the way for the future design and modification of intercalation materials for RMBs.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Design of a Single Controller for Multiple Paralleled Inverters

Paralleling power electronics inverters is an effective way to increase dc-ac system power level. Accurately synchronized switching action and independent closed-loop regulator are necessary to prevent circulating current in paralleled inverters. There are many challenges for the controller design, when the number of paralleled inverters is large, and control period gets short for high switching frequency applications. This paper presents a single controller design based on DSP + FPGA that is suitable for paralleling multiple inverters. A simple synchronization scheme between DSP and FPGA based on universal parallel port (UPP) is proposed to eliminate the synchronization delay among inverters, and independent control of each converter can also be implemented. The controller is built for a system consisting of 4 paralleled three-level, three-phase high frequency ANPC inverters using space vector modulation, and it can be easily adopted to other topologies and modulations. Experimental results have demonstrated the effectiveness of this controller.

Niu, Jiahao↗

Coupled Inductor Design for Interleaved Three-level Active Neutral Point Clamped Inverters Considering EMI Noise Reduction

This paper presents the coupled inductor design for interleaved three-level active neutral point clamped (ANPC) inverter considering electromagnetic interference (EMI) noise reduction. Compared to two-level case, the scenarios involved in the three-level space vector modulation (SVM) are more complicated when analyzing the volt-seconds of the coupled inductor for paralleled three-level inverter. At system level, the purpose of converter interleaving is to reduce EMI noise and ripple current in most applications, and coupled inductor design should consider the needs of EMI noise reduction and EMI filter design. These issues are discussed in this paper. The relationship between circulating current and EMI noise is illustrated. EMI filter corner frequency as a function of interleaving angle is analytically derived, and optimal interleaving angle for maximum common-mode (CM) filter and differential-mode (DM) filter corner frequencies is discussed. Coupled inductor design methodology for interleaved three-level inverters with SVM is then presented. Experiments on two interleaved ANPC inverters are conducted. The results verify the coupled inductor design. With the derived optimal interleaving angle, the CM and DM EMI noise are significantly reduced.

Chen, Ruirui↗

Operation of a Flexible Dynamic Boundary Microgrid with Multiple Islands

A microgrid with dynamic boundary can expand or shrink its boundary depending on available local distributed energy resources (DER). Compared to conventional microgrid with fixed boundary, it can lead to better DER utilization and improved reliability. Previous literature has only considered the operation of a microgrid with a single island that is energized by stable voltage sources. This paper introduces control function designs that can effectively synchronize islands inside a dynamic boundary microgrid, depending on the operation status of each voltage source inside the islands. An overview of the components and rationale within the control function designs is provided, and hardware-in-the-loop simulation results are analyzed to demonstrate the effectiveness of the control functions.

Zhen, Shuying↗

Analytical Analysis of Ac and Dc Side Harmonics of Three-level Active Neutral Point Clamped Inverter with Space Vector Modulation

This paper presents a comprehensive analytical analysis of the ac and dc side harmonics of the three-level active neutral point clamped (ANPC) inverter with space vector modulation (SVM) scheme. An analytical model to calculate the harmonics of a three-level converter with SVM is developed. The ac side output voltage harmonics and dc side current harmonics characteristics are calculated and analyzed. With the developed models, the impact of interleaving on both sides harmonics are studied which considers the modulation index, interleaving angle, and power factor. The analysis provides guideline for interleaving angle optimization to reduce the ac side power filter and dc side dc-link capacitor. The relationship between electromagnetic interference (EMI) filter corner frequency and switching frequency is also analytically derived which provides guideline for switching frequency and EMI filter design optimization. Two paralleled three-level ANPC inverters are constructed and experimental results are presented to verify the analytical analysis.

Chen, Ruirui↗

Analysis of Circulating Harmonic Currents in Paralleled Three Level ANPC Inverters using SVM

In paralleled voltage source inverters (VSI), circulating current has both high frequency and low frequency components, and its spectrum highly depends on the modulation scheme. Previous research has mostly focused on the circulating current suppression for paralleled two-level VSIs. Little literature exists on similar analysis for paralleled three-level VSIs using space vector modulation. A detailed circulating current spectrum on full frequency range has not been well developed. This paper presents an improved analytical model for three-level space vector modulation (SVM), considering the impacts of regularly sampled reference and dead time. Then, circulating harmonic currents are determined across the full frequency range for various interleaving angles of two three-level ANPC inverters. The calculated harmonics are also verified by experimental results.

Niu, Jiahao↗

A Simple Control to Reduce Device Over-Voltage Caused by Non-Active Switch Loop in Three-Level ANPC Converters

With the development of wide band-gap (WBG) technology, the switching speed of power semiconductor devices increases, which makes circuits more sensitive to parasitics. For three-level active neutral point clamped (3L-ANPC) converters, the over-voltage caused by additional non-active switch loop can be an issue. This paper analyzes the multiple commutation loops in 3L-ANPC converter and summarizes the impact factors of the device over-voltage. The nonlinearity of the output capacitance of the device can significantly influence the over-voltage. A simple control without introducing additional hardware circuit or complex software algorithm is proposed to attenuate the effect of the nonlinear output capacitance. Multi-pulse test is conducted for a 3L-ANPC converter built with silicon carbide (SiC) MOSFETs. With the proposed control, the testing results show that the peak drain-source voltage of both active and non-active switches is reduced by more than 20% compared to the conventional control.

Gui, Handong↗

Current Source Gate Drive to Reduce Switching Loss for SiC MOSFETs

With conventional voltage source gate drives (VSG), the switching speed of SiC MOSFETs is difficult to increase due to large internal gate resistance, high Miller voltage, and limited gate voltage rating. This paper analyzes the requirement of current source gate drive (CSG) for SiC MOSFETs and proposes a CSG that can improve the switching speed and reduce switching loss. With the introduction of bi-directional switches, the influence of the large internal gate resistance of the SiC MOSFET can be mitigated, and sufficient gate current can be guaranteed throughout the switching transient. Therefore, the switching time and loss is reduced. The CSG can be controlled to be a VSG during steady state so the current of the gate drive is discontinuous and the stored energy of the inductor can be returned to the power supply to reduce gate drive loss. Double pulse tests are conducted for a SiC MOSFET with both conventional VSG and the proposed CSG. Testing results show that the switching loss of the proposed CSG is less than one third of the conventional VSG at full load condition.

Gui, Handong↗

Investigation of Fourth-leg for Common-mode Noise Reduction in Three-level Neutral Point Clamped Inverter Fed Motor Drive

The four-leg topology has been applied to two-level inverters for common-mode (CM) noise elimination. To achieve zero common-mode voltage (CMV), the zero vector typically used in the two-level inverter is not allowed. As a result, the reference cannot be synthesized by nearest three vectors, which introduces a penalty in dc voltage utilization and current THD. This paper applies the fourth-leg to three-level neutral point clamped (NPC) inverter fed motor drives. Unlike the case in the two-level inverter, the reference can be synthesized by the nearest three vectors while zero CMV can be achieved at the same time in a three-level inverter with the fourth-leg. The topology and modulation are presented. The fourth-leg filter structures are investigated, and a fourth-leg filter structure which decouples the fourth-leg from the main circuit power level is proposed for high power applications. The experiment results on a three-level NPC inverter show that with the fourth-leg and presented modulation applied, the CM noise has been significantly reduced, and around 25 dB attenuation can be observed at the first noise peak in the electromagnetic interference (EMI) frequency range.

Chen, Ruirui↗

Non-aqueous flow cell comprising a polyurethane separator

A non-aqueous flow cell energy storage device comprises a ionically conductive separator, which separator comprises a polyurethane prepared by curing an isocyanate capped prepolymer, which prepolymer was prepared from a polyol having polycarbonate backbone, wherein the separator may be impregnated with electrolyte salts and/or swelled by an organic solvent.

Madabusi, Venkatramanan K.↗

High electronic conductivity as the origin of lithium dendrite formation within solid electrolytes

Solid electrolytes (SEs) are widely considered as an ‘enabler’ of lithium anodes for high-energy batteries. However, recent reports demonstrate that the Li dendrite formation in Li 7 La 3 Zr 2 O 12 (LLZO) and Li 2 S–P 2 S 5 is actually much easier than that in liquid electrolytes of lithium batteries, by mechanisms that remain elusive. Here we illustrate the origin of the dendrite formation by monitoring the dynamic evolution of Li concentration profiles in three popular but representative SEs (LiPON, LLZO and amorphous Li 3 PS 4 ) during lithium plating using time-resolved operando neutron depth profiling. Although no apparent changes in the lithium concentration in LiPON can be observed, we visualize the direct deposition of Li inside the bulk LLZO and Li 3 PS 4 . Furthermore, our findings suggest the high electronic conductivity of LLZO and Li 3 PS 4 is mostly responsible for dendrite formation in these SEs. Lowering the electronic conductivity, rather than further increasing the ionic conductivity of SEs, is therefore critical for the success of all-solid-state Li batteries.

36 MATERIALS SCIENCE↗

Unusual pressure-induced electronic structure evolution in organometal halide perovskite predicted from first-principles

Pressure has been demonstrated to be an effective parameter to alter the atomic and electronic structures of materials. By using the first-principles calculations based on density functional theory (DFT), we systematically investigated the changes in the atomic and electronic structures of the cubic MAPbI 3 phase under pressures. It is found that the band gap of the compressed cubic MAPbI 3 structure exhibits a remarkable redshift to 1.114/1.380 eV in DFT/HSE-SOC calculation under a mild pressure of 2.772 GPa, and subsequently shows a widening at higher pressures until ~20 GPa. As the pressure further increases, the band gap closes at ~80 GPa. Detailed structural and electronic characteristic analyses indicate that the band gap of the cubic MAPbI 3 structure is determined by two competing effects: the lattice contraction decreases its band gap while the PbI 6 octahedral tilting increases it. Given that, pressure can be a powerful tool to help understanding the optoelectronic properties of perovskite materials.

36 MATERIALS SCIENCE↗