Engineering Papers⌕ Search

Engineering topics

Wang, B.

Publications and source records attributed to Wang, B..

18 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Sound speed measurements in shock compressed cemented tungsten carbide: Evolution of elastic moduli with damage at pressures to 100 GPa

The motivation of the present study is to gain insights into the evolution of elastic properties of cemented tungsten carbides (WC) shock compressed to 100 GPa. Seven plate impact experiments—two front surface impact and five release wave overtake—are conducted to make simultaneous measurements of Hugoniot states and longitudinal sound speeds in shocked WC with 3.7wt.% cobalt binder. The sound speeds along with estimates for bulk sound speeds, obtained using the Birch–Murnaghan EoS, are analyzed to determine the elastic moduli—longitudinal, bulk, and shear—as a function of Hugoniot stress. The longitudinal and bulk sound speeds at Hugoniot states of interest are found to increase linearly with longitudinal stress. Consistent with the increase in sound speeds, the longitudinal and bulk moduli also increase with Hugoniot stress; however, the increase in longitudinal modulus is modest when compared to predictions of theoretical models that account for pressure and temperature dependence of elastic moduli, but with no damage. The shear moduli remain nearly constant at ~318 GPa over the range of Hugoniot states investigated. These values are, however, much lower than those predicted by the Steinberg–Guinan model with no damage. Poisson’s ratio decreases initially from its ambient value of 0.208 to ~0.199 for Hugoniot stress ≤10 GPa indicating consolidation of the WC microstructure with low initial stress; however, with an increase in Hugoniot stress to ~100 GPa, Poisson’s ratio increases to ~0.317, indicating degradation of shear moduli with increasing stress. The product of density and Grüneisen parameter (ρΓ), after an initial spike, remains nearly constant for volumetric strains ≥0.07. The maximum average temperature rise is estimated to be ~286°C at the highest Hugoniot stress employed in the study.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Shock compression of cemented tungsten carbides to 100 GPa: Structure of shock waves, Hugoniot relations, and strength

Plate impact experiments are conducted on cemented tungsten carbides (WC) with a 3.7 and 6.0 wt. % cobalt binder to better understand their dynamic, high-pressure response to 100 GPa. The measured wave profiles show propagation of steady structured waves. Standard impedance matching procedures are used to determine the Hugoniot relations in the shock velocity–particle velocity (U s –v p ) and Hugoniot stress–specific volume (P–V/V o ) planes. The Hugoniot elastic limit of the samples is controlled by ductility of the Co binder and is determined to be 4.45 ± 0.29 GPa for cemented WC with 3.7 wt. % cobalt and 3.72 ± 0.24 GPa for a 6.0 wt. % cobalt binder. Both grades show a non-linear U s –v p relationship depending on whether the particle velocity is in the strength dominated or hydrodynamic regime. In the strength dominated regime, a non-linear decrease in U s is observed as v p increases from ambient to the material’s hydrodynamic limit. In the hydrodynamic regime, the U s –v p Hugoniot is linear and is determined to be U s = 4.97(±0.006)+1.446(±0.018)v p km/s for WC with 3.7 wt. % Co and U s = 4.93(±0.006)+1.463(±0.017)v p km/s for 6 wt. % Co. Both WC grades indicate shear-stress hardening with mean stress immediately after yield, followed by pressure softening, and then a sharp fall in stress carrying capacity as the mean stress is increased to ≈70 GPa (hydrodynamic limit) and beyond. This behavior is in contrast to pure WC ceramics, which show continued shear-stress hardening with mean stress to ≈80 GPa.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Optimal 1D Ly α forest power spectrum estimation – III. DESI early data

ABSTRACT The 1D power spectrum P1D of the Ly α forest provides important information about cosmological and astrophysical parameters, including constraints on warm dark matter models, the sum of the masses of the three neutrino species, and the thermal state of the intergalactic medium. We present the first measurement of P1D with the quadratic maximum likelihood estimator (QMLE) from the Dark Energy Spectroscopic Instrument (DESI) survey early data sample. This early sample of 54 600 quasars is already comparable in size to the largest previous studies, and we conduct a thorough investigation of numerous instrumental and analysis systematic errors to evaluate their impact on DESI data with QMLE. We demonstrate the excellent performance of the spectroscopic pipeline noise estimation and the impressive accuracy of the spectrograph resolution matrix with 2D image simulations of raw DESI images that we processed with the DESI spectroscopic pipeline. We also study metal line contamination and noise calibration systematics with quasar spectra on the red side of the Ly α emission line. In a companion paper, we present a similar analysis based on the Fast Fourier Transform estimate of the power spectrum. We conclude with a comparison of these two approaches and discuss the key sources of systematic error that we need to address with the upcoming DESI Year 1 analysis.

79 ASTRONOMY AND ASTROPHYSICS↗
DOE OSTI2023

The Lyman-α forest catalogue from the Dark Energy Spectroscopic Instrument Early Data Release

We present and validate the catalogue of Lyman-α forest fluctuations for 3D analyses using the Early Data Release (EDR) from the Dark Energy Spectroscopic Instrument (DESI) survey. We used 88 511 quasars collected from DESI Survey Validation (SV) data and the first two months of the main survey (M2). We present several improvements to the method used to extract the Lyman-α absorption fluctuations performed in previous analyses from the Sloan Digital Sky Survey (SDSS). In particular, we modify the weighting scheme and show that it can improve the precision of the correlation function measurement by more than 20 percent. This catalogue can be downloaded from https://data.desi.lbl.gov/public/edr/vac/edr/lya/fuji/v0.3, and it will be used in the near future for the first DESI measurements of the 3D correlations in the Lyman-α forest.

79 ASTRONOMY AND ASTROPHYSICS↗
DOE OSTI2023

Overview of Nuclear Data Measurement and Analysis at RP [Slides]

This presentation details neutron capture in 54 Fe along with neutron capture yield and γ-ray cascade spectra measurements. The presentation then follows with thermal neutron die-away measurements and concludes with URR improvement to SAMMY.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗
DOE OSTI2023

Quasi-Differential Neutron Scattering Measurements of 181 Ta and Teflon from 1.5 to 20 MeV [Slides]

This presentation covers motivation for the Experiments Performed. Secondly, it touches on upgrades to the Experimental Apparatus for Measurements. Thirdly, it presents quasi-Differential Experimental Methodology a) Pulse Shape Discrimination b) Validation Measurement of Carbon. The presentation concludes with Preliminary Results and Future Studies.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗
DOE OSTI2023

High Energy Quasi - Differential Neutron Emission Measurements of 181 Ta and 19 F [Slides]

This presentation begins with the motivation for performing 181 Ta and 19 F high energy quasi-differential and neutron emission measurements. It then provides a discussion of significant pulse digitization upgrade. The Quasi-Differential methodology and importance for validating nuclear data are provided. Preliminary results from 181 Ta and 19 F are displayed. The presentation concludes with a discussion and future studies.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2022

Total thermal neutron cross section measurements of hydrogen dense polymers from 0.0005–20 eV

Hydrogen dense polymers, specifically polyethylene, polystyrene, and Plexiglas, have served as neutron moderator and reflector materials in hundreds of separate critical benchmark experiments because of their low cost and abundance of hydrogen. In order to accurately model and simulate these critical benchmarks, the thermal scattering law (TSL) evaluation that governs how neutrons will thermalize must be well understood and rigorously validated. To support this validation, researchers at Rensselaer Polytechnic Institute performed total neutron cross section measurements for high-density polyethylene & polystyrene over the energy range 0.0005–20 eV and for Plexiglas G & Plexiglas G-UVT over the energy range 0.0005–3 eV. Comparisons were made between the measured cross section and that predicted by the ENDF/B-VIII.0 and Oak Ridge National Laboratory/European Spallation Source/Rensselaer Polytechnic Institute TSL evaluations for polyethylene, Plexiglas, and polystyrene, as available. These experiments represent the first total neutron cross section measurements for polystyrene.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2022

A deterministic gradient-based approach to avoid saddle points

Abstract Loss functions with a large number of saddle points are one of the major obstacles for training modern machine learning (ML) models efficiently. First-order methods such as gradient descent (GD) are usually the methods of choice for training ML models. However, these methods converge to saddle points for certain choices of initial guesses. In this paper, we propose a modification of the recently proposed Laplacian smoothing gradient descent (LSGD) [Osher et al., arXiv:1806.06317 ], called modified LSGD (mLSGD), and demonstrate its potential to avoid saddle points without sacrificing the convergence rate. Our analysis is based on the attraction region, formed by all starting points for which the considered numerical scheme converges to a saddle point. We investigate the attraction region’s dimension both analytically and numerically. For a canonical class of quadratic functions, we show that the dimension of the attraction region for mLSGD is $\lfloor (n-1)/2\rfloor$ , and hence it is significantly smaller than that of GD whose dimension is $n-1$ .

Mathematics↗
DOE OSTI2022

Overview of Nuclear Data Measurement and Analysis at RPI [Slides]

This presentation discusses the experimental, simulation, and nuclear data methods that were validated for the RPI γ-Multiplicity Detector. When the neutron capture γ-cascade data is well-known, the γ-emission spectra can be accurately calculated using the modified simulation tools. The RPI γ-Multiplicity Detector system is now ready for analysis and recommendations for isotopes with deficiencies in γ-ray data. The presentation also discusses future work which includes developing a method for analyzing and adjusting nuclear data for 59 Co, 55 Mn and other measured isotopes including 181 Ta. Additionally, future work includes comparing experimental γ-emission spectra with MCNP-6.2/DICEBOX simulations for 238 U and 235 U. In summation, new capture and transmission measurements for 54 Fe will help improve resonance parameter evaluation. Neutron capture gamma cascade spectra and yields were measured in the resolved resonance region and compared to evaluations. In addition, the pulsed neutron die-away method was developed as a tool to provide data for validation of TSLs.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
NASA NTRS2018

Investigating Hydrometeorological Conditions Associated with Increasing Dust Events in Southwestern United States

A recent study (Tong et al. 2017) shows a rapid intensification of dust storm activity over the southwestern United States in the past decades. For example, the frequency of windblown dust storms has increased 240 percent from 1990s to 2000s. Increasing dust storms can worsen air quality in the region. The study also finds that the intensification of dust events has a close connection with a fast-rising infectious disease (valley fever) caused by inhaling soil-dwelling fungi (Coccidioides immitis and C. posadasii) in the southwestern United States. Hydrometeorological conditions play an important role in dust storm activity, including winds, precipitation, soil moisture, atmospheric boundary stability, land surface types, etc. In this presentation, we describe our preliminary results of linking the dust trends to variations of hydrometeorological conditions at regional and global scales, using a number of Earth observations, including products from NLDAS (North American Land Data Assimilation System), TRMM (Tropical Rainfall Measuring Mission), and MERRA (Modern Era Retrospective-analysis for Research and Applications) datasets, from NASA Goddard Earth Sciences (GES) Data and Information Services Center (DISC). The GES DISC, one of the 12 NASA data centers, is home to multidisciplinary data archives such as precipitation, hydrology, atmospheric chemistry, atmospheric dynamics, etc. We demonstrate that multidisciplinary datasets and services at GES DISC can be used for interdisciplinary investigation to understand the interactions of Earth system components from an observational perspective.

satellite↗
NASA NTRS2009

Monolithic Parallel Tandem Organic Photovoltaic Cell with Transparent Carbon Nanotube Interlayer

We demonstrate an organic photovoltaic cell with a monolithic tandem structure in parallel connection. Transparent multiwalled carbon nanotube sheets are used as an interlayer anode electrode for this parallel tandem. The characteristics of front and back cells are measured independently. The short circuit current density of the parallel tandem cell is larger than the currents of each individual cell. The wavelength dependence of photocurrent for the parallel tandem cell shows the superposition spectrum of the two spectral sensitivities of the front and back cells. The monolithic three-electrode photovoltaic cell indeed operates as a parallel tandem with improved efficiency.

Tanaka, S.↗
NASA NTRS2003

New Particle Formation in Anthropogenic Plumes Advecting from Asia Observed During TRACE-P

The characteristics and sources of what are believed to be newly formed 3 to 4 nm particles in anthropogenic plumes advecting from Asian are reported. Airborne measurements were made from March to April 2001 as part of the NASA TRACE-P experiment at latitudes ranging from North of the Philippines to Northern Japan (20 to 45 deg. N). In the more polluted plumes, high concentrations of 3 to 4 nm diameter particles (less than 100/qu cm) were observed both within and along the upper outer edges of plumes that were identified by enhanced carbon monoxide and fine particulate sulfate concentrations. The results from two research flights are investigated in detail. Three to four-nm particle concentrations are generally correlated with gas phase sulfuric acid and found in regions of low surface areas relative to the immediate surroundings or where there are steep transitions to lower surface areas. Sulfuric acid and surface area concentrations in the most polluted plume reached 6 x l0(exp 7) and 750 micro sq m/qu cm, respectively, in regions of particle formation. In contrast to these anthropogenic plumes, few 3 to 4 nm particles were observed in the clean background and few were detected within a volcanic plume where the studies highest H2SO4 concentrations (less than lO(exp 8)/qu cm) were recorded. Enhanced SO2 concentrations in the range of approximately 2 to 7 ppb, in conjunction with other unidentified, possibly coemitted species, appear to be the driving factor for nucleation. (0345, 4801); 0322 Atmospheric Composition and Structure: Constituent sources and sinks; 0345 Atmospheric Composition and Structure: Pollution-urban and regional (0305); 4801 Oceanography: Biological and Chemical: Aerosols (0305).

Weber, R. J.↗
NASA NTRS2001

Heavy ion induced soft breakdown of thin gate oxides

Heavy ion induced soft and hard breakdown are investigated in thin gate oxides as a function of LET, fluence, and voltage applied during irradiation. It is found that post-irradiation oxide conduction is well described by the Sune quantum point contact model.

radiation↗