Engineering topics

Wang, A.-H.

Publications and source records attributed to Wang, A.-H..

8 records

NASA NTRS1999

A Two-Fluid, MHD Coronal Model

We describe first results from a numerical two-fluid MHD model of the global structure of the solar Corona. The model is two-fluid in the sense that it accounts for the collisional energy exchange between protons and electrons. As in our single-fluid model, volumetric heat and Momentum sources are required to produce high speed wind from Corona] holes, low speed wind above streamers, and mass fluxes similar to the empirical solar wind. By specifying different proton and electron heating functions we obtain a high proton temperature in the coronal hole and a relatively low proton temperature above the streamer (in comparison with the electron temperature). This is consistent with inferences from SOHO/UltraViolet Coronagraph Spectrometer instrument (UVCS), and with the Ulysses/Solar Wind Observations Over the Poles of the Sun instrument (SWOOPS) proton and electron temperature measurements which we show from the fast latitude scan. The density in the coronal hole between 2 and 5 solar radii (2 and 5 R(sub S)) is similar to the density reported from SPARTAN 201.-01 measurements by Fisher and Guhathakurta [19941. The proton mass flux scaled to 1 AU is 2.4 x 10(exp 8)/sq cm s, which is consistent with Ulysses observations. Inside the closed field region, the density is sufficiently high so that the simulation gives equal proton and electron temperatures due to the high collision rate. In open field regions (in the coronal hole and above the streamer) the proton and electron temperatures differ by varying amounts. In the streamer the temperature and density are similar to those reported empirically by Li et al. [1998], and the plasma beta is larger than unity everywhere above approx. 1.5 R(sub S), as it is in all other MHD coronal streamer models [e.g., Steinolfson et al., 1982; also G. A. Gary and D. Alexander, Constructing the coronal magnetic field, submitted to Solar Physics, 1998].

Suess, S. T.↗

NASA NTRS1998

A Two-Fluid, MHD Coronal Model

We describe first results from a numerical two-fluid MHD model of the global structure of the solar corona. The model is two-fluid in the sense that it accounts for the collisional energy exchange between protons and electrons. As in our single-fluid model, volumetric heat and momentum sources are required to produce high speed wind from coronal holes, low speed wind above streamers, and mass fluxes similar to the empirical solar wind. By specifying different proton and electron heating functions we obtain a high proton temperature in the coronal hole and a relatively low proton temperature in the streamer (in comparison with the electron temperature). This is consistent with inferences from SOHO/UVCS, and with the Ulysses/SWOOPS proton and electron temperature measurements which we show from the fast latitude scan. The density in the coronal hole between 2 solar radii and 5 solar radii (2RS and 5RS) is similar to the density reported from SPARTAN 201-01 measurements by Fisher and Guhathakurta. The proton mass flux scaled to 1 AU is 2.4 x 10(exp 8)/sq cm s, which is consistent with Ulysses observations. Inside the closed field region, the density is sufficiently high so that the simulation gives equal proton and electron temperatures due to the high collision rate. In open field regions (in the coronal hole and above the streamer) the proton and electron temperatures differ by varying amounts. In the streamer, the temperature and density are similar to those reported empirically by Li et al and the plasma beta is larger than unity everywhere above approx. 1.5 R(sub s), as it is in all other MHD coronal streamer models.

Suess, Steven T.↗

NASA NTRS1998

The Geometric Spreading of Coronal Plumes and Coronal Holes

The geometric spreading in plumes and in the interplume region in coronal holes is calculated, using analytic and numerical theoretical models, between 1.0 and 5.0 solar radius. We apply a two-scale approximation that permits the rapid local spreading at the base of plumes (f(sub t)) to be evaluated separately from the global spreading (f(sub g)) imposed by coronal hole geometry. We show that f(sub t) can be computed from a potential-field model and f(sub g) can be computed from global magnetohydrodynamic simulations of coronal structure. The approximations are valid when the plasma beta is mail with respect to unity and for a plume separation small with respect to a solar radius.

Suess, S. T.↗

NASA NTRS1998

Streamer Evaporation

Evaporation is the consequence of heating near the top of streamers in ideal Magnetohydrodynamics (MHD) models, where the plasma is weakly contained by the magnetic field. Heating causes slow opening of field lines and release of new solar wind. It was discovered in simulations and, due to the absence of loss mechanisms, the ultimate end point is the complete evaporation of the streamer. Of course streamers do not behave in this way because there are losses by thermal conduction and radiation. Physically, heating is also expected to depend on ambient conditions. We use our global MHD model with thermal conduction to examine the effect of changing the heating scale height. We also apply and extend an analytic model of streamers developed by Pneuman (1968) to show that steady streamers are unable to contain plasma for temperatures near the cusp greater than approximately 2 x 10(exp 6) K.

Suess, S. T.↗

NASA NTRS1993

A two-dimensional MHD global coronal model - Steady-state streamers

We describe a two-dimensional time-dependent, numerical, magnetohydrodynamic model for the determination of the physical properties of coronal streamers from the top of the transition zone (solar radius = 1) to 15 solar radii. Four examples are given: for dipole, quadrupole, and hexapole initial field topologies. The computed parameters are density, temperature, velocity, and magnetic field. In addition to the properties of the solutions, their accuracy is discussed. We use the model as the basis for a general discussion of the way boundary conditions are specified in this and similar simulations.

Wang, A.-H.↗

NASA NTRS1993

L-alpha intensity in coronal streamers

White-light images are presently the primary source of information on physical conditions in the solar corona at distances greater than a few tenths of a solar radius above the limb. As a consequence, we still only have an incomplete description of structures extending beyond the solar limb. In particular, streamers, although observed for decades, represent a poorly known phenomenon. SOHO, to be launched in 1995, will be able to make long-term observations of these features up to heights of a few solar radii, both in white light and UV. In this paper we present simulations of L-alpha intensity in coronal streamers, based on the two-dimensional (2D) model developed by Wang et at. (1992, 1993) via a time-dependent numerical relaxation approach. Because the model is 2D, we make an a priori hypothesis about the extension of streamers in the third dimension. L-alpha data, obtained from a rocket (Kohl et al., 1983), allowed us to identify a shape which fits the observations.

Noci, G.↗

NASA NTRS1992

Predicting Ly-alpha intensities in coronal streamers

SOHO (Solar and Heliospheric Observatory) UVCS (Ultraviolet Coronagraph Spectrometer) will make long term observations of coronal streamers in UV lines, providing a new tool for the analysis of structures which have been known for decades but are still far from being adequately described. Work to evaluate the Lyman alpha brightness of coronal streamers is reported, adopting the streamer models obtained, via a time dependent numerical relaxation technique. This will yield understanding on the role of geometric versus physical factors in determining the streamer lyman alpha intensity and provide guidelines for UVCS observational operations. Future prospects along this line of research are summarized.

Noci, Giancarlo↗

NASA NTRS1992

A two-dimensional MHD global coronal model - Steady-state streamers

A 2D, time-dependent, numerical, MHD model for the simulation of coronal streamers from the solar surface to 15 solar is presented. Three examples are given; for dipole, quadrupole and hexapole (Legendre polynomials P1, P2, and P3) initial field topologies. The computed properties are density, temperature, velocity, and magnetic field. The calculation is set up as an initial-boundary value problem wherein a relaxation in time produces the steady state solution. In addition to the properties of the solutions, their accuracy is discussed. Besides solutions for dipole, quadrupole, and hexapole geometries, the model use of realistic values for the density and Alfven speed while still meeting the requirement that the flow speed be super-Alfvenic at the outer boundary by extending the outer boundary to 15 solar radii.

Wang, A.-H.↗