Engineering Papers⌕ Search

Engineering topics

Walker, J. D. A.

Publications and source records attributed to Walker, J. D. A..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

Embedded function methods for compressible high speed turbulent flow

This is the final report on the work performed on the grant 'Embedded Function Methods for Compressible High Speed Turbulent Flow' carried out at Lehigh University during the contract period from September, 1987, to October of 1991. Work has continued at Lehigh on this project on an unfunded basis to the present. The original proposed work had two separate thrusts which were associated with developing embedded function methods in order to obviate the need to expend computational resources on turbulent wall layers in Navier Stokes and boundary-layer calculations. Previous work on the incompressible problem had indicated that this could be done successfully for two-dimensional and three-dimensional incompressible flows. The central objective here was to extend the basic approach to the high speed compressible problem.

Walker, J. D. A.↗
NASA NTRS1993

The structure of a three-dimensional turbulent boundary layer

The three-dimensional turbulent boundary layer is shown to have a self-consistent two-layer asymptotic structure in the limit of large Reynolds number. In a streamline coordinate system, the streamwise velocity distribution is similar to that in two-dimensional flows, having a defect-function form in the outer layer which is adjusted to zero at the wall through an inner wall layer. An asymptotic expansion accurate to two orders is required for the cross-stream velocity which is shown to exhibit a logarithmic form in the overlap region. The inner wall-layer flow is collateral to leading order but the influence of the pressure gradient, at large but finite Reynolds numbers, is not negligible and can cause substantial skewing of the velocity profile near the wall. Conditions under which the boundary layer achieves self-similarity and the governing set of ordinary differential equations for the outer layer are derived. The calculated solution of these equations is matched asymptotically to an inner wall-layer solution and the composite profiles so formed describe the flow throughout the entire boundary layer. The effects of Reynolds number and cross-stream pressure gradient on the crossstream velocity profile are discussed and it is shown that the location of the maximum cross-stream velocity is within the overlap region.

Degani, A. T.↗
NASA NTRS1992

Some aspects of unsteady separation

Unsteady separation can be forced in a variety of ways and in this presentation two fundamental means will be considered: (1) the introduction of convected vorticular disturbances into the flow; and (2) the influence of a specific type of three-dimensional geometry. In both situations a response of the viscous flow near the wall is provoked wherein the fluid near the surface abruptly focuses into a narrow region that erupts from the surface into the mainstream. In two-dimensional flows, the eruption takes the form of a narrow, explosively-growing spike, while in three-dimensional situations, examples are presented which indicate that the eruption is along a narrow zone in the shape of a crescent-shaped plume. The nature of the three-dimensional flow near a circular cylinder, which is mounted normal to a flat plate, is also examined in this study. Here the three-dimensional geometry induces complex three-dimensional separations periodically. The dynamics of the generation process is studied experimentally in a water channel using hydrogen bubble wires and a laser sheet, and the main features of the laminar regime through to transition are documented.

Smith, C. R.↗
NASA NTRS1992

The three-dimensional turbulent boundary layer near a plane of symmetry

The asymptotic structure of the three-dimensional turbulent boundary layer near a plane of symmetry is considered in the limit of large Reynolds number. A self-consistent two-layer structure is shown to exist wherein the streamwise velocity is brought to rest through an outer defect layer and an inner wall layer in a manner similar to that in two-dimensional boundary layers. The cross-stream velocity distribution is more complex and two terms in the asymptotic expansion are required to yield a complete profile which is shown to exhibit a logarithmic region. The flow in the inner wall layer is demonstrated to be collateral to leading order; pressure-gradient effects are formally of higher order but can cause the velocity profile to skew substantially near the wall at the large but finite Reynolds numbers encountered in practice. The governing set of ordinary differential equations describing a self-similar flow is derived. The calculated numerical solutions of these equations are matched asymptotically to an inner wall-layer solution and the results show trends that are consistent with experimental observations.

Degani, A. T.↗
NASA NTRS1992

An algebraic model for dissipation in supersonic boundary layers

With increasing mainstream Mach number, viscous dissipation becomes a progressively important influence in high-speed compressible turbulent boundary layers. An asymptotic analysis is carried out for high Reynolds numbers and Mach numbers of order 1, and it is shown that viscous dissipation gives rise to important terms in the solution of the total enthalpy equation. For simplicity, the case of supersonic flow over an adiabatic wall is considered. An expression for the adiabatic wall temperature is derived. It is shown that the asymptotic analysis constrains the types of turbulence models that can be used to represent the effects of viscous dissipation. A simple algebraic turbulence model is proposed and comparisons with measured total enthalpy profile data show good agreement.

He, J.↗
NASA NTRS1991

On the application of algebraic turbulence models to high Mach number flows

In this paper the implementation of embedded-function algorithms for conventional algebraic turbulence models is described; using this methodology it is shown that the entire wall layer may be removed from the calculation algorithm (as well as near-wall mixing-length models) with no degradation in the accuracy of predicted results for skin friction. Various difficulties that are associated with the application of conventional algebraic models in high-speed flows are discussed. Alternative algebraic models are proposed which are cast in terms of the Howarth-Dorodnitsyn variable and which lead to a simple 'law of the wall' for both velocity and total enthalpy.

Degani, A. T.↗
NASA NTRS1991

Evolution of hairpin vortices in a shear flow

Recent experimental studies suggest that the hairpin vortex plays an important (and perhaps dominant) role in the dynamics of turbulent flows near walls. In this study, a numerical procedure is developed to allow the accurate computation of the trajectory of a 3D vortex having a small core radius. For hairpin vortices which are convected in a shear flow above a wall, the calculated results show that a 2D vortex containing a small 3D disturbance distorts into a complex shape with subsidiary hairpin vortices forming outboard of the original hairpin vortex. As the vortex moves above the wall, it induces unsteady motion in the viscous flow near the wall: numerical solutions suggest that the boundary-layer flow near the wall will ultimately erupt in response to the motion of the hairpin vortex and in the process a secondary hairpin vortex will be created. The computer results agree with recent experimental investigations.

Hon, T.-L.↗
NASA NTRS1990

Embedded function methods for supersonic turbulent boundary layers

The development of embedded functions to represent the mean velocity and total enthalpy distributions in the wall layer of a supersonic turbulent boundary layer is considered. The asymptotic scaling laws (in the limit of large Reynolds number) for high speed compressible flows are obtained to facilitate eventual implementation of the embedded functions in a general prediction method. A self-consistent asymptotic structure is derived, as well as a compressible law of the wall in which the velocity and total enthalpy are logarithmic within the overlap zone, but in the Howarth-Dorodnitsyn variable. Simple outer region turbulence models are proposed (some of which are modifications of existing incompressible models) to reflect the effects of compressibility. As a test of the methodology and the new turbulence models, a set of self-similar outer region profiles is obtained for constant pressure flow; these are then coupled with embedded functions in the wall layer. The composite profiles thus obtained are compared directly with experimental data and good agreement is obtained for flows with Mach numbers up to 10.

He, J.↗
NASA NTRS1990

Computation of three-dimensional turbulent boundary layers with heat transfer in a plane of symmetry using embedded wall-layer functions

In the calculation of turbulent boundary layers, a large number of mesh points are required to adequately resolve the intense variation in the velocity and enthalpy in the near-wall region. A substantial reduction in computational effort may be realized by representing the velocity and enthalpy profiles in the wall layer by analytical embedded functions. The effectively inviscid flow in the outer part of the boundary layer may then be resolved by employing a relatively coarser mesh. To obtain complete profiles, the outer numerical solution is matched asymptotically to the inner wall-layer analytical solution. To date, this approach has been restricted to two-dimensional flows; in the present study, a method which may be utilized for turbulent boundary layers with heat transfer in a plane of symmetry is developed as a first step in the application of the embedded-function method to full three-dimensional flows. The present method uses only about half as many mesh points as that required in a conventional procedure, which calculates the flow all the way to the wall, but there is no degradation in accuracy of the computed results.

Degani, A. T.↗
NASA NTRS1989

Wall-layer eruptions in turbulent flows

The near-wall region of a turbulent flow is investigated in the limit of large Reynolds numbers. When low-speed streaks are present, the governing equations are shown to be of the boundary-layer type. Physical processes leading to local breakdown and a strong interaction with the outer region are considered. It is argued that convected vortices, predominantly of the hairpin type, will provoke eruptions and regenerative interactions with the outer region.

Walker, J. D. A.↗
NASA NTRS1989

Asymptotic structure and similarity solutions for three-dimensional turbulent boundary layers

The asymptotic structure of the three-dimensional turbulent boundary layer is investigated in the limit of large Reynolds numbers. A self-consistent, but relatively complex, two-layer structure exists and the simplest situation, corresponding to a plane of symmetry, is considered in this paper as a first step. The adjustment of the streamwise velocity to relative rest, through an outer defect layer and then an inner wall layer, is similar to that in two-dimensional flow. The adjustment of the cross-streamwise velocity is more complicated and it is shown that two terms in the expansion are required to obtain useful results, and in particular to obtain the velocity skew angle at the wall near the symmetry plane. The conditions under which self-similarity is achieved near a plane of symmetry are investigated. A set of ordinary differential equations is developed which describe the streamwise and cross-streamwise velocities near a plane of symmetry in a self-similar flow through two orders of magnitude. Calculated numerical solutions of these equations yield trends which are consistent with experimental observations.

Degani, A. T.↗
NASA NTRS1989

Embedded function methods for compressible high speed turbulent flow

Fundamental issues relating to compressible turbulent flow are addressed. The focus has been on developing methods and testing concepts for attached flows rather than trying to force a conventional law of the wall into a zone of backflow. Although the dynamics of the near-wall flow in an attached turbulent boundary layer are relatively well documented, the dynamical features of a zone of reversed turbulent flow are not, nor are they well understood. Incompressibility introduces effects and issues that have been dealt with only marginally in the literature, therefore, the present work has been focussed on attached high-speed flows. The wall function method has been extended up through the supersonic to hypersonic speeds. Algorithms have been successfully introduced into the code that calculates the flow all the way to the wall, and testing is being carried out for progressively more complex flow situations.

Walker, J. D. A.↗
NASA NTRS1988

Evolution of hairpin vortices in a shear flow

Recent experimental studies suggest that the hairpin vortex plays an important (and perhaps dominant) role in the dynamics of turbulent flows near walls. In this study a numerical procedure is developed to allow the accurate computation of the trajectory of a 3-D vortex having a small core radius. For hairpin vortices which are convected in a shear flow above a wall, the calculated results show that a 2-D vortex containing a small 3-D disturbance distorts into a complex shape with subsidiary hairpin vortices forming outboard of the original hairpin vortex. As the vortex moves above the wall, it induces unsteady motion in the viscous flow near the wall: numerical solutions suggest that the boundary-layer flow near the wall will ultimately erupt in response to the motion of the hairpin vortex and in the process a secondary hairpin vortex will be created. The computer results agree with recent experimental investigations.

Hon, T.-L.↗
NASA NTRS1987

An embedded function approach for turbulent flow prediction

In conventional prediction methods for turbulent flow influence on surface properties, very small mesh sizes and considerable computational effort is required to adequately resolve the intense velocity and temperature profile variations that occur in the wall-layer region. In this study, an approach is described wherein an outer region numerical solution is smoothly matched to a set of embedded analytic profile functions in the near-wall region; these wall-layer profile functions having been derived through consideration of the coherent structure of the time-dependent near-wall flow provide analytic expressions for the mean velocity and enthalpy profiles in the wall layer. The concept is demonstrated through example applications to turbulent boundary-layer flows in two dimensions. The technique is shown to be very efficient and it is demonstrated that a reduction of approximately half the mesh points across the 2-D layer may be realized (as compared to conventional methods) with no degradation in accuracy.

Walker, J. D. A.↗
NASA NTRS1986

Wall layer models for the calculation of velocity and heat transfer in turbulent boundary layers

In the computation of turbulent boundary-layer flows and internal flows, a substantial amount of mesh points and computational effort is required to adequately resolve the intense temperature and velocity profile variations in the near wall region. In this study, analytical profile approximations are obtained for the mean velocity and temperature distribution in the wall layer; these profiles are based upon consideration of the observed coherent structure of the time-dependent wall-layer flow. The profile approximations are relatively simple analytical formulae which satisfy all the required compatibility conditions at the wall and the logarithmic behavior at the edge of the wall layer. The Reynolds analogy for heat transfer is not used in the present theory. A general method for utilizing the present wall-layer profile models in a prediction method is indicated.

Walker, J. D. A.↗
NASA NTRS1979

A prediction method for velocity and temperature profiles in a two-dimensional nominally steady turbulent boundary layer

This paper describes a recently developed boundary-layer prediction method for a variable property compressible flow, in which heat transfer takes place primarily by forced convection and for which the mainstream Mach number is small. The leading order terms, in asymptotic expansions for large Reynolds numbers, are obtained for the mean velocity and temperature distribution in both the inner and outer layer of the turbulent boundary layer. Closure in the inner layer is achieved using an analytical model for the mean profiles which is based on the observed coherent structure of the time-dependent inner layer flow. For the outer layer, simple eddy viscosity and conductivity models are developed without recourse to the Reynolds analogy. In the prediction method a numerical solution of the outer layer equations is matched to the analytical inner layer profiles as the computation procedes downstream. Calculations are presented for a range of adverse and favorable pressure gradient flows and the predicted results compare well with existing data.

Weigand, G. G.↗
NASA NTRS1979

An accurate method for two-point boundary value problems

A second-order method for solving two-point boundary value problems on a uniform mesh is presented where the local truncation error is obtained for use with the deferred correction process. In this simple finite difference method the tridiagonal nature of the classical method is preserved but the magnitude of each term in the truncation error is reduced by a factor of two. The method is applied to a number of linear and nonlinear problems and it is shown to produce more accurate results than either the classical method or the technique proposed by Keller (1969).

Walker, J. D. A.↗