Engineering topics

Venkatesan, T.

Publications and source records attributed to Venkatesan, T..

6 records

NASA NTRS2004

In situ Pulsed Laser Deposition of C-Axis Oriented MgB2 Films and Their Characterization

The recent discovery of an intermetallic superconductor MgB2 has renewed interest in the area of superconductivity not only because of fundamental understanding of superconductivity but also due to its potential applicability in devices such as thermal detectors. Considerable amount of research has been devoted to obtain MgB2 films by an all in situ growth technique. We have grown MgB2 thin films by an all in situ pulsed laser deposition process from pure B and Mg targets. Ultrathin layers of B and Mg were deposited in a multilayer configuration. Hundreds of such Mg-B bilayers with a capping Mg layer on the top were deposited on sapphire substrate. These depositions were done in high vacuum (approx. 10(exp -7) Torr) and at room temperature. After deposition, such a configuration was annealed at high temperature for a short time in a forming gas (4% H2 in Ar). The best films, obtained by this procedure, showed superconducting transition temperature approx. 30 K. These films have been characterized by x-ray diffraction, Rutherford Backscattering Spectrometry, AC susceptibility-, resistivity- (with and without magnetic field) and 1/f noise-measurements. The physical properties of these films will be presented and discussed.

Shinde, Sanjay↗

NASA NTRS1999

Room Temperature Thin Film Ba(x)Sr(1-x)TiO3 Ku-Band Coupled MicrostripPhase Shifters: Effects of Film Thickness, Doping, Annealing and Substrate Choice

We report on measurements taken on over twenty Ku-band coupled microstrip phase shifters (CMPS) using thin ferroelectric films of Ba(x)Sr(1-x)TiO3. This CMPS design is a recent innovation designed to take advantage of the high tunability and tolerate the high dielectric constant of ferroelectric films at Ku- and K-band frequencies. These devices are envisioned as a component in low-cost steerable beam phased area antennas, Comparisons are made between devices with differing film thickness, annealed vs unannealed, Mn-doped vs. undoped, and also substrates of LaAlO3 and MgO. A comparison between the CMPS structure and a CPW phase shifter was also made oil the same ferroelectric film.

VanKeuls, F. W.↗

NASA NTRS1994

Mechanisms of optical response in superconducting YBa2Cu3O7-delta thin films and grain-boundary weak links

The optical response of single grain-boundary weak links in superconducting YBCO thin films has been investigated. At temperatures well below the transition temperature, the grain boundary exhibits an optical response which is qualitatively different from transition edge response. Using a resistively shunted-junction model for the grain-boundary weak link, we find that the optical response below the transition temperature can be described by radiation induced thermal modulation of the critical currents of the weak links. The dependence on the bias current and the temperature distinguishes the weak-link optical response from the transition edge optical response. We discuss novel aspects of a potential radiation detector based on grain-boundary weak-link junctions.

Bhattacharya, S.↗

NASA NTRS1993

Optical response of an ultrathin film and a large-angle grain-boundary in superconducting YBa2Cu3O(7-delta)

We have investigated the optical response of epitaxial ultrathin (3 nm) YBa2Cu3O(7-delta) film on an NdGaO3 substrate and thin (50 nm) film of YBa2Cu3O(7-delta) on a bicrystal SrTiO3 substrate. While the current-voltage characteristics of the ultrathin film indicate a Kosterlitz-Thouless transition (associated with vortex-antivortex unbinding) at a temperature T(KT), we do not observe any optical response at or below T(KT). An enhanced optical response with nonbolometric characteristics was observed from the grain-boundary as compared to the bolometric optical response of the epitaxial film at the resistive transition. These results indicate that the grain-boundary weak links play a significant role in the enhanced optical response near Tc.

Bhattacharya, S.↗

NASA NTRS1991

Perspectives on high temperature superconducting electronics

The major challenges in making high temperature superconducting (HTSC) electronics viable are predominantly materials problems. Unlike their predecessors, the metal oxide-based superconductors are integratable with other advanced technologies such as opto-electronics and micro-electronics. The materials problems to be addressed relate to the epitaxial growth of high quality films, highly oriented films on non-lattice matched substrates, heterostructures with atomically sharp interfaces of junctions and other novel devices, and the processing of these films with negligible deterioration of the superconducting properties. These issues are illustrated with results based on films prepared in-situ by a pulsed laser deposition process. Films with zero-transition temperatures of 90 K and critical current densities of 5 x 10(exp 6) A/sq cm at 77 K have been prepared by this technique. Ultra-thin films, less than 100 A show T(sub c) is greater than 80 K, supporting the idea of two-dimensional transport in these materials. By the use of appropriate buffer layers, films with T(sub c) of 87 K and J(sub c) of 6 x 10(exp 4) A/sq cm were fabricated on silicon substrates. Submicron structures with J(sub c) is greater than 2 x 10(exp 7) at 10 K were fabricated. Results on nonlinear switching elements, IR detectors, and microwave studies will be briefly summarized.

Venkatesan, T.↗

NASA NTRS1990

Perspectives on high temperature superconducting electronics

The major challenges in making high temperature superconducting (HTSC) electronics viable are predominantly materials problems. Unlike their predecessors the metal oxide-based superconductors are integratable with other advanced technologies such as opto-electronics and micro-electronics. The materials problems to be addressed relate to the epitaxial growth of high quality films, highly oriented films on non-lattice matched substrates, heterostructures with atomically sharp interfaces of junctions and other novel devices, and the processing of these films with negligible deterioration of the superconducting properties. These issues are illustrated with results based on films prepared in-situ by a pulsed laser deposition process. Films with zero-transition temperatures of 90 K and critical current densities of 5 x 10(exp 6) A/sq cm at 77 K have been prepared by this technique. Ultra-thin films, less than 100 A show T(sub c) is greater than 80 K, supporting the idea of two-dimensional transport in these materials. By the use of appropriate buffer layers, films with T(sub c) of 87 K and J(sub c) of 6 x 10(exp 4) A/sq cm were fabricated on silicon substrates. Submicron structures with J(sub c) is greater than 2 x 10(exp 7) at 10 K were fabricated. Results on nonlinear switching elements, IR detectors, and microwave studies will be briefly summarized.

Venkatesan, T.↗