Engineering Papers⌕ Search

Engineering topics

Vatsa, Veer N.

Publications and source records attributed to Vatsa, Veer N..

49 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Development of a flexible and efficient multigrid-based multiblock flow solver

A multigrid-based numerical scheme for solving the Navier-Stokes and Euler equations on block-structured grids is presented for flows over complex aircraft configurations. Self-consistency checks are conducted to ascertain that the multiblock code reproduces previously known solutions from single-block codes by splitting a single-block grid into multiple blocks. The newly-developed multiblock code maintains multigrid performance of an equivalent single-block code.

Vatsa, Veer N.↗
NASA NTRS1993

A Comparison of the Predictive Capabilities of Several Turbulence Models using Upwind and Central-Difference Computer Codes

Four turbulence models are described and evaluated for transonic flows using the upwind code CFL3D and the central-difference code TLNS3D. In particular, the effects of recent modifications to the half-equation model of Johnson-King are explored in detail, and different versions of the model are compared. This model can obtain good results for both two-dimensional (2D) and three-dimensional (3D) separated flows. The one-equation models of Baldwin-Barth and Spalart-Allmaras perform well for separated airfoil flows, but can predict the shock too far forward at the outboard stations of a separated wing. The equilibrium model of Baldwin-Lomax predicts the shock location too far aft for both 2D and 3D separated flows, as expected. In general, all models perform well for attached or mildly separated flows.

Rumsey, Christopher L.↗
NASA NTRS1992

Evaluation of a multigrid-based Navier-Stokes solver for aerothermodynamic computations

A multigrid acceleration technique developed for solving the three-dimensional Navier-Stokes equations is used for computing high Mach number flows over configurations of practical interest. An explicit multistage Runge-Kutta type of time-stepping scheme is used as the basic algorithm. Solutions are presented for a spherically blunted cone at Mach 10 and a modified shuttle orbiter at Mach 6. The computed surface heat-transfer distributions are shown to compare favorably with the experimental data. Effect of grid-refinement on computed heat-transfer distributions is also examined to assess the numerical accuracy of the computed solutions. The rapid convergence rate associated with multigrid schemes in previous applications at transonic speeds is observed at the higher Mach number flows investigated here.

Vatsa, Veer N.↗
NASA NTRS1991

Extension of multigrid methodology to supersonic/hypersonic 3-D viscous flows

A multigrid acceleration technique developed for solving 3-D Navier-Stokes equations for subsonic/transonic flows was extended to supersonic/hypersonic flows. An explicit multistage Runge-Kutta type of time stepping scheme is used as the basic algorithm in conjunction with the multigrid scheme. Solutions were obtained for a blunt conical frustum at Mach 6 to demonstrate the applicability of the multigrid scheme to high speed flows. Computations were performed for a generic High Speed Civil Transport configuration designed to cruise at Mach 3. These solutions show both the efficiency and accuracy of the present scheme for computing high speed viscous flows over configurations of practical interest.

Vatsa, Veer N.↗
NASA NTRS1991

Viscous flow solutions for slender bodies of revolution at incidence

Flow over slender prolate spheroids at incidence is examined. The incidence angle is chosen high enough to cause streamwise separation of the flow in addition to crossflow separation generally observed at lower incidence angles. The freestream Mach number for the cases investigated here is subsonic, thus precluding the use of parabolized procedures. Laminar, transitional and turbulent flow cases are investigated.

Vatsa, Veer N.↗
NASA NTRS1990

Evaluation of transonic wall interference assessment and correction for semi-span wing data

A newly developed transonic wall interference assessment and correction (WIAC) code is applied to transonic semispan wing data taken in the Lockheed-Georgia Compressible Flow Wind Tunnel (CFWT), in order to evaluate previous WIAC results and corrections. A current state-of-the-art Navier-Stokes free-air code is used as an independent check. Results are presented for Wing C at the transonic edge of its test data matrix in the CFWT. The results demonstrate the effects of wall porosity, Mach number, and angle-of-attack on the transonic wall interference correction.

Garriz, Javier A.↗
NASA NTRS1990

Effect of artificial viscosity on three-dimensional flow solutions

Artificial viscosity is added either implicitly or explicitly in practically every numerical scheme for suppressing spurious oscillations in the solution of fluid dynamics equations. In the present central-difference scheme, artificial viscosity is added explicitly for suppressing high frequency oscillations and achieving good convergence properties. The amount of artificial viscosity added is controlled through the use of pre-selected coefficients. In the standard scheme, scalar coefficients based on the spectral radii of the Jacobian of convective fluxes are used. However, this can add too much viscosity to the slower waves. Hence, use the matrix-valued coefficients, which give appropriate viscosity for each wave component is suggested. With the matrix-valued coefficients, the central-difference scheme produces more accurate solutions on a given grid, particularly in the vicinity of shocks, while still maintaining good convergence properties.

Turkel, Eli↗
NASA NTRS1989

Recent advances in Runge-Kutta schemes for solving 3-D Navier-Stokes equations

A thin-layer Navier-Stokes has been developed for solving high Reynolds number, turbulent flows past aircraft components under transonic flow conditions. The computer code has been validated through data comparisons for flow past isolated wings, wing-body configurations, prolate spheroids and wings mounted inside wind-tunnels. The basic code employs an explicit Runge-Kutta time-stepping scheme to obtain steady state solution to the unsteady governing equations. Significant gain in the efficiency of the code has been obtained by implementing a multigrid acceleration technique to achieve steady-state solutions. The improved efficiency of the code has made it feasible to conduct grid-refinement and turbulence model studies in a reasonable amount of computer time. The non-equilibrium turbulence model of Johnson and King has been extended to three-dimensional flows and excellent agreement with pressure data has been obtained for transonic separated flow over a transport type of wing.

Vatsa, Veer N.↗
NASA NTRS1989

Development of an efficient multigrid code for 3-D Navier-Stokes equations

A multigrid acceleration technique has been developed to solve the three-dimensional Navier-Stokes equations efficiently. An explicit multistage Runge-Kutta type of time-stepping scheme is used as the basic algorithm in conjunction with the multigrid scheme. Solutions for flow over a finite wing have been obtained on extremely fine meshes in order to achieve grid convergence of the solutions. Present solutions indicate that the number of multigrid cycles required to achieve a given level of convergence does not increase with the number of mesh points employed, making it a very attractive scheme for fine meshes.

Vatsa, Veer N.↗
NASA NTRS1989

The 3-D Euler and Navier-Stokes calculations for aircraft components

An explicit multistage Runge-Kutta type of time-stepping scheme is used for solving transonic flow past a transport type wing/fuselage configuration. Solutions for both Euler and Navier-Stokes equations are obtained for quantitative assessment of boundary layer interaction effects. The viscous solutions are obtained on both a medium resolution grid of approximately 270,000 points and a find grid of 460,000 points to assess the effects of grid density on the solution. Computed pressure distributions are compared with the experimental data.

Vatsa, Veer N.↗
NASA NTRS1989

Prediction of separated transonic wing flows with a non-equilibrium algebraic model

A nonequilibrium algebraic turbulence model, which is based on the turbulence closure scheme of Johnson and King (1985), is proposed to predict separated transonic wing flows. The influence of history effects are modeled by solving a partial differential equation for the maximum total Reynolds shear stress, which is then used to scale the eddy viscosity of an algebraic model. The turbulence model is implemented in a three-dimensional, Reynolds-averaged Navier-Stokes code. Comparisons with experimental data are presented which show clearly that the nonequilibrium type of turbulence model is essential for accurate prediction of transonic separated flows.

Abid, Ridha↗