Calculation of the Heat Transfer Coefficient in the Outer Body for a Rotational Detonation
Unsteady heat transfer characterization on the combustion surfaces of Rotational Detonation Engines (RDE) is not well understood. It is generally thought that the complex nature of the unsteady, reacting, compressible fluid flow inside the combustion anulus of the RDE causes the convective heat transfer coefficient to be significantly higher than it is in other applications. Empirical models that have been used to analyze this strictly apply to steady flows where dimensionless groups can be employed. The reacting flow fields that are characteristic of RDEs are inherently compressible, three dimensional, unsteady, and turbulent, having properties that change by orders of magnitude throughout the flow field. They will therefore contain multiple length scales and time scales operating everywhere in the flow during all times. Because of this it is not likely that the RDE flow fields will lend themselves to explanation using simple dimensionless parameters. The dimensionless groups have meaning only in situations where length scales and time scales are singular and well defined. In spite of this it may be possible to get a relatively good idea of what the convection heat transfer coefficient is. In this work a numerical study is performed where the inside wall surface temperature distribution in the RDE outer body is systematically changed over a given range that would be characteristic of the start-up flows inside an RDE. For each case, temperature distributions inside the outer containment wall of the RDE was calculated and compared with experimental data. The closet match can then be used to directly calculate the convection heat transfer coefficient on the inside surface of the RDE.