Engineering PapersSearch

Engineering topics

Van Speybroeck, L.

Publications and source records attributed to Van Speybroeck, L..

Image analysis of the AXAF VETA-1 X-ray mirror

Initial core scan data of the VETA-1 X-ray mirror proved disappointing, showing considerable unpredicted image structure and poor measured FWHM. 2-D core scans were performed, providing important insight into the nature of the distortion. Image deconvolutions using a raytraced model PSF was performed successfully to reinforce our conclusion regarding the origin of the astigmatism. A mechanical correction was made to the optical structure, and the minor was tested successfully (FWHM 0.22 arcsec) as a result.

Freeman, M.

The X-ray reflectivity of the AXAF VETA-I optics

The study measures the X-ray reflectivity of the AXAF VETA-I optic and compares it with theoretical predictions. Measurements made at energies of 0.28, 0.9, 1.5, 2.1, and 2.3 keV are compared with predictions based on ray trace calculations. Results on the variation of the reflectivity with energy as well as the absolute value of the reflectivity are presented. A synchrotron reflectivity measurement with a high-energy resolution over the range 0.26 to 1.8 keV on a flat Zerodur sample is also reported. Evidence is found for contamination of the flat by a thin layer of carbon on the surface, and the possibility of alteration of the surface composition of the VETA-I mirror, perhaps by the polishing technique. The overall agreement between the measured and calculated effective area of VETA-I is between 2.6 and 10 percent. Measurements at individual energies deviate from the best-fitting calculation to 0.3 to 0.8 percent, averaging 0.6 percent at energies below the high energy cutoff of the mirror reflectivity, and are as high as 20.7 percent at the cutoff.

Kellogg, E.

Grazing incidence X-ray reflectivity - Studies for the AXAF observatory

The energy bandwidth and total throughput of a grazing incidence optics system is a strong function of the X-ray reflectivity of the surface coating. In support of the Advanced X-ray Astrophysics Facility (AXAF), studies are underway to evaluate and characterize the reflectivity of potential AXAF coatings. Here we report on results obtained for Au, Ir, and Ni coatings produced by electron-beam evaporation, evaporation with ion-assist, and sputtering. Effects of coating thickness and deposition angle have been evaluated at 6.4 and 8.1 keV; the highest reflectivities are those of the thinner, about 200 A vs about 700 A, coatings. While considerable variations exist, the best Ir samples have higher reflectivity than any of the Au coatings. Data results have been compared with models for theoretical reflectivity, particularly with regard to the effective density of the coatings. Independent measurements of the coating densities have been carried out for comparison with the reflectivity results.

Slane, P.

Correspondence between AXAF TMA X-ray performance and models based upon mechanical and visible light measurements

The AXAF Technology Mirror Assembly (TMA) was characterized prior to X-ray testing by properties measured mechanically or with visible light; these include alignment offsets, roundness and global-axial-slope errors, axial-figure errors with characteristic lengths greater than about five mm, and surface roughness with scale lengths between about 0.005 and 0.5 mm. The X-ray data of Schwartz et al. (1985) are compared with predictions based upon the mechanical and visible light measurements.

Van Speybroeck, L.

The X-ray morphology of Abell 1367

X-ray observations of the nearby cluster Abell 1367 were made with the Imaging Proportional Counter (IPC) and High Resolution Imager (HRI) aboard the Einstein Observatory. The IPC is used to study the diffuse cluster emission. With the HRI, eight point sources are detected above the diffuse cluster emission, three of which are apparently associated with cluster galaxies. In addition, the HRI observations have resolved 13 extended features with characteristic radii of order arcmin, eight of which are associated with cluster galaxies. These extended sources have luminosities of 1.5-6.5 x 10 to the 41st per (H0)50)-squared ergs per sec in the 0.5-4.5 keV band and constitute about 60% of the total cluster emission. The ways in which these hot galactic coronae can be maintained are discussed.

Bechtold, J.

The nuclear X-ray source in M81

X-ray observations of the M81 galaxy were taken by the high resolution imager and the monitor proportional counter aboard the Einstein observatory. The luminosity is about 1.7 X 10 to the 40th ergs/s. It is suggested that M81 probably has an active nucleus two orders of magnitude less luminous than any other well-established case. Any critical 'turn-on' luminosity is thus very low and approaches that of compact X-ray binary systems. The agreement of the alpha hydrogen/X-ray ratio of M81 suggests that the physics of the activity is not strongly different at these low luminosities from that in the normal range

Elvis, M.

Einstein imaging observations of clusters with a bimodal mass distribution

Einstein imaging observations of four X-ray clusters of galaxies characterized by a double X-ray surface brightness and thus mass distribution are presented. The clusters A98, A115, A1750 and SC 0627-54 were found to exhibit two enhancements in their X-ray surface brightness distributions in observations made with the Einstein Imaging Proportional Counter. Calculations of the probability that the clusters represent chance superpositions indicate that the double clusters are physically associated. The radial distributions of the components are inconsistent with those of single point sources, and have been used to derive cluster luminosities which are typical of rich clusters. Masses of the subclusters are also found to be typical of bound and virialized clusters with gas contributing 10%. Within the framework of the hierarchical theory of galactic clustering, the double clusters are suggested to represent an intermediate evolutionary stage before the merger of subclusters into a relaxed Coma-type cluster.

Forman, W.

The Einstein Observatory and future X-ray telescopes

A history of the events leading to the development and flight of the Einstein Observatory is given. The advantages of using grazing-incidence telescopes for solar and extrasolar X-ray astronomy is first discussed and followed by a description of the HEAO program. The Einstein Observatory marks a departure from the manner in which X-ray investigations are carried out, from individual experiments to the shared use of large facilities. The Observatory has achieved a sensitivity to point sources of 10 to the -14th erg/sq cm-sec in the 1-3 keV band, a flux 500 times smaller than previously detected and about 10 million times smaller than that of the first extrasolar source detected in 1962. The design philosophy of the Observatory entails three principles: (1) the unified scientific approach, (2) the establishment of spacecraft requirements at lowest acceptable levels that still allow operating flexibility, and (3) the idea of 'soft' rather than 'hard' failure. The mirror design, including the high resolution imager, the imaging proportional counter, and the solid-state and focal plane crystal spectrometers, is also given. An account of the struggle to gain acceptance by the scientific community and the funding agencies of the need for the Einstein Observatory mission is discussed. Finally, results of observations made by the Observatory are presented in detail, along with plans for future observation experiments.

Giacconi, R.

The S-054 X-ray telescope experiment on Skylab

A description of the S-054 X-ray telescope on Skylab is presented with a discussion of the experimental objectives, observing program, data reduction and analysis. Some results from the Skylab mission are given. The telescope photographically records high-resolution images of the solar corona in several broadband regions of the soft X-ray spectrum. It includes an objective grating used to study the line spectrum. The spatial resolution, sensitivity, dynamic range and time resolution of the instrument were chosen to survey a wide variety of solar phenomena. It embodies improvements in design, fabrication, and calibration techniques which were developed over a ten-year period. The observing program was devised to optimize the use of the instrument and to provide studies on a wide range of time scales. The data analysis program includes morphological studies and quantitative analysis using digitized images. A small sample of the data obtained in the mission is presented to demonstrate the type of information that is available and the kinds of results that can be obtained from it.

Vaiana, G. S.

High-resolution imaging X-ray detector

The paper describes an X-ray detector using microchannel plates as a photocathode surface and imaging photoelectron multiplier, and a crossed wire grid as a two-dimensional position-sensitive detector. The position resolution is 10 microns. The crossed wire grid consists of 100-micron-diam wires on 200-micron centers. Position sensing is accomplished by electronic interpolation to 1/20 of the wire spacing. The quantum efficiency of the microchannel plates varies from 29% at 0.28 keV to 5% at 3 keV. This detector will provide second-of-arc X-ray imaging in the focal plane of the 342.9-cm focal length grazing-incidence telescope being prepared for the HEAO-B observatory. By addition of suitable photocathodes, it can be used for single-photon imaging light detection in the UV, visible, and near-IR-ranges. In all cases, it gives a very low dark counting rate, allows timing of individual events to 1 microsec or less, and can handle counting rates up to 10,000 per sec.

Kellogg, E.