Engineering Papers⌕ Search

Engineering topics

Turner, Jim E.

Publications and source records attributed to Turner, Jim E..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2015

On the X-34 FASTRAC-Memorandums of Misunderstanding

Engineers at MSFC designed, developed, and tested propulsion systems that helped launch Saturn I, IB, and V boosters for the Apollo missions. After the Apollo program, Marshall was responsible for the design and development of the propulsion elements for the Shuttle launch vehicle, including the solid rocket boosters, external tank and main engines. Each of these systems offered new propulsion technological challenges that pushed engineers and administrators beyond Saturn. The technical challenges presented by the development of each of these propulsion systems helped to establish and sustain a culture of engineering conservatism and was often accompanied by a deep level of penetration into contractors that worked on these systems.

Hawkins, Lakiesha V.↗
NASA NTRS2001

Elimination of Intermediate-Frequency Combustion Instability in the Fastrac Engine Thrust Chamber

A series of tests were conducted to measure the combustion performance of the Fastrac engine thrust chamber. The thrust chamber exhibited benign, yet marginally unstable combustion. The marginally unstable combustion was characterized by chamber pressure oscillations with large amplitudes and a frequency that was too low to be identified as acoustic or high-frequency combustion instability and too high to be identified as chug or low-frequency combustion instability. The source of the buzz or intermediate-frequency combustion instability was traced to the fuel venturi whose violently noisy cavitation caused resonance in the feedline downstream. Combustion was stabilized by increasing the throat diameter of the fuel venturi such that the cavitation would occur more quietly.

Rocker, Marvin↗
NASA NTRS2000

Lightweight Chambers for Thrust Cell Applications

This is a viewgraph presentation which reviews the progress in the development of lightweight chambers for thrust cell applications. The objective of the program is to reduce thrust assembly weights to create lighter engines which will allow for an increase in the payload. Using new composite materials and fabrication technologies the team has constructed 7 different thrust cell demonstration units. The materials used in the demonstration units are reviewed.

Elam, Sandy↗
NASA NTRS2000

Flow Analysis of X-34 Main Propulsion System Feedlines

This viewgraph presentation reviews the flow analysis of the propulsion feedlines in the X-34. The objective of the analysis was to determine the flow development at the engine interface, and to predict the pressure drop in the feedline. The presentation shows the design of the feedlines, and the computational grids. It reviews the numerical method, which included solving the curvilinear coordinate transport equations. Line graphs review the computational fluid dynamic results. The results and conclusions are also presented.

Vu, Bruce↗
NASA NTRS2000

Status Report on the Penn State RBCC Test Program

The status of the RBCC ejector mode research program at Penn State is reviewed. Recent hardware modifications and measurement system improvements are discussed, including the motivation for these changes. Results from a series of tests with a single thruster configuration at a chamber pressure of 200 psia and with an area ratio 3.3 nozzle are presented. These results indicate that the primary (rocket exhaust) and secondary (entrained air) flow streams mix much more rapidly than a previous test series with an area ratio of 6.0 nozzle. Finally, the plans for a test series with a twin thruster configuration are discussed.

Cramer, J.↗