Engineering Papers⌕ Search

Engineering topics

Turner, G.

Publications and source records attributed to Turner, G..

Impact ionization in Al{sub x}Ga{sub 1−x}As{sub y}Sb{sub 1−y} avalanche photodiodes

Avalanche photodiodes (APDs) have been fabricated in order to determine the impact ionization coefficients of electrons (α) and holes (β) in Al{sub x}Ga{sub 1−x}As{sub y}Sb{sub 1−y} lattice matched to GaSb for three alloy compositions: (x = 0.40, y = 0.035), (x = 0.55, y = 0.045), and (x = 0. 65, y = 0.054). The impact ionization coefficients were calculated from photomultiplication measurements made on specially designed APDs, which allowed for both pure electron and pure hole injection in the same device. Photo-multiplication measurements were made at temperatures ranging from 77 K to 300 K for all three alloys. A quasi-physical model with an explicit temperature dependence was used to express the impact ionization coefficients as a function of electric-field strength and temperature. For all three alloys, it was found that α < β at any given temperature. In addition, the values of the impact ionization coefficients were found to decrease as the aluminum concentration of the AlGaAsSb alloy was increased. A value between 1.2 and 4.0 was found for β/α, which is dependent on temperature, alloy composition, and electric-field strength.

36 MATERIALS SCIENCE↗

Phase-controlled, heterodyne laser-induced transient grating measurements of thermal transport properties in opaque material

The methodology for a heterodyned laser-induced transient thermal grating technique for non-contact, non-destructive measurements of thermal transport in opaque material is presented here. Phase-controlled heterodyne detection allows us to isolate pure phase or amplitude transient grating signal contributions by varying the relative phase between reference and probe beams. The phase grating signal includes components associated with both transient reflectivity and surface displacement whereas the amplitude grating contribution is governed by transient reflectivity alone. By analyzing the latter with the two-dimensional thermal diffusion model, we extract the in-plane thermal diffusivity of the sample. Measurements on a 5 μm thick single crystal PbTe film yielded excellent agreement with the model over a range of grating periods from 1.6 to 2.8 μm. The measured thermal diffusivity of 1.3 × 10 -6 m 2 /s was found to be slightly lower than the bulk value.

36 MATERIALS SCIENCE↗

Oxygen isotopes implanted in the LDEF spacecraft

Secondary ion mass spectrometry was used to study oxygen implanted in the surface of copper from the Long Duration Exposure Facility (LDEF). Oxidation that occurred in orbit shows a characteristic oxygen isotope composition, depleted in O-18. The measured depletion is comparable to the predicted depletion (45 percent) based on a model of the gravitational separation of the oxygen isotopes. The anomalous oxygen was contained within 10nm of the surface. Tray E10 was calculated to have received 5.14 x 10(exp 21) atoms of oxygen cm(sup -2) during the LDEF mission and so there is sufficient anomalous implanted oxygen present in the surface to obtain a reliable isotopic profile.

Saxton, J. M.↗

Oxygen isotopes implanted in the LDEF spacecraft

Depth profiles of O-16 and O-18/O-16 were measured on stainless steel nuts and copper sheet (from a grounding strap) recovered from the leading edge of LDEF (Tray E10). The measurements were obtained by dynamic SIMS (secondary ion mass spectrometry) using a VG Isolab 54 ion microprobe. Plots of O-18/O-16 against time, show large depletions of up to a factor of 2 compared to the O-18/O-16 value at sea level. The O-16 current decreases by 2 orders of magnitude in the interior of the metal, and the corresponding profile of anomalous O-16 is strongly peaked in the outer few tens of nanometers of the surface. This depth scale is a tentative one based on estimated sputtering rates. Plots of O-18/O-16 against 1/O-16 should be linear if two isotopically distinct components, one of variable concentration (orbital component) and one of fixed concentration (normal oxygen), are mixed. Data to be presented at the meeting show departures from linearity which result from variability in the concentration of normal oxygen, but may also arise from the implantation of oxygen with a range of fractionation due to the decaying orbit of the LDEF, sputtering of the surface by atomic oxygen, and the different momenta of the two isotopes due to their equal velocities. The potential for using this method as a means of identifying exposure to low-Earth orbit, de-convoluting the effects of space exposure from terrestrial contamination, and using the implanted anomolous oxygen as a means of studying the atomic oxygen density and upper atmosphere temperature height profile will be discussed at the meeting.

Saxton, J. M.↗

NASA solar array flight experiment

The NASA large flexible solar array space shuttle flight experiment is described. The 32 x 4 m wing is deployed from the shuttle bay, and experiments in electrical output, multiple deployment, and structural dynamics are planned. Both 2 x 4 cm and 5.9 x 5.9 cm cell assemblies on the array blanket are evaluated. Safety/hazards provisions are described, including emergency jettison provisions. Ground testing and hardware fabrication are summarized.

Turner, G.↗

Some observations on the characteristics of low-cost silicon sheets

To meet the need for low cost silicon sheet material in the ERDA/JPL photovoltaics program, JPL has initiated a wide ranging technology development effort in crystal growth that includes several different technology thrusts. They range in scope from innovative ingot growth and multislice wafering, to shaped growth techniques, substrate-related processes and hot forming techniques. In this paper, some salient observations on materials resulting from these processes are reported. Included are multiblade wafering-induced damage studies, interface morphology studies on the heat exchanger cast silicon, some diffusion length measurements in thin silicon layers on ceramic substrates, and results on the equilibrium structure found in laser zone ribbon growth.

Digges, T. G., Jr.↗

Ar40-Ar39 systematics in rocks and separated minerals from Apollo 14.

The Ar40-Ar39 dating technique has been applied to separated minerals (plagioclase, pyroxene, quintessence and an 'ilmenite' concentrate), and whole rock samples of Apollo 14 rocks 14310 and 14073. Plagioclase shows the best gas retention characteristics, with no evidence of anomalous behavior and only a small amount of gas loss in the initial release. Ages determined from the plagioclase of 14310 and 14073 are (3.87 plus or minus 0.05) and (3.88 plus or minus 0.05) AE respectively. Low apparent ages at low release temperatures, which are frequently observed in whole rock Ar40-Ar39 experiments on lunar basalts, are shown to be principally due to gas loss in the high-K interstitial glass (quintessence) phase, confirming earlier suggestions. The decrease in apparent ages in the high-temperature release previously observed in several total rock samples of Apollo 14 basalts has been identified with the pyroxene. Plagioclase is also found to be the most suitable mineral for the determination of cosmic ray exposure ages, and exposure ages of 280 and 113 m.y. are found for 14310 and 14073, respectively, indicating that these rocks, which are very similar in many respects, have different exposure histories.

Turner, G.↗

Ar-40/Ar-39 ages and cosmic ray exposure ages of Apollo 14 samples.

We have used the Ar-40/Ar-39 dating technique on eight samples of Apollo 14 rocks (14053, 14310), breccia fragments (14321), and soil fragments (14001, 14167). The large basalt fragments give reasonable Ar-40/Ar-39 release patterns and yield well defined crystallization ages of 3.89-3.95 aeons. Correlation of the Ar-40/Ar-39 release patterns with Ar-39/Ar-37 patterns showed that the low temperature fractions with high radiogenic argon loss came from K-rich phases. A highly shocked sample and fragments included in the breccia yield complex release patterns with a low temperature peak. The total argon age of these fragments is 3.95 aeons. Cosmic ray exposure ages on these samples are obtained from the ratio of spallogenic Ar-38 to reactor induced Ar-37 and show a distinct grouping of low exposure ages of 26 m.y. correlated with Cone crater. Other samples have exposure ages of more than 260 m.y. and identify material with a more complex integrated cosmic age exposure history.

Turner, G.↗

Ar-40-Ar-39 ages from the lunar maria

Argon isotopes retention ages of crystalline lunar rocks 12002, 12051 and 12065 from lunar maria, using neutron activitation and stepwise heating experiments

Turner, G.↗