Engineering Papers⌕ Search

Engineering topics

Tsui, C. K.

Publications and source records attributed to Tsui, C. K..

8 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Dependence of divertor turbulence on plasma density and current in TCV

To reliably predict the distribution of heat and particle fluxes at the target plates of tokamaks, a comprehensive understanding of turbulence throughout the entire Scrape-Off-Layer (SOL) is imperative. This study examines divertor turbulence systematically across a broad parameter range on the TCV tokamak, including variations in magnetic field direction, plasma current I p ∈ [140,320] kA, edge safety factor q 95 ∈ [2.6,4.7] and Greenwald fraction f G ∈ [0.18,0.6]. The TCV X-point Gas Puff Imaging (GPI) system is used to measure 2D filament properties in the inner and outer divertor region. The fluctuation levels in the divertor are found to strongly increase with density (to 80% over most of the SOL) while remaining insensitive to I p . The previously identified divertor-localized filaments (DLF), located on the bad curvature side of the outer divertor leg, are found to be a common feature on TCV, while no filaments are observed in the PFR. DLFs are present over most of the parameter space and in both field directions. However, they are absent, or appear only closer to the target, for sufficiently large Λ div ≳ 10 or q 95 ≳ 3.7. Across both I p and f G scans, some clear trends with Λ div are found for divertor filament sizes and velocities, and with target fall-off lengths of density and heat flux profiles at the outer target. This study provides important experimental insights to turbulent transport in the divertor also for comparison with self-consistent, turbulence simulations and extrapolation to future reactor conditions.

cross-field transport↗
DOE OSTI2024

The effect of plasma shaping on high density H-mode SOL profiles and fluctuations in TCV

Abstract The impact of plasma shaping on the properties of high density H-mode scrape-off layer (SOL) profiles and transport at the outer midplane has been investigated on Tokamakà configuration variable. The experimental dataset has been acquired by evolving the upper triangularity while keeping the other parameters constant. The scan comprises δ u p values between 0.0 and 0.6, excluding negative triangularity scenarios. Within this study, a transition from type-I edge localised modes to the quasi-continuous exhaust regime takes place from low to high δ u p . The modification of the upstream SOL profiles has been assessed, in terms of separatrix quantities, within the α t turbulence control parameter theoretical framework (Eich et al 2020 Nucl. Fusion 60 056016). The target parallel heat load and the upstream near-SOL density profiles have been shown to broaden significantly for increasing α t . Correspondingly, in the far SOL a density shoulder formation is observed when moving from low to high δ u p . These behaviours have been correlated with an enhancement of the SOL fluctuation level, as registered by wall-mounted Langmuir probes as well as the thermal helium beam diagnostic. Specifically, both the background and the filamentary-induced fluctuating parts of the first wall ion saturation current signal are larger at higher δ u p , with filaments being ejected more frequently into the SOL. Comparison of two pulses at the extremes of the δ u p scan range, but with otherwise same input parameters, shows that the midplane neutral pressure does not change much during the H-mode phase of the discharge. This indicates that indirect effects of the change in geometry, linked to first wall recycling sources, should not play a significant role. The total core radiation increases at high δ u p , on account of a stronger plasma–wall interaction and resulting larger carbon impurity intake from the first wall. This is likely associated to the enhanced first wall fluctuations, as well as a smaller outer gap and the close-to-double-null magnetic topology at high shaping.

Stagni, A. (ORCID:0000000180841544)↗
DOE OSTI2022

Dependence of scrape-off layer profiles and turbulence on gas fuelling in high density H-mode regimes in TCV

A set of high density, highly shaped H-mode discharges has been performed in the TCV tokamak with the aim of assessing the effects of increasing divertor neutral recycling on the properties of upstream inter-ELM scrape-off layer (SOL) profiles and transport. An increase of divertor neutral pressure has been correlated with the evolution of separatrix properties and turbulence level. The latter has been quantified by means of the α t parameter introduced in (Eich 2020 Nucl. Fusion 60 056016), describing the contribution of resistive-interchange turbulence in the SOL relative to drift wave transport. The analysis reveals a general broadening of the upstream SOL profiles as α t increases, with the SOL power width measured by the vertical IR thermography system increasing significantly. In a similar way, the upstream density profile widens in the near SOL, whereas in the far SOL a density shoulder is observed to progressively form and increase in amplitude. This behaviour is associated with an enhancement of far SOL turbulent transport in the form of blob-filaments travelling radially faster across the far SOL and becoming bigger at higher α t . Finally, the detected filaments, evaluated from the fast reciprocating probe at the outer midplane, are determined to mostly belong to the resistive ballooning and resistive X-point regimes.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Evidence on the effects of main-chamber neutrals on density shoulder broadening

Evidence that density shoulder broadening is dependent on high main-chamber neutral density is presented. Shoulder broadening does not occur when the sources for main-chamber neutrals are minimized using divertor baffles and wide gaps to the first wall (~3× the density decay length). Removing the baffles or reducing the gap to the inner wall both act to increase the density shoulder amplitude in otherwise identical TCV discharges. Radial turbulent transport is correlated with shoulder amplitude.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗
DOE OSTI2022

Relevance of E × B drifts for particle and heat transport in divertors

Radial electric fields up to ~4 kV m –1 are observed in the boundary between the private flux region (PFR) and the scrape-off layer (SOL) driving E × B drifts between the inner and outer targets at speeds up to 2.8 km s –1 in the Tokamak à configuration variable divertor. The resulting E × B fluxes, located in a narrow region ($\Delta {\rho _\Psi } < 0.012$ in normalized radius or $\Delta $ R – R sep <4 mm mapped to the outer midplane) are equivalent to around 20% of the total heat and particle flux to the divertor targets (inner + outer). At the peak E r , the E × B poloidal transport is equivalent to parallel flows with M ∥ ~ 3. In the snowflake divertor with a second X-point in the outer SOL, the drifts in the PFR-SOL boundary were equivalent to around 30% of the total heat and particle flux to the divertor targets and cover a region ~50% wider than in the single null ($\Delta {\rho _\Psi }$ ~ 0.018, $\Delta $R – R sep ~ 6 mm). Furthermore, the location of the PFR-SOL boundary drift shifts radially in the E ∥ × B direction when reversing the toroidal field direction. Peaks in density and electron pressure have been identified near the primary X-point along with large gradients in density, temperature, and potential, the latter resulting in a local electric field ~2.7 kV m –1 which drives a drift (1.9 km s –1 ) upwards towards the closed flux surfaces. Floating potential (V f ) magnitudes up to 75 V (~2 kT e ) were measured, indicating that V f and parallel currents should not be neglected when estimating plasma potential.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2022

Suppression of first-wall interaction in negative triangularity plasmas on TCV

Magnetically confined fusion plasmas with negative triangularity (d) exhibit greater L-mode confinement than with positive d. Recent experiments in the TCV and DIII-D tokamaks have correlated the confinement improvement to a reduction of fluctuations within the plasma core. We report on fluctuation measurements in the scrape-off layer (SOL) for −0.61 < d < +0.64 in limited and diverted ohmic L-mode plasmas; these reveal a strong reduction in SOL fluctuation amplitudes at d < −0.25, and, surprisingly, an almost full suppression of plasma interaction with the main-chamber first-wall, which could have important implications for the prospects of using negative d plasmas as a reactor solution. An exploration of several physical mechanisms suggests that a reduced connection length—intrinsic to negative d plasmas—plays a critical role in the origin of this phenomenon.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2021

SOLPS-ITER validation with TCV L-mode discharges

This work presents a quantitative test of SOLPS-ITER simulations against tokamak a configuration variable (TCV) L-mode experiments. These simulations account for drifts, currents, kinetic neutrals, and carbon impurities providing the most complete edge transport simulations for TCV to date. The comparison is performed on nominally identical discharges carried out to assess the effectiveness of TCV’s divertor baffles in the framework of the European Plasma Exhaust program and employs numerous edge diagnostics providing a detailed code-experiment benchmark for TCV. The simulations show a qualitative consistency, but the quantitative differences remain, which are assessed herein. It is found that, for a given separatrix density, the simulations most notably yield a colder, and denser, divertor state with a higher divertor neutral pressure than measured.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗