Engineering Papers⌕ Search

Engineering topics

Trembly, Jason

Publications and source records attributed to Trembly, Jason.

9 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Quantifying the Temperature Dependence of the Multi-Species, Multi-Reaction Model: Part II. Estimation of Entropy Coefficient for Meso-Carbon Micro-Bead Graphite

In Part 1 of this paper, the temperature impact on the Multi-Species, Multi Reaction (MSMR) model was studied. This was accomplished by acquiring data from slow rate lithiation and delithiation of a meso-carbon micro-bead (MCMB) graphite. Through this analysis, the temperature impact on the total fraction of available host sites in a particular MSMR gallery (X j ), the impact on the reference potential (U$^o_j$), and the impact on the parameter detailing the deviation from Nernstian behavior (ω j ) was determined. Here, the intercalation material is discussed, compared to traditional methods of acquiring the entropy coefficient, and comparison is made to previous mathematical estimates. Some of the challenges in using temperature dependent constant rate charge and discharge data as compared to the potentiodynamic entropy coefficient calculation method are also discussed, and a recommendation for future applications is proposed.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Novel Modular Electrocatalytic Processing for Simultaneous Conversion of Carbon Dioxide and Wet Shale Gas into Valuable Products

This report examines solid oxide electrolyzer cell (SOEC) technology as an alternative process for the manufacture of carbon monoxide (CO) and the separation of ethane (C 2 H 6 ) from wet natural gas (WNG). SOEC cathodes for the electrochemical reduction of carbon dioxide (CO 2 ) to CO and SOEC anodes for the selective electrochemical oxidation of C 2 H 6 to ethylene (C 2 H 4 ) are described and presented. Lifecycle and techno-economic analyses (LCA and TEA) utilizing SOEC technology for the production of CO are also reported.

03 NATURAL GAS↗
DOE OSTI2023

Coal Plastic Composite Piping Infrastructure Components

This report examines the development and use of coal plastic composite materials for piping applications. Foam materials were developed at bench scale and evaluated according to ASTM specifications. Techno-economic analyses are also reported.

01 COAL, LIGNITE, AND PEAT↗
DOE OSTI2023

Formation of Amorphous Carbon Multi‐Walled Nanotubes from Random Initial Configurations

Amorphous carbon nanotubes (a‐CNT) with up to four walls and sizes ranging from 200 to 3200 atoms have been simulated, starting from initial random configurations and using the Gaussian Approximation Potential. The important variables (like density, height, and diameter) required to successfully simulate a‐CNTs were predicted with the machine learning random forest technique. The width of the a‐CNT models ranged between 0.55–2 nm with an average inter‐wall spacing of 0.31 nm. The topological defects in a‐CNTs were analyzed and new defect configurations were observed. The electronic density of states and localization in these phases were discussed and delocalized electrons in the π subspace were identified as an important factor for inter‐layer cohesion. Spatial projection of the electronic conductivity favors axial transport along connecting hexagons, while non‐hexagonal parts of the network either hinder or bifurcate the electronic transport. A vibrational density of states was calculated and is potentially an experimentally comparable fingerprint of the material. The appearance of a low‐frequency radial breathing mode was discussed and the thermal conductivity at 300 K was estimated using the Green‐Kubo formula.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗