Engineering topics

Tombrello, T. A.

Publications and source records attributed to Tombrello, T. A..

At least 37 records · Page 2

NASA NTRS1982

The sputtering of insulating materials by fast heavy ions

In this paper recent experimental results on sputtering of UF4 and H2O (ice) by fast heavy ions are reviewed. Measurements have been made of the dependence of the sputtering yield on the incident ion type, charge state, and energy. In the case of UF4, the energy spectra of neutral sputtered particles have been obtained as well. There is a clear dependence of the sputtering yield on the electronic part of the stopping power, and the yield is strongly affected by the charge state of the incident ion, which shows that in the near-surface region from which sputtered particles arise, the charge state of the incident ion has not reached equilibrium. The shape of the energy spectra observed for UF4 targets is that expected from a thermal distribution rather than that of the collision cascade form typical of ordinary sputtering. A model of the sputtering-track registration process that has arisen from these data is shown to provide a framework of understanding the close relationship of these observations to the 'plasma desorption' of marcromolecules.

Seiberling, L. E.↗

NASA NTRS1982

Retention of ion-implanted-xenon in olivine: Dependence on implantation dose

The diffusion of Xe in olivine, a major mineral in both meteorites and lunar samples, was studied. Xe ions were implanted at 200 keV into single-crystal synthetic-forsterite targets and the depth profiles were measured by alpha particle backscattering before and after annealing for 1 hour at temperatures up to 1500 C. The fraction of implanted Xe retained following annealing was strongly dependent on the implantation dose. Maximum retention of 100% occurred for an implantion dose of 3 x 10 to the 15th power Xe ions/sq cm. Retention was less at lower doses, with (approximately more than or = 50% loss at one hundred trillion Xe ions/sq cm. Taking the diffusion coefficient at this dose as a lower limit, the minimum activation energy necessary for Xe retention in a 10 micrometer layer for ten million years was calculated as a function of metamorphic temperature.

Melcher, C. L.↗

NASA NTRS1982

Sputtering of Al2O3 and LiNbO3 in the electronic stopping region

Because of recent interest in the role played by the thermal properties of materials that exhibit high energy sputtering, Al2O3 and LiNbO3 were sputtered with chlorine ions at energies between 3 MeV and 25 MeV. To detect the sputtered Al and Nb we employ thin carbon catcher foils, which are analyzed with Rutherford scattering in the forward direction. Al surface densities of 10 to the 14th/sq cm and Nb surface densities of 10 to the 13th/sq cm are easily measured. The sputtering yields for both Al2O3 and LiNbO3 increase rapidly with increasing chlorine energy, and the Al and Nb yields are both approximately 0.2 at 20 MeV. Tests for dose, beam current, and contamination effects will be discussed.

Qiu, Y.↗

NASA NTRS1982

Solar system sputtering

The sites and materials involved in solar system sputtering of planetary surfaces are reviewed, together with existing models for the processes of sputtering. Attention is given to the interaction of the solar wind with planetary atmospheres in terms of the role played by the solar wind in affecting the He-4 budget in the Venus atmosphere, and the erosion and differentiation of the Mars atmosphere by solar wind sputtering. The study is extended to the production of isotopic fractionation and anomalies in interplanetary grains by irradiation, and to erosion effects on planetary satellites with frozen volatile surfaces, such as with Io, Europa, and Ganymede. Further measurements are recommended of the molecular form of the ejected material, the yields and energy spectra of the sputtered products, the iosotopic fractionation sputtering causes, and the possibility of electronic sputtering enhancement with materials such as silicates.

Tombrello, T. A.↗

NASA NTRS1981

Ion-beam-enhanced adhesion in the electronic stopping region

The use of ion beams in the electronic stopping region to improve the adhesion of insulators to other materials is described. In particular, the bonding of Au films to Teflon, ferrite, and SiO2 was improved by bombarding them with He and Cl, respectively. Improvements in bonding were also observed for Au on glass, Au and Cu on sapphire, and Si3N4 on Si. The mechanism is apparently associated with sputtering and track forming processes occurring in the electronic stopping region. Some applications are discussed.

Griffith, J. E.↗

NASA NTRS1981

Possible isotopic fractionation effects in material sputtered from minerals

A model is presented which predicts isotope fractionation in material sputtered from mineral surfaces. According to the model, the fractionation is a function of the fractional abundances of each isotope, the low-energy collision cross sections and the atomic masses, and the fractionation pattern can be nonlinear. Calculations are illustrated for all sets of isotopes in the minerals perovskite, anorthite, akermanite, enstatite and troilite, and it is found that while O is always positively fractionated, with heavier isotopes sputtered preferentially, heavier elements are generally negatively fractionated. It is noted that the model may be tested by experiments on a system such as CaF2, CaI2, in which the Ca sputtered from CaF2 is predicted to be strongly fractionated in a negative sense and that sputtered from CaI2 is predicted to be strongly fractionated in a positive sense.

Haff, P. K.↗

NASA NTRS1980

A thermalized ion explosion model for high energy sputtering and track registration

A velocity spectrum of neutral sputtered particles as well as a low resolution mass spectrum of sputtered molecular ions was measured for 4.74 MeV F-19(+2) incident of UF4. The velocity spectrum is dramatically different from spectra taken with low energy (keV) bombarding ions, and is shown to be consistent with a hot plasma of atoms in thermal equilibrium inside the target. A thermalized ion explosion model is proposed for high energy sputtering which is expected to describe track formation in dielectric materials. The model is shown to be consistent with the observed total sputtering yield and the dependence of the yield on the primary ionization rate of the incident ion.

Seiberling, L. E.↗

NASA NTRS1980

Method and means for helium/hydrogen ratio measurement by alpha scattering

An apparatus for determining helium to hydrogen ratios in a gaseous sample is presented. The sample is bombarded with alpha particles created by a self contained radioactive source and scattering products falling within a predetermined forward scattering angular range impact a detector assembly. Two detectors are mounted in tandem, the first completely blocking the second with respect to incident scattering products. Alpha particle/hydrogen or alpha particle/helium collisions are identified by whether scattering product impacts occur simultaneously in both detectors or only in the first detector. Relative magnitudes of the two pulses can be used to further discriminate against other effects such as noise and cosmic ray events.

Whitehead, A. B.↗

NASA NTRS1980

Possible isotopic fractionation effects in sputtered minerals

A model which makes definite predictions for the fractionation of isotopes in sputtered material is discussed. The fractionation patterns are nonlinear, and the pattern for a particular set of isotopes depends on the chemical matrix within which those isotopes are contained. Calculations are presented for all nonmonoisotopic elements contained in the minerals perovskite, anorthite, ackermanite, enstatite, and troilite. All isotopes are fractionated at the level of approximately 4-6 deg/o per atomic mass unit. Oxygen is always positively fractionated (heavier isotopes sputtered preferentially), and heavier elements are generally negatively fractioned (light isotopes sputtered preferentially). The value of Delta (O-18:O-16) is always less by about 1.8 deg/o than a linear extrapolation based upon the calculated delta (O-17:O-16) value would suggest. The phenomenon of both negative and positive fractionation patterns from a single target mineral are used to make an experimental test of the proposed model.

Haff, P. K.↗

NASA NTRS1980

A thermalized ion explosion model for high energy sputtering and track registration

Explore the source record for details and available documents.

Seiberling, L. E.↗

NASA NTRS1980

Solar wind sputtering effects in the atmospheres of Mars and Venus

It is found through an investigation, combining Monte Carlo simulations and analytical techniques, of the direct collisional interaction of an energetic particle flux with the neutral components of a planetary atmosphere, that solar wind sputtering could provide an important exospheric mass sink on both Mars and Venus under appropriate conditions. The computed rates of helium loss in the Venusian atmosphere and of carbon, nitrogen and oxygen in the Martian atmosphere imply that sputtering would have a significant effect on the noble gas budget of Venus and dominate the chemical and photochemical loss processes of Mars. Because of diffusive separation of lighter elements and isotopes, and because the gravitational binding energy is proportional to the mass, the erosion process preferentially removes the lighter components of the atmosphere. Solar wind sputtering could therefore compete with other erosion mechanisms in generating substantial fractionation effects.

Watson, C. C.↗

NASA NTRS1979

Ion-beam analysis of meteoritic and lunar samples

Charged particle-induced nuclear reactions were used in the following problems: the determination of elemental abundances of boron and fluorine in carbonaceous chondritic meteorites; the identification of products of lunar vulcanism; and the study of solar wind-implanted atoms in lunar materials. The technique was seen as an important supplement to other methods of elemental and isotopic analysis. This was especially true for cases involving light elements at very low concentrations or where high resolution depth distribution information was needed in non-destructive analysis.

Tombrello, T. A.↗

NASA NTRS1979

Surface sticking probabilities for sputtered atoms of Nb-93 and Rh-103

The capture coefficient probabilities for sputtered atoms of Nb-93 and Rh-103 incident on Al2O3 surfaces were measured using the backscattering of MeV heavy ions. In the circumstance where the collecting surface is thickly covered, the sticking probabilities integrated over the energy distribution of sputtered atoms are 0.97 plus or minus 0.01 for Nb-93 and 0.95 plus or minus 0.01 for Rh-103 respectively. In the limit of negligible areal coverage of the collector, the accuracy is less; in this case the sticking probabilities are 0.97 + 0.03 or -0.08 and 0.95 + 0.05 or -0.08.

Weller, M. R.↗

NASA NTRS1979

Ion erosion on the Galilean satellites of Jupiter

Several different models of ion-induced erosion of both the rocky and icy Galilean satellites are considered. The conclusion is that erasure of surface relief via this mechanism is likely to occur at a rate not exceeding about 100 m per billion years, and therefore is not of global topographic significance. Another effect of ion bombardment is the possible growth of a thin mineral armor on the surfaces of the icy satellites. A volume concentration of 0.1% of 1 micron sized mineral grains can lead to 50% armoring of the surface on time scales ranging from thousands to millions of years.

Haff, P. K.↗

NASA NTRS1978

Solar-wind sputtering of the Martian atmosphere

The role of solar-wind sputtering in causing atmospheric mass loss from Mars is discussed. The atmospheric mass loss is studied by analogy to models of sputtering of solid surfaces and by use of empirical data for the lunar surface. Results show that Martian atmospheric mass loss, when integrated over the course of 4 times 10 to the ninth power years, amounts to 3.1 times 10 to the 41st power CO2 molecules. Preferential loss of light elements and isotopes by sputtering is also considered.

Haff, P. K.↗

NASA NTRS1978

Sputtering of uranium

Results are presented for an experimental study of the sputtering of U-235 atoms from foil targets by hydrogen, helium, and argon ions, which was performed by observing tracks produced in mica by fission fragments following thermal-neutron-induced fission. The technique used allowed measurements of uranium sputtering yields of less than 0.0001 atom/ion as well as yields involving the removal of less than 0.01 monolayer of the uranium target surface. The results reported include measurements of the sputtering yields for 40-120-keV protons, 40-120-keV He-4(+) ions, and 40- and 80-keV Ar-40(+) ions, the mass distribution of chunks emitted during sputtering by the protons and 80-keV Ar-40(+) ions, the total chunk yield during He-4(+) sputtering, and some limited data on molecular sputtering by H2(+) and H3(+). The angular distribution of the sputtered uranium is discussed, and the yields obtained are compared with the predictions of collision cascade theory.

Gregg, R.↗

NASA NTRS1978

Energy spectrum of sputtered uranium - A new technique

The fission track technique for detecting U-235 has been used in conjunction with a mechanical time-of-flight spectrometer in order to measure the energy spectrum in the region 1 eV to 1 keV of material sputtered from a 93% enriched U-235 foil by 80 keV Ar-40(+) ions. The spectrum was found to exhibit a peak in the region 2-4 eV and to decrease approximately as E exp -1.77 for E not less than 100 eV. The design, construction and resolution of the mechanical spectrometer are discussed and comparisons are made between the data and the predictions of the random collision cascade model of sputtering.

Weller, R. A.↗

NASA NTRS1978

Direct measurement of surface carbon concentrations for lunar soil breccias

A nuclear reaction depth profiling technique previously described by Filleux et al. (1977) has been used to measure the depth distribution of C on grain surfaces for Apollo 11, 15, 16 and 17 soil breccias. The surface C concentration of all samples studied lies between 2 and 8 times 10 to the 15th atoms per sq cm, showing no correlation with the volume C, which varies over an order of magnitude. If the observed variation represents the presence of unexposed grains on the surfaces studied, these results indicate a steady state surface C concentration of 5 to 10 times 10 to the 15th atoms per sq cm, accumulated over a time scale short compared with that required for the formation of volume-related C and with the mean lifetime of grains at the lunar surface. About one-third to one-half of the total C in lunar soil seems to be surface-correlated.

Filleux, C.↗