Engineering Papers⌕ Search

Engineering topics

Tiwari, S. N.

Publications and source records attributed to Tiwari, S. N..

At least 109 records · Page 6
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

A parabolized Navier-Stokes algorithm for separated supersonic internal flows

A stable global-iteration procedure is applied to a fully implicit noniterative parabolized Navier-Stokes algorithm to improve the solutions of the single-sweep method as well as to resolve small separation bubbles due to shock-wave/boundary-layer interactions. A modified form of the FLARE approximation is employed in the separated regions and some requirements for stable iterations are discussed. The results of the global-iteration scheme for two test cases of supersonic internal flows are compared against the results of the single-sweep method as well as the results of the full Navier-Stokes solver.

Chitsomboon, T.↗
NASA NTRS1985

Studies on the interference of wings and propeller slipstreams

The small disturbance potential flow theory is applied to determine the lift of an airfoil in a nonuniform parallel stream. The given stream is replaced by an equivalent stream with a certain number of velocity discontinuities, and the influence of these discontinuities is obtained by the method of images. Next, this method is extended to the problem of an airfoil in a nonuniform stream of smooth velocity profile. This model allows perturbation velocity potential in a rotational undisturbed stream. A comparison of these results with numerical solutions of Euler equations indicates that, although approximate, the present method provides useful information about the interaction problem while avoiding the need to solve the Euler equations.

Prabhu, R. K.↗
NASA NTRS1985

Numerical solutions of 3-dimensional Navier-Stokes equations for closed bluff-bodies

The Navier-Stokes equations are solved numerically. These equations are unsteady, compressible, viscous, and three-dimensional without neglecting any terms. The time dependency of the governing equations allows the solution to progress naturally for an arbitrary initial guess to an asymptotic steady state, if one exists. The equations are transformed from physical coordinates to the computational coordinates, allowing the solution of the governing equations in a rectangular parallelepiped domain. The equations are solved by the MacCormack time-split technique which is vectorized and programmed to run on the CDc VPS 32 computer. The codes are written in 32-bit (half word) FORTRAN, which provides an approximate factor of two decreasing in computational time and doubles the memory size compared to the 54-bit word size.

Abolhassani, J. S.↗
NASA NTRS1985

Computerized data reduction techniques for nadir viewing remote sensors

Computer resources have been developed for the analysis and reduction of MAPS experimental data from the OSTA-1 payload. The MAPS Research Project is concerned with the measurement of the global distribution of mid-tropospheric carbon monoxide. The measurement technique for the MAPS instrument is based on non-dispersive gas filter radiometer operating in the nadir viewing mode. The MAPS experiment has two passive remote sensing instruments, the prototype instrument which is used to measure tropospheric air pollution from aircraft platforms and the third generation (OSTA) instrument which is used to measure carbon monoxide in the mid and upper troposphere from space platforms. Extensive effort was also expended in support of the MAPS/OSTA-3 shuttle flight. Specific capabilities and resources developed are discussed.

Tiwari, S. N.↗
NASA NTRS1985

An asymptotic theory for the interference of large aspect ratio swept wings and multiple propeller slipstreams

This paper presents an asymptotic method for the analysis of the interference of multiple tractor propeller slipstream with large aspect ratio swept wings. It is assumed that the height of the slipstream is of the order of the wing chord and its spanwise extent is of the order of the wing span. Three different flow regions are identified by employing different stretching transformations. Asymptotic expansions are made in each of the three regions, using the chord to span ratio as the small expansion parameter. The details of the nonuniform flow in the slipstream enter into the wing sectional analysis. In the outer limit, the wing shrinks to a swept lifting line, and the slipstream reduces to a thin sheet of jet carrying the momentum gain from the propeller. The curvature of this jet sheet results in a pressure difference which is represented by a vortex sheet. The governing equations are solved by discretization. Several examples are considered for which experimental data are available. Comparison of the present results with the experimental data as well as other numerical solutions showed generally good agreement.

Prabhu, R. K.↗
NASA NTRS1984

A second-order accurate parabolized Navier-Stokes algorithm for internal flows

A parabolized implicit Navier-Stokes algorithm which is of second-order accuracy in both the cross flow and marching directions is presented. The algorithm is used to analyze three model supersonic flow problems (the flow over a 10-degree edge). The results are found to be in good agreement with the results of other techniques available in the literature.

Chitsomboon, T.↗
NASA NTRS1984

Implementation of uniform perturbation method for potential flow past axisymmetric and two-dimensional bodies

The aerodynamic characteristics of potential flow past an axisymmetric slender body and a thin airfoil are calculated using a uniform perturbation analysis method. The method is based on the superposition of potentials of point singularities distributed inside the body. The strength distribution satisfies a linear integral equation by enforcing the flow tangency condition on the surface of the body. The complete uniform asymptotic expansion of its solution is obtained with respect to the slenderness ratio by modifying and adapting an existing technique. Results calculated by the perturbation analysis method are compared with the existing surface singularity panel method and some available analytical solutions for a number of cases under identical conditions. From these comparisons, it is found that the perturbation analysis method can provide quite accurate results for bodies with small slenderness ratio. The present method is much simpler and requires less memory and computation time than existing surface singularity panel methods of comparable accuracy.

Wong, T. C.↗
NASA NTRS1984

Convective and radiative heating of a Saturn entry probe

The extent of convective and radiative heating for a Saturn entry probe is investigated in the absence and presence of ablation mass injection. The flow in the shock layer is assumed to be axisymmetric, viscous and in local thermodynamic equilibrium. The importance of chemical nonequilibrium effects for both the radiative and convective nonblowing surface heating rates is demonstrated for prescribed entry conditions. Results indicate that the nonequilibrium chemistry can significantly influence the rate of radiative heating to the entry probes. With coupled carbon-phenolic ablation injection, the convective heating rates are reduced substantially. Turbulence has little effect on radiative heating but it increases the convective heating considerably.

Tiwari, S. N.↗
NASA NTRS1984

Accurate evaluation of homogenous and nonhomogeneous gas emissivities

Spectral transmittance and total band adsorptance of selected infrared bands of carbon dioxide and water vapor are calculated by using the line-by-line and quasi-random band models and these are compared with available experimental results to establish the validity of the quasi-random band model. Various wide-band model correlations are employed to calculate the total band absorptance and total emissivity of these two gases under homogeneous and nonhomogeneous conditions. These results are compared with available experimental results under identical conditions. From these comparisons, it is found that the quasi-random band model can provide quite accurate results and is quite suitable for most atmospheric applications.

Tiwari, S. N.↗
NASA NTRS1983

Interaction of two-dimensional transverse jet with a supersonic mainstream

The interaction of a two dimensional sonic jet injected transversely into a confined main flow was studied. The main flow consisted of air at a Mach number of 2.9. The effects of varying the jet parameters on the flow field were examined using surface pressure and composition data. Also, the downstream flow field was examined using static pressure, pitot pressure, and composition profile data. The jet parameters varied were gapwidth, jet static pressure, and injectant species of either helium or nitrogen. The values of the jet parameters used were 0.039, 0.056, and 0.109 cm for the gapwidth and 5, 10, and 20 for the jet to mainstream static pressure ratios. The features of the flow field produced by the mixing and interaction of the jet with the mainstream were related to the jet momentum. The data were used to demonstrate the validity of an existing two dimensional elliptic flow code.

Kraemer, G. O.↗
NASA NTRS1983

Analysis of longwave radiation for the Earth-atmosphere system

Accurate radiative transfer models are used to determine the upwelling atmospheric radiance and net radiative flux in the entire longwave spectral range. The validity of the quasi-random band model is established by comparing the results of this model with those of line-by-line formulations and with available theoretical and experimental results. Existing radiative transfer models and computer codes are modified to include various surface and atmospheric effects (surface reflection, nonequilibrium radiation, and cloud effects). The program is used to evaluate the radiative flux in clear atmosphere, provide sensitivity analysis of upwelling radiance in the presence of clouds, and determine the effects of various climatological parameters on the upwelling radiation and anisotropic function. Homogeneous and nonhomogeneous gas emissivities can also be evaluated under different conditions.

Tiwari, S. N.↗
NASA NTRS1983

A modified lifting line theory for wing-propeller interference

An inviscid incompressible model for the interaction of a wing with a single propeller slipstream is presented. The model allows the perturbation quantities to be potential even though the undisturbed flow is rotational. The governing equations for the spanwise lift distribution are derived and a simple method of solving these is indicated. Spanwise lift and induced drag distribution for two cases are computed.

Prabhu, R. K.↗
NASA NTRS1983

Linearized potential solution for an airfoil in nonuniform parallel streams

A small perturbation potential flow theory is applied to the problem of determining the chordwise pressure distribution, lift and pitching moment of a thin airfoil in the middle of five parallel streams. This theory is then extended to the case of an undisturbed stream having a given smooth velocity profile. Two typical examples are considered and the results obtained are compared with available solutions of Euler's equations. The agreement between these two results is not quite satisfactory. Possible reasons for the differences are indicated.

Prabhu, R. K.↗
NASA NTRS1983

Application of the method of lines for solutions of the Navier-Stokes equations using a nonuniform grid distribution

The feasibility of the method of lines for solutions of physical problems requiring nonuniform grid distributions is investigated. To attain this, it is also necessary to investigate the stiffness characteristics of the pertinent equations. For specific applications, the governing equations considered are those for viscous, incompressible, two dimensional and axisymmetric flows. These equations are transformed from the physical domain having a variable mesh to a computational domain with a uniform mesh. The two governing partial differential equations are the vorticity and stream function equations. The method of lines is used to solve the vorticity equation and the successive over relaxation technique is used to solve the stream function equation. The method is applied to three laminar flow problems: the flow in ducts, curved-wall diffusers, and a driven cavity. Results obtained for different flow conditions are in good agreement with available analytical and numerical solutions. The viability and validity of the method of lines are demonstrated by its application to Navier-Stokes equations in the physical domain having a variable mesh.

Abolhassani, J. S.↗
NASA NTRS1983

Infrared limb-darkening effects for the earth-atmosphere system

An infrared radiative transfer model has been developed for evaluating anisotropic functions in the longwave region (5-50 microns) due to limb-darkening effects in the earth's atmosphere. An accurate narrow-band model of absorption has been used for computing transmission functions of the atmosphere. Absorption due to all major and minor atmospheric constituents has been taken into account including the continuum absorption due to water vapor. Anisotropic functions have been calculated for several latitudinal and seasonal climatological-average model atmospheres. The effects of the variability of various meteorological parameters, e.g. surface temperature, surface relative humidity, and cloud-top height have been examined. It has been found that the variability of cloud parameters has the largest effect on the infrared anisotropic functions.

Gupta, S. K.↗
NASA NTRS1982

Analysis of the Scramjet inlet flow field using two-dimensional Navier-Stokes equations

A computer code was developed to solve the full two dimensional Navier-Stokes equations in a scramjet inlet. The analysis uses a numerical coordinate transformation which generates a set of boundary-fitted curvilinear coordinates. The explicit finite difference algorithm of MacCormack is used to solve the governing equations. A two-layer eddy viscosity model is used for the turbulent flow. The code can analyze both inviscid and viscous flows with multiple struts in the flow field. Detailed results are presented for two model problems and two scramjet inlets with one and two struts. The application of the two dimensional analysis in the preliminary design of the actual scramjet inlet is briefly discussed.

Kumar, A.↗