Engineering Papers⌕ Search

Engineering topics

Tischler, M. B.

Publications and source records attributed to Tischler, M. B..

25 records · Page 2

Helistat simulation studies

An analysis of the flight dynamics and piloted control characteristics of the Helistat, a quadrotor heavy-lift airship, was completed using the HYBRDS airship simulation facility. The analysis covered the full operating flight envelope, including likely ranges of altitude, airspeed, sideslip, and loading variations. Particular areas of study were performance, trim, power requirements, linearized dynamics, handling qualities, and mooring operations. The key assumptions were: a rigid vehicle, no control system dynamics, fixed rotor and propeller RPM, and no ballonet dynamics. The nominal cruise speed for the H34 engines operating at 1275 HP was found to be 40-50 kts, depending on the loading condition. The maximum payload capability was calculated as 45,000 lbs for sea level-based operations. The crosswind capability in hover is 5-10 kts depending on the loading conditions, but this requires excessive roll angle due to the roll-to-translate control gearing. Sideslip angles of 110-135 degrees (wind from aft quarters) are critical for directional trim and stability, and should be avoided.

Tischler, M. B.↗

The effects of atmospheric turbulence on a quadrotor heavy lift airship

The response of a quadrotor heavy lift airship to atmospheric turbulence is evaluated using a four-point input model. Results show interaction between gust inputs and the characteristic modes of the vehicle's response. Example loop closures demonstrate tradeoffs between response regulation and structural loads. Vehicle responses to a tuned discrete wave front compare favorably with the linear results and illustrate characteristic HLA motion.

Tischler, M. B.↗

Simulation of Heavy Lift Airship dynamics over large ranges of incidence and speed

A nonlinear, multibody, six-degrees-of-freedom digital simulation has been developed to study generic Heavy Lift Airship (HLA) dynamics and control. The basic aerodynamic functions developed to model the hull, tail, and rotor loads continuously over all incidence ranges are reviewed and applied to a Quadrotor HLA with a low fineness ratio hull and a small vee-tail. Trim calculations for a test vehicle suggest control power deficiencies in crosswind stationkeeping for the unloaded vehicle. Gust responses show the importance of correctly calculating loads due to accelerated relative motion of air and hull. Numerically linearized dynamics for the test vehicle show the existence of a divergent yaw mode, and an oscillatory pitch mode whose stability characteristics are sensitive to flight speed. A considerable improvement in the vehicle's stability and response results from a simple multi-axis closed-loop control system operating on the rotors and propeller blades.

Tischler, M. B.↗

Determination of the spin and recovery characteristics of a typical low-wing general aviation design

The equilibrium spin technique implemented in a graphical form for obtaining spin and recovery characteristics from rotary balance data is outlined. Results of its application to recent rotary balance tests of the NASA Low-Wing General Aviation Aircraft are discussed. The present results, which are an extension of previously published findings, indicate the ability of the equilibrium method to accurately evaluate spin modes and recovery control effectiveness. A comparison of the calculated results with available spin tunnel and full scale findings is presented. The technique is suitable for preliminary design applications as determined from the available results and data base requirements. A full discussion of implementation considerations and a summary of the results obtained from this method to date are presented.

Tischler, M. B.↗

A dynamic analysis of the motion of a low-wing general aviation aircraft about its calculated equilibrium flat spin mode

The properties of the flat spin mode of a general aviation configuration have been studied through analysis of rotary balance data, numerical simulation, and analytical study of the equilibrium state. The equilibrium state is predicted well from rotary balance data. The variations of yawing moment and pitching moment as functions of sideslip have been shown to be of great importance in obtaining accurate modeling. These dependencies are not presently available with sufficient accuracy from previous tests or theories. The stability of the flat spin mode has been examined extensively using numerical linearization, classical perturbation methods, and reduced order modeling. The stability exhibited by the time histories and the eigenvalue analyses is shown to be strongly dependent on certain static cross derivatives and more so on the dynamic derivatives. Explicit stability criteria are obtained from the reduced order models.

Tischler, M. B.↗

Generic multi-body formulation of heavy lift airship equations of motion

This paper describes the formulation of a comprehensive set of equations which describe the dynamic behavior of a generic heavy lift airship (HLA). They are being used in a digital computer simulation to investigate the response dynamics and flying qualities of HLAs operating with various payloads in a variety of operational environments. A key feature is the separate treatment of each component body making up the HLA. This allows the analyst to vary the configuration (e.g., number of lift-propulsion units, presence or absence of slung payload, etc.) without rewriting the equations. It further provides measures of key structural and control loads acting on the HLA and eases the task of modeling wind disturbances.

Ringland, R. F.↗

Application of the equilibrium spin technique to a typical low-wing general aviation design

A graphical implementation of the equilibrium technique for obtaining spin modes from rotary balance data is presented. Using this technique, spin modes were computed for the NASA Low-Wing General Aviation Aircraft. The computed angles of attack are within 10 degrees of the NASA spin tunnel results. The method also provides information on the dynamic nature of spin modes. This technique offers the capability of providing a great deal of information on spin modes and recovery, using data from a single experimental installation. Such a technique could be utilized in the preliminary design phase in order to provide basic information on aircraft spin and recovery characteristics. Results, advantages and limitations of the application of this technique are discussed.

Tischler, M. B.↗