Engineering topics
Publications and source records attributed to Teuber, D..
Various perturbations which occurred during the operation of a PDS 2020 GM microdensitometer are reviewed. The effects of elevated temperature, vibration, transient electrical noise, and photometric perturbations are briefly discussed. Sample astronomical results from the PDS 2020 GM unit are presented.
In this paper a quantitative evaluation of the shear in the magnetic field along the neutral line in an active region during an epoch of flare activity is presented. Shear is defined as the angular difference in the photosphere between the potential magnetic field, which fits the boundary conditions imposed by the observed line-of-sight field, and the observed magnetic field. For the active region studied, this angular difference (shear) is non-uniform along the neutral line with maxima occurring at the locations of repeated flare onsets. It is suggested that continued magnetic evolution causes the field's maximum shear to exceed a critical value of shear, resulting in a flare around the site of maximum shear. Evidently, the field at the site of the flare must relax to a state of shear somewhat below the critical value (but still far from potential), with subsequent evolution returning the field to the critical threshold. This inference is drawn because several flares occured at sites of maximum photospheric shear which were persistent in location.
The results of a Solar Maximum Mission (SMM) guest investigation to determine the vertical gradients of sunspot magnetic fields for the first time from coordinated observations of photospheric and transition-region fields are described. Descriptions are given of both the photospheric vector field of a sunspot, derived from observations using the NASA Marshall Space Flight Center vector magnetograph, and of the line-of-sight component in the transition region, obtained from the SMM Ultraviolet Spectrometer and Polarimeter instrument. On the basis of these data, vertical gradients of the line-of-sight magnetic field component are calculated using three methods. It is found that the vertical gradient of Bz is lower than values from previous studies and that the transition-region field occurs at a height of approximately 4000-6000 km above the photosphere.
Photospheric line-of-sight and transverse-magnetic-field data obtained, with a vector magnetograph system for an isolated sunspot are described. A study of the linear polarization patterns and of the calculated transverse field lines indicates that the magnetic field of the region is very nearly potential. The H-alpha fibril structures of this region as seen in high-resolution photographs corroborate this conclusion. Consequently, a potential-field calculation is described using the measured line-of-sight fields together with assumed Neumann boundary conditions; both are necessary and sufficient for a unique solution. The computed transverse fields are then compared with the measured transverse fields to verify the potential-field model and assumed boundary values. The implications of these comparisons for the validity of magnetic-field extrapolations using potential theory are discussed.
A method is described which correlates the NASA-Marshall Space Flight Center (MSFC) Image Data Processing System (IDAPS) and MSFC magnetograph data to X-ray and H-alpha observations from the Skylab mission. Solutions of Laplace's equation in three dimensions, based on the magnetograph data, are convolved with observed X-ray and H-alpha regions. Matched filtering (template matching) provides a best fit of the observed X-ray regions to the computed total magnetic vector magnitude between 10,000 and 15,000 km above the photosphere.
High resolution frequency analysis methods, with application to the gravitational probe redshift experiment, are discussed. For this experiment a resolution of .00001 Hz is required to measure a slowly varying, low frequency signal of approximately 1 Hz. Major building blocks include fast Fourier transform, discrete Fourier transform, Lagrange interpolation, golden section search, and adaptive matched filter technique. Accuracy, resolution, and computer effort of these methods are investigated, including test runs on an IBM 360/65 computer.