Engineering Papers⌕ Search

Engineering topics

Taylor, L. W., Jr.

Publications and source records attributed to Taylor, L. W., Jr..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Analytical techniques for the analysis of stall/spin flight test data

Analytical techniques for the analysis of stall/spin flight test data are reviewed by discussing (1) certain special flight instrumentation issues, (2) the mathematical modeling techniques, and (3) the analysis of post stall and spinning flight of general aviation airplanes. The angles of attack, sideslip, roll, pitch, and yaw are derived from measurements of angular velocity and linear acceleration. The key to the success of this approach is to simultaneously estimate both the biases in the instrumentation and the initial conditions. Techniques for determining stability derivatives from flight data are applied to angles of attack too high for stabilized flight. This practice greatly expands the range over which aerodynamic characteristics can be determined from flight test. Nonlinear terms in certain aerodynamic functions are shown to be valid by comparing them with the trends of results at different angles of attack. A very old technique of studying spins is extended and applied to some modern light airplanes. Airplanes for which the wing provides the dominant moments during spins, offer the possibility of linking spin characteristics to longitudinal data.

Taylor, L. W., Jr.↗
NASA NTRS1980

Determination of an angle of attack sensor correction for a general aviation airplane at large angles of attack as determined from wind tunnel and flight tests

A comprehensive investigation into the flow correction for an angle of attack sensor mounted ahead of the wing tip of a general aviation research airplane has been conducted at the Langley Research Center. This correction has been determined in wind tunnels using a full-scale model up to angles of attack of 45 deg and a 1/5-scale model up to 80 deg angle of attack. The flow correction has also been obtained in flight by using a standard technique at low angles of attack and in spinning flight at larger angles of attack, by using both a simple approximate technique and a parameter estimation technique. The results show the correction is significant, reaching 10 deg at a measured angle of attack of about 90 deg. The flow correction was sensitive to the angle of sideslip at measured angles of attack greater than 60 deg and was not influenced by wing leading-edge modifications or aileron deflections.

Moul, T. M.↗
NASA NTRS1978

A new formulation for the epsilon method applied to the minimum-time-to-climb problem

Balakrishnan's epsilon technique is used to compute minimum-time profiles for the F-104 airplane. This technique differs from the classical gradient method in that a quadratic penalty on the error in satisfying the equation of motion is included in the cost function to be minimized as a means of eliminating the requirement of satisfying the equations of motion. Although the number of unknown independent functions is increased to include the state variables, the evaluation of the gradient of the cost function is simplified, resulting in considerable computational savings, thereby making it appear feasible to use the epsilon method for real-time application.

Taylor, L. W., Jr.↗
NASA NTRS1977

Active controls for transports

It is shown that the integration of active controls into advanced commercial transport designs yields increased efficiency (by as much as 12%), reduced fuel consumption, and improved safety. These conclusions are based on a NASA development program considering various design configurations, wind tunnel tests (e.g., tests of static and dynamic control effects, aerodynamic loads, flutter tests, and active flutter suppression system tests), and extensive flight testing.

Taylor, L. W., Jr.↗
NASA NTRS1977

Future opportunities in digital avionics - NASA's role

The current avionics program of NASA is briefly reviewed with attention given to digital operations (navigation, communication and guidance), integrated controls (dealing with aircraft stability, handling qualities, load alleviation, and propulsion) and cockpit avionics. NASA's role is discussed in terms of the present avionics program and the future opportunities that are addressed in long-range plans.

Taylor, L. W., Jr.↗
NASA NTRS1977

Resource conservation through airborne electronics

Avionics can play a significant role in making aircraft more fuel-efficient through active controls and the accompanying structural and aerodynamic configuration changes. In addition, avionics can make aircraft operations more efficient through advanced guidance systems. This paper discusses some of these techniques, reviews their potential benefits, and examines certain related NASA programs.

Taylor, L. W., Jr.↗
NASA NTRS1975

Application of a new criterion for modeling systems

A new criterion is proposed for modeling systems which promises to be useful in deciding how complex a model should be. The criterion is based on the expected model response error instead of the error in fitting the data used for estimating the model parameters. The new criterion also does not require withholding data to be used exclusively for testing. There remains, however, the difficulty of testing a large number of candidate models that correspond to the combinations of terms used in the dynamic equations. A computational approach is suggested which greatly reduces the computations required in searching for the best model. In the suggested approach the gradient of the response with respect to the model coefficients is held fixed and numerous combinations of terms are assessed. After determining the most promising candidate model, the gradient is updated and the process is repeated. This procedure gives greater assurance that the best model is selected and does not rely on the analyst's judgement.

Taylor, L. W., Jr.↗
NASA NTRS1975

Application of active controls to civil transport aircraft

The impact of active controls on civil transport aircraft and some of the complex problems involved are described. The approach taken by NASA as part of the Active Control Technology Program is discussed to integrate active controls in the conceptual design phase. It is shown that when handled correctly, active controls improve aircraft performance.

Taylor, L. W., Jr.↗
NASA NTRS1974

A modified Newton-Raphson analysis of flight measurements of the trailing vortices of a heavy jet transport

A modified Newton-Raphson method has been used to determine the parameters in equations describing the vortex flow to obtain a best match with flight measurements of the flow behind the C-5A airplane. The flight measurements were made using a specially instrumented T-33 airplane which passed as closely as possible to the centers of the trailing vortices at several distances behind the C-5A airplane. The flight measurements were transformed to flow velocity relative to an inertial frame of reference. The assumed form of the flow consisted of the superposition of two counterrotating, finite core vortices. The positions of the vortex centers, their total circulation, the effective eddy viscosity and measurement bias were the parameters adjusted. The assumed form of vortex flow fit well the measured velocities for the numerous sets of data, both flaps up and down for the C-5A airplane. The resulting values of total circulation, however, were about two-thirds that expected of a wing with an elliptical loading. A partial explanation of the less than expected circulation is a dip in the spanwise lift distribution at the airplane's center line. The distance between the trailing vortices at the smallest times encountered is somewhat less than that expected for an elliptical wing loading.

Taylor, L. W., Jr.↗
NASA NTRS1974

A new criterion for modeling systems

The criterion that is proposed is an expected value of the mean square response error as an alternative to testing a model against new data. Modeling with respect to this new criterion does not change the estimate for a given model format from a maximum likelihood estimate or mean square response error estimate. The new criterion does, however, provide a means of comparing models with different formats and varying complexity. A numerical example is used to illustrate the application of the proposed criteria and the problem of searching for the best model. For all but the most trivial system identification problems, it is shown that a prohibitive number of combinations of terms of the model must be investigated to ensure the final model is best.

Taylor, L. W., Jr.↗
NASA NTRS1974

Systems identification - reprise and projections

A state-of-the-arts review is given for the field of system identification. Progress in the field is traced from the early models of dynamic systems by Sir Isaac Newton up to the present day use of advanced techniques for numerous applications.

Taylor, L. W., Jr.↗
NASA NTRS1972

Systems identification using a modified Newton-Raphson method: A FORTRAN program

A FORTRAN program is offered which computes a maximum likelihood estimate of the parameters of any linear, constant coefficient, state space model. For the case considered, the maximum likelihood estimate can be identical to that which minimizes simultaneously the weighted mean square difference between the computed and measured response of a system and the weighted square of the difference between the estimated and a priori parameter values. A modified Newton-Raphson or quasilinearization method is used to perform the minimization which typically requires several iterations. A starting technique is used which insures convergence for any initial values of the unknown parameters. The program and its operation are described in sufficient detail to enable the user to apply the program to his particular problem with a minimum of difficulty.

Taylor, L. W., Jr.↗
NASA NTRS1972

Determination of stability derivatives from flight data using a Newton-Raphson minimization technique

A modified Newton-Raphson or quasilinearization minimization technique for determining stability derivatives from flight data was developed and compared with simple-equations, analog-matching, least-squares, and Shinbrot methods of analysis. For the data analyzed, the solutions computed by using the estimates obtained from the Newton-Raphson technique fit the data and determined coefficients adequately. A further modification to include a priori information was found to be useful. A model statistically similar to the flight data was analyzed using the same methods (excluding analog matching), and the Newton-Raphson technique was found to yield superior estimates. An approximate Cramer-Rao bound was compared with the error covariance matrix of the model and was found to provide information about the reliability of the individual estimates obtained. The technique was successfully applied to data obtained from a light airplane, a large supersonic airplane, and a lifting body vehicle. It was shown that the reliability of the estimates of a given coefficient obtained from these vehicles depends upon the data analyzed.

Iliff, K. W.↗