Engineering topics

Targ, Russell

Publications and source records attributed to Targ, Russell.

13 records

NASA NTRS1993

Coherent launch-site atmospheric wind sounder - Theory and experiment

The coherent launch-site atmospheric wind sounder (CLAWS) is a lidar atmospheric wind sensor designed to measure the winds above space launch facilities to an altitude of 20 km. In our development studies, lidar sensor requirements are defined, a system to meet those requirements is defined and built, and the concept is evaluated, with recommendations for the most feasible and cost-effective lidar system for use as an input to a guidance and control system for missile or spacecraft launches. The ability of CLAWS to meet NASA goals for increased safety and launch/mission flexibility is evaluated in a field test program at Kennedy Space Center (KSC) in which we investigate maximum detection range, refractive turbulence, and aerosol backscattering efficiency. The Nd:YAG coherent lidar operating at 1.06 micron with 1-J energy per pulse is able to make real-time measurements of the 3D wind field at KSC to an altitude of 26 km, in good agreement with our performance simulations. It also shows the height and thickness of the volcanic layer caused by the volcanic eruption of Mount Pinatubo in the Philippines.

Hawley, James G.↗

NASA NTRS1993

The detection and measurement of microburst wind shear by an airborne lidar system

The NASA Lockheed Missiles and Space Company (LMSC) Coherent Lidar Airborne Shear Sensor (CLASS) employs coherent lidar technology as a basis for a forward-looking predictive wind shear detection system. Line of sight wind velocities measured ahead of the aircraft are combined with aircraft state parameters to relate the measured wind change (or shear) ahead of an aircraft to its performance loss or gain. In this way the system can predict whether a shear detected ahead of the aircraft poses a significant threat to the aircraft and provide an advance warning to the flight crew. Installed aboard NASA's Boeing 737 research aircraft, the CLASS system is flown through convective microburst wind shears in Denver, Co., and Orlando, Fl. Some preliminary flight test results are presented. It is seen that the system was able to detect and measure wind shears ahead of the aircraft in the relatively dry Denver environment, but its performance was degraded in the high humidity and heavy rain in Orlando.

Robinson, Paul A.↗

NASA NTRS1992

Performance of a 1-micron, 1-joule Coherent Launch Site Atmospheric Wind Sounder

The paper describes the design and performance of the Coherent Launch Site Atmospheric Wind Sounder (CLAWS), which is a test and demonstration program designed for monitoring winds with a solid-state lidar in real time for the launch site vehicle guidance and control application. Analyses were conducted to trade off CO2 (9.11- and 10.6-microns), Ho:YAG (2.09 microns), and Nd:YAG (1.06-micron) laser-based lidars. The measurements set a new altitude record (26 km) for coherent wind measurements in the stratosphere.

Hawley, James G.↗

NASA NTRS1991

Coherent lidar airborne windshear sensor - Performance evaluation

As part of the NASA/FAA National Integrated Windshear Program, a measurable windshear hazard index has been defined that can be remotely sensed from an aircraft, to give the pilot information about the wind conditions along the flight path. A technology analysis and end-to-end performance simulation measuring signal-to-noise ratios and resulting wind velocity errors for competing coherent laser radar (lidar) systems have been carried out. The results show that a Ho:YAG lidar at a wavelength of 2.1 microns and a CO2 lidar at 10.6 microns can give the pilot information about the line-of-sight component of a windshear threat from his present position to a region extending 2-4 km in front of the aircraft. This constitutes a warning time of 20-40 s, even in conditions of moderately heavy precipitation.

Targ, Russell↗

NASA NTRS1991

CLASS: Coherent Lidar Airborne Shear Sensor. Windshear avoidance

The coherent lidar airborne shear sensor (CLASS) is an airborne CO2 lidar system being designed and developed by Lockheed Missiles and Space Company, Inc. (LMSC) under contract to NASA Langley Research Center. The goal of this program is to develop a system with a 2- to 4-kilometer range that will provide a warning time of 20 to 40 seconds, so that the pilot can avoid the hazards of low-altitude wind shear under all weather conditions. It is a predictive system which will warn the pilot about a hazard that the aircraft will experience at some later time. The ability of the system to provide predictive warnings of clear air turbulence will also be evaluated. A one-year flight evaluation program will measure the line-of-sight wind velocity from a wide variety of wind fields obtained by an airborne radar, an accelerometer-based reactive wind-sensing system, and a ground-based Doppler radar. The success of the airborne lidar system will be determined by its correlation with the windfield as indicated by the onboard reactive system, which indicates the winds actually experienced by the NASA Boeing 737 aircraft.

Targ, Russell↗

NASA NTRS1991

Lidar windshear detection for commercial aircraft

As part of the NASA/FAA National Integrated Windshear Program, a measurable windshear hazard index that can be remotely sensed from an aircraft is presented. This will provide a pilot information about the wind conditions he will experience at some later time if he continues along the present flight path. The technology analysis and end-to-end performance simulation, which measured S/N and resulting wind velocity errors for competing lidar systems, demonstrated that a Ho:YAG lidar at a wavelength of 2.1 microns and a CO2 lidar at 10.6 microns can give the pilot data about the line-of-sight component of a windshear threat in an area extending from his present position to two to four km in front of the aircraft.

Targ, Russell↗

NASA NTRS1991

Infrared lidar windshear detection for commercial aircraft and the edge technique, a new method for atmospheric wind measurement

The edge technique, a new method for measuring small frequency shifts, is described. The technique allows high-accuracy measurement of atmospheric winds (0.2-1 m/s) with a high vertical resolution (10 m) using currently available technology. With the edge technique, a lidar system can be used to obtain range resolved measurements of the wind in the atmosphere from the ground, aircraft, or spaceborne platforms. The edge technique can be used with different lasers over a broad range of wavelengths.

Targ, Russell↗

NASA NTRS1990

Investigation of airborne lidar for avoidance of windshear hazards

A generalized windshear hazard index is defined, which is derived from considerations of wind conditions at the present position of an aircraft and from remotely sensed information along the extended flight path. Candidate airborne sensor technologies based on microwave Doppler radar, Doppler lidar, and infrared radiometric techniques are discussed in the context of overall system functional requirements. Initial results of a performance and technology assessment study for competing lidars are presented. Based on a systems approach to the windshear threat, lidar appears to be a viable technology for windshear detection and avoidance, even in conditions of moderately heavy precipitation. The proposed airborne CO2 and Ho:YAG lidar windshear-detection systems analyzed here can give the pilot information about the line-of-sight component of windshear threat from his present position to a region extending 1 to 3 km in front of the aircraft. This constitutes a warning time of 15 to 45 seconds. The technology necessary to design, build, and test such a brassboard 10.6 micron CO2 lidar is now available. However, for 2-micron systems, additional analytical and laboratory investigations are needed to arrive at optimum 2-micron rare-earth-based laser crystals.

Targ, Russell↗

NASA NTRS1988

Investigation of airborne lidar for avoidance of windshear hazards

The present generalized windshear hazard index is formulated in terms of wind conditions at the given aircraft position and of remotely-sensed information obtained along the extended flight path. Overall system functional requirements are addressed by comparing microwave Doppler radar, Doppler lidar, and IR radiometry candidate techniques, giving attention to airborne CO2 and Ho:YAG lidar windshear-detection systems; these furnish pilots with data on the line-of-sight component of windshear threats over as much as 1-3 km, for a warning time of 15-45 sec. While the technology for a 10.6-micron, CO2 laser-based lidar is available, additional development is required for 2-micron, Ho:YAG laser-based systems.

Targ, Russell↗

NASA NTRS1988

Lidar windshear detection and avoidance: Performance and technical assessment

The objective of this study is to evaluate competing lidars for use in an airborne forward-looking system to enable aircraft to avoid the hazards of low altitude wind shear. Information is presented in vugraph form on lidar general requirements, tentative technical requirements, comparison of velocity errors and signal to noise ratios in clear weather for 2.1 and 10.6 micron lidars, a wind shear display, and preliminary results.

Targ, Russell↗

NASA NTRS1988

Windshear detection and avoidance - Airborne systems perspective

The generalized windshear hazard index presently defined is derived from aircraft-position wind data and remotely sensed data obtained along the extended flight path by such candidate sensor technologies as microwave Doppler radar, Doppler lidar, and IR radiometry. Attention is given here to the results of a comparative evaluation of CO2 and Ho:YAG lidar sensor-employing windshear-detection systems, over a range 1-3 km ahead of the aircraft (corresponding to 15-45 sec of warning time). While the technology for a 10.6-micron CO2 lidar system is available, an optimum 2-micron REE laser crystal-based system remains to be developed.

Bowles, Roland L.↗

NASA NTRS1988

Windshear avoidance - Requirements and proposed system for airborne lidar detection

A generalized windshear hazard index is derived from considerations of wind conditions and an aircraft's present and potential altitude. Based on a systems approach to the windshear threat, lidar appears to be a viable methodology for windshear detection and avoidance, even in conditions of moderately heavy precipitation. The airborne CO2 and Ho:YAG lidar windshear detection systems analyzed can each give the pilot information about the line-of-sight component of windshear threat from his present position to a region extending 1 to 3 km in front of the aircraft. This constitutes a warning time of 15 to 45 s. The technology necessary to design, build and test such a brassboard 10.6-micron CO2 lidar is at hand.

Targ, Russell↗

NASA NTRS1988

Performance analysis and technical assessment of coherent lidar systems for airborne wind shear detection

Detailed computer simulations of the lidar wind-measuring process have been conducted to evaluate the use of pulsed coherent lidar for airborne windshear monitoring. NASA data fields for an actual microburst event were used in the simulation. Both CO2 and Ho:YAG laser lidar systems performed well in the microburst test case, and were able to measure wind shear in the severe weather of this wet microburst to ranges in excess of 1.4 km. The consequent warning time gained was about 15 sec.

Huffaker, R. Milton↗