Engineering topics
Tang, L.
Publications and source records attributed to Tang, L..
Electroproduction of K+ Λ at JLab Hall-C
A Λ hypernuclear spectroscopic experiment, JLab E05-115 was performed at JLab Hall-C in 2009 by the (e, e' K + ) reaction. Data of Λ hypernuclei with mass numbers from A = 7 to A = 52 were successfully taken, and the analyses are in progress. A polyethylene (CH 2 ) target was used as a proton target to calibrate energy scales, and to study elementary process of the p(e, e' K + )Λ, Σ 0 reaction. We report a preliminary differential cross section of K + Λ electro-production at low Q 2 [~0.01 (GeV/c) 2 ] and at small kaon angles (cosΘ$CM\atop{K}$ ~0.97) in the present article.
Observation of the Λ ⁷He Hypernucleus by the (e, e'K⁺) Reaction
An experiment with a newly developed high-resolution kaon spectrometer and a scattered electron spectrometer with a novel configuration was performed in Hall C at Jefferson Lab. The ground state of a neutron-rich hypernucleus, He Λ ⁷, was observed for the first time with the (e, e'K⁺) reaction with an energy resolution of ~0.6 MeV. This resolution is the best reported to date for hypernuclear reaction spectroscopy. The He Λ ⁷ binding energy supplies the last missing information of the A=7, T=1 hypernuclear isotriplet, providing a new input for the charge symmetry breaking effect of the ΛN potential.
New Measurements of High-Momentum Nucleons and Short-Range Structures in Nuclei
We present new, high-Q 2 measurements of inclusive electron scattering from high-momentum nucleons in nuclei. This yields an improved extraction of the strength of two-nucleon correlations for several nuclei, including light nuclei where clustering effects can, for the first time, be examined. The data extend to the kinematic regime where three-nucleon correlations are expected to dominate and we observe significantly greater strength in this region than previous measurements.
Semi-inclusive charged-pion electroproduction off protons and deuterons : cross sections, ratios and access to the quark-parton model at low energies
No abstract prepared.
Sounding Rocket Microgravity Experiments Elucidating Diffusive and Radiative Transport Effects on Flame Spread over Thermally-Thick Solids
A series of 6-minute microgravity combustion experiments of opposed flow flame spread over thermally-thick PMMA has been conducted to extend data previously reported at high opposed flows to almost two decades lower in flow. The effect of flow velocity on flame spread shows a square root power law dependence rather than the linear dependence predicted by thermal theory. The experiments demonstrate that opposed flow flame spread is viable to very low velocities and more robust than expected from the numerical model, which predicts that at very low velocities (less than 5 centimeters per second), flame spread rates fall off more rapidly as flow is reduced. It is hypothesized that the enhanced flame spread observed in the experiments may be due to three- dimensional hydrodynamic effects, which are not included in the zero-gravity, two-dimensional hydrodynamic model. The effect of external irradiation was found to be more complex that the model predicted over the 0-2 Watts per square centimeter range. In the experiments, the flame compensated for the increased irradiation by stabilizing farther from the surface. A surface energy balance reveals that the imposed flux was at least partially offset by a reduced conductive flux from the increased standoff distance, so that the effect on flame spread was weaker than anticipated.
Simulation of Transonic Limit Cycle Oscillations Using a CFD Time-marching Method
CFD-based aeroelastic computations are performed to investigate the effect of nonlinear aerodynamics on transonic LCO (Limit Cycle Oscillations) characteristics of a two-dimensional supercritical wing with the NLR 7301section. It is found that the presentation of the viscous effects, including turbulence modeling, plays an important role on the accurate prediction of shock and LCO; and a small initial perturbation appears to produce large amplitude LCO at small mean pitch angle and plunge while a large amplitude initial perturbation produces small (or negligible) amplitude LCO at larger mean values. Also addressed in the paper is the issues related to multiblock MPI (Message Passing Interface) parallel computation.
Reflight of the Solid Surface Combustion Experiment: Flame Radiation Near Extinction
In flame spreading in quiescent and low-velocity opposing flows, effects of surface reradiation and flame radiation are important in establishing the spread rate and whether the flame, once ignited, survives to steady spread or extinguishes after a time long compared to the ignition event. A reflight of the Solid Surface Combustion Experiment (SSCE), supported by modelling, demonstrates that for thick, flat fuels, the ultimate fate of the flame is extinction rather than steady spread. A mismatch between the thermal scale in the gas, driven by radiation, and the species diffusion scale, driven by mass diffusion, develops such that the high temperature regions of the flame are ultimately located in a region to which oxygen cannot be supplied at a sufficient rate to sustain reaction, and extinction occurs. Results of the experiment conducted on Space Shuttle mission STS 85 on 9 August 1997 are reviewed. For the flat surface geometry, while the hydrodynamic phenomena associated with opposed-flow flame spread may be treated two dimensionally, the radiative effects are three dimensional, and so modelling the radiative processes, with the mismatch in dimensionality, is difficult. The cylindrical geometry at least one long compared to the radius, provides a configuration in which the radiative processes for spread in the axial direction are two dimensional, thus simplifying the modelling. The cylindrical geometry allows for the development of more sophisticated radiative models without the complication of dimensionality concerns, e.g., discrete transfer, which is discussed in detail by Bundy (1998). Additionally, the cylindrical geometry results in a "focussing" of the heat transfer to the surface and may allow for steady spread for radii that for thick fuels of the same half-thickness there is no steady spread.
Diffusive and Radiative Transport in Fires (DARTFire): Opposed-Flow Flame Spread in Low-Velocity Flows
For flames spreading into a low-velocity flow that can only be obtained in microgravity, we have observed behavior that is different from that which is obtained at higher velocities where radiative effects are unimportant and species transport is relatively fast. Unfortunately, lack of a large body of low-gravity flame spread experimental data inhibits progress in developing an understanding of the physics of low-velocity, opposed-flow flame spread phenomena. Recent DARTFire sounding rocket experimental studies though, coupled with developing theory and modelling, have allowed some strides in understanding to be made, on which we report here. Four launches to date have resulted in six experiments for opposed-flow flame spread over a thick PMMA sample. During the 6 min microgravity period, the PMMA samples were ignited, and steady flame spread was studied under varied flow velocity, oxidizer atmospheric conditions, and, because radiative heat transfer is so important in these slowly spreading flames, external radiant flux. These were the first attempts at such experimental control and measurement in microgravity. A recent reflight of the Solid Surface Combustion Experiment (SSCE) has demonstrated, as modelling predicts, that for the thick fuel of the DARTFire experiment, flame spread in a quiescent environment is a transient process evolving from ignition to extinction on the order of 600 s (Altenkirch et al., 1999). Further study then of the effects of radiation in the very low-velocity opposing flows is of interest in understanding the transition from steady, sustained spread to the unsteady evolution to extinction as the opposing flow is reduced further and eventually removed.
Maintaining Restored Bone with Bisphoshonate in the Ovariectomized Rat Skeleton: Dynamic Histomorphometry of Changes in Bone Mass
This experiment contains the crucial data for the Lose, Restore and Maintain (LRM) concept, a practical approach for reversing existing osteoporosis. The LRM concept uses ovariectomy (ox) to lose bone, an anabolic agent to restore bone mass and then switches to an anti-resorptive agent to maintain bone mass. We ox'd or sham-ox'd rats for 150 days (Loss Phase), treated them with 6 mg PGE2/kg/d for 75 days to restore lost cancellous bone mass (Restore Phase) and then stopped PGE2 treatment and began treatment with 1 or 5 micro-g/kg Risedronate, a bisphosphonate twice a week for 60 days (Maintain Phase). During the Loss Phase, cancellous bone volumes of the proximal tibial metaphysis (PTM) in the ox'd rat fell to 19% of initial controls. During the Restore Phase, the PTM bone volume in ox'd rats doubled. However, when PGE2 treatment was stopped, the PGE2-induced cancellous bone disappeared. In contrast, 5 micro-g of Risedronate inhibited the bone loss and maintained it at the PGE2 treatment level. The key dynamic histomorphometry value for the restore (R) and maintenance (M) phases was the ratio of bone formation to resorption rates. The ratio was elevated to 5.8 in the R phase and depressed to 0.4 for no and 1 micro-g Risedronate treated M phase and to a ratio of near unity of 1.1 for the 5 micro-g Risedronate treatment. These findings indicate that we were successful in maintaining the new PTM bone induced by PGE2 after discontinuing PGE2 by administering enough Risedronate, a resorption inhibitor. We concluded that the LRM concept is correct and such an approach should be considered when employing anabolic agents or growth factors in the treatment of osteoporosis. Continued use of an anabolic agent may not be appropriate because of cost, potential adverse side effects and a loss of efficacy.
Maintaining Restored Bone with Bisphosphonate in the Ovariectomized Rat Skeleton: Dynamic Histomorphometry of Changes in Bone Mass
This experiment contains the crucial data for the Lose, Restore and Maintain (LRM) concept, a practical approach for reversing existing osteoporosis. The LRM concept uses ovariectomy (ox) to lose bone, an anabolic agent to restore bone mass and then switches to an antiresorptive agent to maintain bone mass. We ox'd or sham-ox'd rats for 150 days (Loss Phase), treated them with 6 mg PGE(sub 2)kg/d for 75 days to restore lost cancellous bone mass (Restore Phase) and then stopped PGE(sub 2) treatment and began treatment with 1 or 5 micrograms/kg Risedronate, a bisphosphonate twice a week for 60 days (Maintain Phase). During the Loss Phase, cancellous bone volumes of the Proximal Tibial Metaphysis (PTM) in the ox'd rat fell to 19% of initial controls. During the Restore Phase, the PTM bone volume in ox'd rats doubled. However, when PGE(sub 2) treatment was stopped, the PGE(sub 2)-induced cancellous bone disappeared. In contrast, 5 miligrams of Risedronate inhibited the bone loss and maintained it at the PGE(sub 2) treatment level. The key dynamic histomorphometry value for the Restore (R) and Maintenance (M) phases was the ratio of bone formation to resorption rates. The ratio was elevated to 5.8 in the R phase and depressed to 0.4 for no and 1 miligram Risedronate treated M phase and to a ratio of near unity of 1.1 for the 5miligrams Risedronate treatment. These findings indicate that we were successful in maintaining the new PTM bone induced by PGE(sub 2) after discontinuing PGE(sub 2) by administering enough Risedronate, a resorption inhibitor. We concluded that the LRM concept is correct and such an approach should be considered when employing anabolic agents or growth factors in the treatment of osteoporosis. Continued use of an anabolic agent may not be appropriate because of cost, potential adverse side effects and a loss of efficacy.