Engineering Papers⌕ Search

Engineering topics

Swanson, Robert S

Publications and source records attributed to Swanson, Robert S.

10 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1948

Lifting-surface-theory aspect-ratio corrections to the lift and hinge-moment parameters for full-span elevators on horizontal tail surfaces

A limited number of lifting-surface-theory solutions for wings with chordwise loadings resulting from angle of attack, parabolic-ac camber, and flap deflection are now available. These solutions were studied with the purpose of determining methods of extrapolating the results in such a way that they could be used to determine lifting-surface-theory values of the aspect-ratio corrections to the lift and hinge-moment parameters for both angle-of-attack and flap-deflection-type loading that could be used to predict the characteristics of horizontal tail surfaces from section data with sufficient accuracy for engineering purposes. Such a method was devised for horizontal tail surfaces with full-span elevators. In spite of the fact that the theory involved is rather complex, the method is simple to apply and may be applied without any knowledge of lifting-surface theory. A comparison of experimental finite-span and section value and of the estimated values of the lift and hinge-moment parameters for three horizontal tail surfaces was made to provide an experimental verification of the method suggested. (author)

Swanson, Robert S↗
NASA NTRS1944

Wind-Tunnel Calibration and Correction Procedures for Three-Dimensional Models

Detailed methods are presented for determining the corrections to results from wind-tunnel tests of three-dimensional models for the effects of the model-support system, the nonuniform air flow in the tunnel, and the tunnel walls or jet boundaries. The procedures for determining the corrections are illustrated by equations and the required tests are discussed. Particular attention is given to the parts of the procedures dealing with drag measurements. Two general methods that are used for determining and applying the corrections to force tests are discussed. Some discussion is also included of the correction procedures to be used for wake survey tests. The methods described in this report apply only to tests at subcritical speeds. (author)

Swanson, Robert S↗
NASA NTRS1943

Jet-boundary corrections for reflection-plane models in rectangular wind tunnel

A detailed method for determining the jet-boundary corrections for reflection-plane models in rectangular wind tunnels is presented. The method includes the determination of the tunnel span local distribution and the derivation of equations for the corrections to the angle of attack, the lift and drag coefficients, and the pitching-, rolling-, yawing-, and hinge-moment coefficients. The principle effects of aerodynamic induction and of the boundary-induced curvature of the streamlines have been considered. An example is included to illustrate the method. Numerical values of the more important corrections for reflection-plane models in 7 by 10-foot closed wind tunnels are presented.

Swanson, Robert S↗
NASA NTRS1940

Wind tunnel tests of an NACA 23021 airfoil equipped with a slotted extensible and a plain extensible flap

An investigation has been made in the NACA 7- by 10-foot wind tunnel of a large chord NACA 23021 airfoil equipped with two arrangements of a completely extended 15 percent chord extensible flap. One of the flaps had a faired juncture, without a gap; the other was provided with a slot between the trailing edge of the airfoil and the nose of the flap. The results showed that the basic airfoil gave the lowest profile-drag coefficients over the low lift range, the airfoil with the plain extensible flap gave the lowest profile-drag coefficients over the moderate lift range, and the airfoil with the slotted extensible flap gave the lowest profile-drag coefficients over the high lift range. The airfoil with the slotted extensible flap had the same maximum lift at a flap deflection of 25 degrees as the airfoil with the plain extensible flap had at a flap deflection of 60 degrees. The results of comparisons of the airfoil pitching-moment coefficients obtained with the two types of flap are dependent upon the basis chosen for comparison. Complete aerodynamic section characteristics are presented for the various flap deflections for both flap arrangements in the completely extended portion.

Swanson, Robert S↗