Engineering topics

Sushko, Petr V.

Publications and source records attributed to Sushko, Petr V..

7 records

DOE OSTI2023

Silicon-Lattice-Matched Boron-Doped Gallium Phosphide: A Scalable Acousto-Optic Platform

The compact size, scalability, and strongly confined fields in integrated photonic devices enable new functionalities in photonic networking and information processing, both classical and quantum. Gallium phosphide (GaP) is a promising material for active integrated photonics due to its high refractive index, wide bandgap, strong nonlinear properties, and large acousto-optic figure of merit. Here, this study demonstrates that silicon-lattice-matched boron-doped GaP (BGaP), grown at the 12-inch wafer scale, provides similar functionalities as GaP. BGaP optical resonators exhibit intrinsic quality factors exceeding 25,000 and 200,000 at visible and telecom wavelengths, respectively. It further demonstrates the electromechanical generation of low-loss acoustic waves and an integrated acousto-optic (AO) modulator. High-resolution spatial and compositional mapping, combined with ab initio calculations, indicate two candidates for the excess optical loss in the visible band: the silicon-GaP interface and boron dimers. These results demonstrate the promise of the BGaP material platform for the development of scalable AO technologies at telecom and provide potential pathways toward higher performance at shorter wavelengths.

36 MATERIALS SCIENCE↗

DOE OSTI2022

Probing electronic dead layers in homoepitaxial n-SrTiO 3 (001) films

We combine state-of-the-art oxide epitaxial growth by hybrid molecular beam epitaxy with transport, x-ray photoemission, and surface diffraction, along with classical and first-principles quantum mechanical modeling to investigate the nuances of insulating layer formation in otherwise high-mobility homoepitaxial n-SrTiO 3 (001) films. Our analysis points to charge immobilization at the buried n-SrTiO 3 /undoped SrTiO 3 (001) interface as well as within the surface contamination layer resulting from air exposure as the drivers of electronic dead-layer formation. As Fermi level equilibration occurs at the surface and the buried interface, charge trapping reduces the sheet carrier density (n 2D ) and renders the n-STO film insulating if n 2D falls below the critical value for the metal-to-insulator transition.

36 MATERIALS SCIENCE↗

DOE OSTI2022

Mapping hidden space-charge distributions across crystalline metal oxide/group IV semiconductor interfaces

The electronic structures of semiconducting heterojunctions are critically dependent on composition including the presence and concentrations of dopants, both intended and unintended. Dopant profiles in the interfacial region can have major effects on band energies which in turn drive transport properties. Here, in this study, we use core-level photoelectron line shapes excited with hard x rays to extract information about electric fields resulting from internal charge transfer in epitaxial La 0.03 Sr 0.97 Zr x Ti 1–x O 3 /Ge(001) (0.1≤x≤0.7) heterostructures. Experiments were carried out for heterojunctions involving both n- and p-type Ge substrates. These heterojunctions were not amenable to electronic characterization of all regions by transport measurements because the doped substrates act as electrical shunts, precluding probing the more resistive films and masking interface conductivity. However, the core-level line shapes were found to be a rich source of information on built-in potentials that exist throughout the heterostructure, and yielded valuable insight into the impact of band bending on band alignment at the buried interfaces. The electronic effects expected for Ge with uniform n- and p-type doping are eclipsed by those of unintended oxygen dopants in the Ge near the interface. This study illustrates the power of hard x-ray photoemission spectroscopy and related modeling to determine electronic structure in material systems for which insight from traditional transport measurements is limited.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Understanding the Electronic Structure Evolution of Epitaxial LaNi1-xFexO3 Thin Films for Water Oxidation

Rare earth nickelates including LaNiO3 are promising catalysts for water electrolysis to produce oxygen gas. Recent studies report that Fe substitution for Ni can significantly enhance the oxygen evolution reaction (OER) activity of LaNiO3. However, the role of Fe in increasing activity remains ambiguous, with potential origins both structural and electronic in nature. Here, by utilizing a series of epitaxial LaNi1-xFexO3 thin films synthesized by oxygen-assisted molecular beam epitaxy, we report that Fe substitution tunes the oxidation state of Ni in LaNi1-xFexO3 and a volcano-like OER trend is observed with x = 0.375 being the most active. Spectroscopy and ab initio modeling reveal that the high-valent Fe3+? B-site cationic species strongly increases the transition metal (TM) 3d bandwidth via Ni-O-Fe bridges and enhances the TM 3d-O 2p hybridization, boosting the OER activity. Furthermore, pH-dependent electrochemical measurements suggest that the OER on LaNi1-xFexO3 involves a lattice oxygen-mediated mechanism.

LaNiO3, Fe substitution, charge transfer, lattice ↗

DOE OSTI2021

Lattice misorientation evolution and grain refinement in Al-Si alloys under high-strain shear deformation

The starting microstructure of an alloy can be tailored to achieve varying degrees of microstructural refinement and enhance mechanical properties through severe plastic shear deformation during solid-phase processing. Crystal plasticity-based grain misorientation modeling, coupled with systematic pin-on-disk tribometry-based subsurface shear deformation experiments on as-cast Al-xSi alloys (x = 0, 1, 4 at %), was conducted. The post-deformation microstructural analysis, through a combined computational and experimental approach, conclusively shows that the initial volume fraction of the hard Si phase enhances the evolution of local lattice misorientation, leading to efficient grain refinement during severe plastic shear deformation. The shear–deformation-induced nanostructure resulted in more than double the nanoindentation hardness in the processed alloy.

Gwalani, Bharat↗

DOE OSTI2021

Formation of pyrophosphates across grain boundaries induces the formation of mismatched but oriented interfaces in silver phosphate polypods

The interfaces and their misfit defects determine the materials properties for a wide range of applications, such as electronic devices, photocatalysis, and mechanical engineering, etc. However, current understanding of atomic interfacial structures is limited. Here we discover a special interfacial structure, mismatched but oriented interface via two distinct facets. Transmission and scanning electron microscopy results suggest that, in Ag 3 PO 4 polypods structures, interfaces of {1 0 0} and {1 1 0}, ({1 0 0}/(1 1 0}), {1 0 0}/{1 1 1}, {1 1 0}/{1 1 1}, and {1 0 0}/{1 0 0}, etc., have a certain orientation relationship, corresponding to the energy minima and coincident site lattice of interfacial atoms as demonstrated by molecular dynamics simulations. Density functional theory demonstrates that the formation of pyrophosphate and/or phosphates rotation to bond across the interface compensate the lattice mismatch at the interfaces, as well as deformations of Ag-O bonds. Furthermore, our work opens up a new avenue for a much wider range of interfacial structures, allow for a higher diversity of structures, and shine light on tailoring crystal structures, morphologies, and the resulting properties.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

Atomic Gradient Structures: Atomic Gradient Structure Alters Electronic Structure in 3D across the Bulk and Enhances Photoactivity

Understanding structure–function relationships enables the design of materials with tailored functionalities. The long-standing challenge is to design materials with high active volume to improve the efficiency. Tailored grain boundaries and lattice defects are traditionally used to tune the electronic structure near interfaces or defects to promote electron and hole separation. However, the active volume of point defect sites or interfaces in these traditional photocatalysts is extremely low. In this work, we report a structure with continuous atomic positional deformation across the bulk, altering the electronic structure in three-dimension and creating a significantly high active volume. Such a structure in anatase is obtained and tuned by phase transformation during heating process. Transmission electron microscopy and density functional theory results reveal that atomic deformations result in continuous band bending across the particles, facilitating electron–hole separation, inhibiting their recombination, and inducing dramatically enhanced photoactivity. These findings enable a different materials design paradigm that can potentially be harnessed for a broad range of applications.

TiO2↗