Engineering topics
Sun, J.
Publications and source records attributed to Sun, J..
The effect of pebble friction on pattern of pebble packing - 18371
To study the influence of friction coefficient of fuel pebble on pebble packing structure in the pebble bed type high temperature reactor (HTR), 3D numerical simulation has been carried out. To reveal the packing structure, the packing fraction distribution, contact number distribution and Delaunay/Voronoi based cell volume distributions are investigated. It demonstrates that friction plays a pivotal role in determining the final static packing in pebble beds, and attention should be paid to the change of friction coefficient of pebbles when packing structure is particularly concerned in a pebble bed reactor. Furthermore, by digging out the regular tetrahedrons, it reveals that there are not concentrated regular structures near the wall. (authors)
Benchmark tests of a strongly constrained semilocal functional with a long-range dispersion correction
Not Available
Coexistence of Weyl physics and planar defects in the semimetals TaP and TaAs
We report a structural study of the Weyl semimetals TaAs and TaP, utilizing diffraction and imaging techniques, where we show that they contain a high density of defects, leading to nonstoichiometric single crystals of both semimetals. Despite the observed defects and nonstoichiometry on samples grown using techniques already reported in the literature, de Haas–van Alphen measurements on TaP reveal quantum oscillations and a high carrier mobility, an indication that the crystals are of quality comparable to those reported elsewhere. Electronic structure calculations on TaAs reveal that the position of the Weyl points relative to the Fermi level shift with the introduction of vacancies and stacking faults. In the case of vacancies the Fermi surface becomes considerably altered, while the effect of stacking faults on the electronic structure is to allow the Weyl pockets to remain close to the Fermi surface. The observation of quantum oscillations in a nonstoichiometric crystal and the persistence of Weyl fermion pockets near the Fermi surface in a crystal with stacking faults point to the robustness of these quantum phenomena in these materials.
Influence of emission threshold of explosive emission cathodes on current waveform in foilless diodes
The emission threshold of explosive emission cathodes (EECs) is an important factor for beam quality. It can affect the explosive emission delay time, the plasma expansion process on the cathode surface, and even the current amplitude when the current is not fully space-charge-limited. This paper researches the influence of the emission threshold of an annular EEC on the current waveform in a foilless diode when the current is measured by a Rogowski coil. The particle-in-cell simulation which is performed under some tolerable and necessary simplifications shows that the long explosive emission delay time of high-threshold cathodes may leave an apparent peak of displacement current on the rise edge of the current waveform, and this will occur only when the electron emission starts after this peak. The experimental researches, which are performed under a diode voltage of 1 MV and a repetitive frequency of 20 Hz, demonstrate that the graphite cathode has a lower emission threshold and a longer lifetime than the stainless steel cathode according to the variation of the peak of displacement current on the rise edge of the current waveform.
A family of rare earth molybdenum bronzes: Oxides consisting of periodic arrays of interacting magnetic units
The family of rare earth molybdenum bronzes, reduced ternary molybdates of composition LnMo{sub 16}O{sub 44,} was synthesized and a detailed structural study carried out. Bond valence sum (BVS) calculations clearly show that the molybdenum ions in tetrahedral coordination are hexavalent while the electron count in the primitive unit cell is odd. Yet, measurements show that the phases are semiconductors. The temperature dependence of the magnetic susceptibility of samples containing several different rare earth elements was measured. These measurements verified the presence of a 6.5 K magnetic phase transition not arising from the rare earth constituent, but likely associated with the unique isolated ReO{sub 3}-type Mo{sub 8}O{sub 36} structural subunits in this phase. To better understand the behavior of these materials, electronic structure calculations were performed within density functional theory. Results suggest a magnetic state in which these structural moieties have an internal ferromagnetic arrangement, with small ~1/8 μ{sub B} moments on each Mo. We suggest that the Mo{sub 8}O{sub 36} units behave like pseudoatoms with spin 1/2 derived from a single hole distributed over the eight Mo atoms that are strongly hybridized with the O atoms of the subunit. Interestingly, while the compound is antiferromagnetic, our calculations suggest that a field-stabilized ferromagnetic state, if achievable, will be a narrow band half-metal. - Graphical abstract: LnMo{sub 16}O{sub 44} phases comprise corner sharing tetrahedral and octahedral molybdenum ions. The MoO{sub 6} octahedra form Mo{sub 8}O{sub 36} units that are well separated and act like pseudo-atoms, accommodating 11 electrons each. - Highlights: • Single crystal X-ray diffraction refinements of LnMo{sub 16}O{sub 44} single crystals for Ln=Ce, Pr, Nd, Tb, Dy and Ho. • DFT calculations based on LaMo{sub 16}O{sub 44}. • [Mo{sub 8}O{sub 36}] units behaving as superatoms with a net magnetic moment of 1 µ{sub B}. • Bronze structure containing equal number of molybdenum tetrahedra and octahedral.
The influence of ions and the induced secondary emission on the nanosecond high-gradient microwave breakdown at metal surface
The mechanism of ultrafast breakdown at metal/vacuum interface in the high-power microwave waveguides is studied. In order to realize the nanosecond discharge, the required ambient gas pressure above the metal surface is approximately calculated as high as several Torr due to the low ionization-rate for high-energy electrons and short pulse. The local high pressure may come from the evaporated microscopic protrusions due to Joule heating and gas desorption. Besides, ions accelerated by the ambient space charge field could obtain sufficient high energy to collide and sputter the metal atoms to increase the ambient pressure. The positive feedbacks during the rapid discharge are studied by particle-in-cell simulation. The relatively high-energy ions could generate secondary electrons. It is shown that, as the positive feedback, the secondary electrons induce the gas desorption and stronger ionization, resulting in ion and electron density increasing as well as sheath field further increasing. As a result, more higher-energy ions bombard metal surface, leading to higher secondary electron yield and higher density plasma generated to cut off the microwave transmission finally. These nonlinear courses realize the ultrafast discharge in waveguides.
Ba{sub 2}TeO: A new layered oxytelluride
Single crystals of the new semiconducting oxytelluride phase, Ba{sub 2}TeO, were synthesized from barium oxide powder and elemental tellurium in a molten barium metal flux. Ba{sub 2}TeO crystallizes in tetragonal symmetry with space group P4/nmm (#129), a=5.0337(1) Å, c=9.9437(4) Å, Z=2. The crystals were characterized by single crystal x-ray diffraction, heat capacity and optical measurements. The optical measurements along with electronic band structure calculations indicate semiconductor behavior with a band gap of 2.93 eV. Resistivity measurements show that Ba{sub 2}TeO is highly insulating. - Graphical abstract: Starting from a simple stacking of rocksalt layers, the final structure of Ba{sub 2}TeO can be obtained by accommodation of structural strain via atom displacements. Density of states calculations and optical absorbance measurements show that Ba{sub 2}TeO has a band gap of 2.93 eV, indicative of semiconductor behavior. - Highlights: • Single crystal synthesis of a new layered oxytelluride, Ba{sub 2}TeO. • The structure features inverse PbO-type BaO layers and NaCl-type BaTe layers. • Optical absorbance show Ba{sub 2}TeO to be a semiconductor with a 2.93 eV gap. • Density of states indicate a small hybridization between Te 5p and Ba 5d states. • The BaTe (BaO) layers dominate the heat capacity at low (high) temperatures.
Complex magnetism and strong electronic correlations in Ce 2 PdGe 3
Single-crystal x-ray diffraction, magnetic susceptibility, magnetization, heat capacity, and electrical resistivity measurements are reported for the new tetragonal compound Ce 2 PdGe 3 , which forms in the space group P4 2 /mmc (No. 131)—a relative of the α₋ThSi 2 -type structure. Measurements reveal a two-part antiferromagnetic phase transition at T N,1 =10.7 K and T N,2 =9.6 K and subsequent ferromagnetlike ordering near TC≈2.25 K. The ordered ground state emerges from a lattice of Ce ions that are hybridized with the conduction electrons, as revealed by the enhanced electronic coefficient of the specific heat γ≈50 mJ/mol-Ce-K 2 (extrapolated to T=0 for T < T C ). Lastly, electronic structure calculations reveal a Fermi surface that includes sheets with distinct nesting vectors. We find chemical/structural disorder also plays an important role, as evidenced by results from single-crystal x-ray diffraction, the width of the peaks in the heat capacity at T N and T C , and the small residual resistivity ratio RRR=ρ300K/ρ0=1.8.
A unique DNA entry gate serves for regulated loading of the eukaryotic replicative helicase MCM2-7 onto DNA
N/A
Crystallographic study of FABP5 as an intracellular endocannabinoid transporter
FABP5 was recently found to intracellularly transport endocannabinoid signaling lipids. The structures of FABP5 complexed with two endocannabinoids and an inhibitor were solved. Human FABP5 was found to dimerize via a domain-swapping mechanism. This work will help in the development of inhibitors to raise endocannabinoid levels. In addition to binding intracellular fatty acids, fatty-acid-binding proteins (FABPs) have recently been reported to also transport the endocannabinoids anandamide (AEA) and 2-arachidonoylglycerol (2-AG), arachidonic acid derivatives that function as neurotransmitters and mediate a diverse set of physiological and psychological processes. To understand how the endocannabinoids bind to FABPs, the crystal structures of FABP5 in complex with AEA, 2-AG and the inhibitor BMS-309403 were determined. These ligands are shown to interact primarily with the substrate-binding pocket via hydrophobic interactions as well as a common hydrogen bond to the Tyr131 residue. This work advances our understanding of FABP5–endocannabinoid interactions and may be useful for future efforts in the development of small-molecule inhibitors to raise endocannabinoid levels.
Biological Conversion of Biomass for Fuels and Chemicals: Explorations from Natural Utilization Systems
Abstract not provided
Chapter 1: Biomass and its Biorefinery: Novel Approaches from Nature-Inspired Strategies and Technology
Abstract not provided
Resonator-quantum well infrared photodetectors
We applied a recent electromagnetic model to design the resonator-quantum well infrared photodetector (R-QWIP). In this design, we used an array of rings as diffractive elements to diffract normal incident light into parallel propagation and used the pixel volume as a resonator to intensify the diffracted light. With a proper pixel size, the detector resonates at certain optical wavelengths and thus yields a high quantum efficiency (QE). To test this detector concept, we fabricated a number of R-QWIPs with different quantum well materials and detector geometries. The experimental result agrees satisfactorily with the prediction, and the highest QE achieved is 71%.
Improvements in the realization of the ITS-90 over the temperature range from the melting point of gallium to the freezing point of silver at NIM
The temperature primary standard over the range from the melting point of gallium to the freezing point of silver in National institute of Metrology (NIM), China, was established in the early 1990s. The performance of all of fixed-point furnaces degraded and needs to be updated due to many years of use. Nowadays, the satisfactory fixed point materials can be available with the development of the modern purification techniques. NIM plans to use a group of three cells for each defining fixed point temperature. In this way the eventual drift of individual cells can be evidenced by periodic intercomparison and this will increase the reliability in disseminating the ITS-90 in China. This article describes the recent improvements in realization of ITS-90 over temperature range from the melting point of gallium to the freezing point of silver at NIM. Taking advantages of the technological advances in the design and manufacture of furnaces, the new three-zone furnaces and the open-type fixed points were developed from the freezing point of indium to the freezing point of silver, and a furnace with the three-zone semiconductor cooling was designed to automatically realize the melting point of gallium. The reproducibility of the new melting point of gallium and the new open-type freezing points of In, Sn, Zn. Al and Ag is improved, especially the freezing points of Al and Ag with the reproducibility of 0.2mK and 0.5mK respectively. The expanded uncertainty in the realization of these defining fixed point temperatures is 0.34mK, 0.44mK, 0.54mK, 0.60mK, 1.30mK and 1.88mK respectively.