Engineering topics

Stough, H. P., III

Publications and source records attributed to Stough, H. P., III.

15 records

NASA NTRS1993

NASA wake vortex research

NASA is conducting research that will enable safe improvements in the capacity of the nation's air transportation system. The wake-vortex hazard is a factor in establishing the minimum safe spacing between aircraft during landing and takeoff operations and, thus, impacts airport capacity. The ability to accurately model the wake hazard and determine safe separation distances for a wide range of aircraft and operational scenarios may provide the basis for significant increases in airport capacity. Current and planned NASA research is described which is focused on increasing airport capacity by safely reducing wake-hazard-imposed aircraft separations through advances in a number of technologies including vortex motion and decay prediction, vortex encounter modeling, wake-vortex hazard characterization, and in situ flow sensing.

Stough, H. P., III↗

NASA NTRS1991

Tail venting for enhanced yaw damping at spinning conditions

An investigation was conducted in the NASA Langley 20-ft Vertical Spin Tunnel to determine the spin and spin-recovery characteristics of a 1/11-scale model of a low-wing general aviation airplane with a horizontal tail modified with variable-size gaps to allow ventilation of the vertical stabilizer and rudder. Erect spins at symmetric loadings were tested with varying gap sizes on either or both sides of the horizontal tail. The model results indicate that the basic airplane (with no gaps) exhibits a fast, flat spin from which no recoveries can be obtained. The airplane with the modified tail has either a fast, flat spin from which no recoveries or poor recoveries may be made, or a slower, steeper spin from which fair to excellent recoveries may be obtained, depending on the size and orientation of the tail gaps. The major contribution to spin recovery was from the gap on the leeward side of the tail. Gap widths of 15-25 percent of the tail semispan were needed to produce satisfactory recovery from the flat spin.

Stough, H. P., III↗

NASA NTRS1990

Wingtip vortex turbine investigation for vortex energy recovery

A flight test investigation has been conducted to determine the performance of wingtip vortex turbines and their effect on aircraft performance. The turbines were designed to recover part of the large energy loss (induced drag) caused by the wingtip vortex. The turbine, driven by the vortex flow, reduces the strength of the vortex, resulting in an associated induced drag reduction. A four-blade turbine was mounted on each wingtip of a single-engine, T-tail, general aviation airplane. Two sets of turbine blades were tested, one with a 15' twist (washin) and one with no twist. Th power recovered by the turbine and the installed drag increment were measured. A trade-off between turbine power and induced drag reduction was found to be a function of turbine blade incidence angle. This test has demonstrated that the wingtip vortex turbine is an attractive alternate, as well as an emergency, power source.

Abeyounis, William K.↗

NASA NTRS1989

Investigations of modifications to improve the spin resistance of a high-wing, single-engine, light airplane

A general aviation aircraft with drooped leading edge modifications for improvement of lateral stability at high angles of attack has been flight tested in combination with a ventral fin which improves directional stability. The two modifications were assessed in light of spin-resistance criteria proposed for incorporation into FAA certification regulations. The configuration combining outboard wing leading-edge droop and a ventral fin yielded a substantial increase in spin resistance, but fell short of all requirements encompassed by the proposed spin-resistance criteria.

Manuel, G. S.↗

NASA NTRS1986

Separated flow

A brief overview of flow separation phenomena is provided. Langley has many active research programs in flow separation related areas. Three cases are presented which describe specific examples of flow separation research. In each example, a description of the fundamental fluid physics and the complexity of the flow field is presented along with a method of either reducing or controlling the extent of separation. The following examples are discussed: flow over a smooth surface with an adverse pressure gradient; flow over a surface with a geometric discontinuity; and flow with shock-boundary layer interactions. These results will show that improvements are being made in the understanding of flow separation and its control.

Sellers, W. L., III↗

NASA NTRS1986

Summary of NASA stall/spin research for general aviation configurations

The major milestones of stall/spin research conducted in the past under NACA/NASA programs are reviewed, and recent results offering promise for further improvements in design methodology and concepts for stall/spin technology are identified. Specific results discussed include: (1) development and validation of test techniques and analysis methods; (2) studies of airplane spinning and spin recovery characteristics; and (3) concepts designed to increase the spin resistance of general aviation-type vehicles.

Chambers, J. R.↗

NASA NTRS1986

Development of spin resistance criteria for light general aviation airplanes

A brief history of stall/spin technology for light general aviation airplanes is presented. Criteria needed to describe desirable characteristics of a spin-resistant airplane and means to evaluate airplanes for compliance with the criteria have been developed. Initial results from limited flight tests of an experimental high-wing airplane indicated that the basic configuration would not meet the spin resistance criteria. Further tests with the airplane modified to enhance its spin resistance are planned.

Dicarlo, D. J.↗

NASA NTRS1985

Leading-edge design for improved spin resistance of wings incorporating conventional and advanced airfoils

Discontinuous wing leading-edge droop designs have been evaluated as a means of modifying wing autorotative characteristics and thus improving airplane spin resistance. Addition of a discontinuous outboard wing leading-edge droop to three typical light airplanes having NACA 6-series wing sections produced significant improvements in stall characteristics and spin resistance. Wind tunnel tests of two wings having advanced natural laminar flow airfoil sections indicated that a discontinuous leading-edge droop can delay the onset of autorotation at high angles of attack without adversely affecting the development of laminar flow at cruise angles of attack.

Stough, H. P., III↗

NASA NTRS1985

Flight investigation of stall, spin and recovery characteristics of a low-wing, single-engine, T-tail light airplane

Flight tests were performed to investigate the stall, spin, and recovery characteristics of a four-place, low-wing, single-engine, T-tail, general aviation research airplane at an aft center-of-gravity position. Most stalls resulted in roll-offs. Spins were oscillatory in roll and pitch at 43 deg angle of attack; the magnitude of the oscillations was determined by aileron position. Power, flap deflection, and landing gear position did not affect the angle of attack to the spin. Antispin rudder followed by forward wheel with ailerons neutral produced the fastest and most consistent recoveries but the initial application of recovery controls did not always stop a spin.

Stough, H. P., III↗

NASA NTRS1984

Wing design for spin resistance

Use of a discontinuous outboard wing leading edge to improve stall/spin characteristics has been evaluated through wind-tunnel and flight tests. Addition of such a discontinuous outboard wing leading-edge droop design to three light airplanes having NACA 6-series airfoil sections produced significant improvements in stall characteristics and spin resistance. The increased spin resistance of the modified airplanes has been related to the difference in angle of attack between the outer wing panel stall and the maximum attainable angle of attack.

Stough, H. P., III↗

NASA NTRS1980

Spinning for safety's sake

NASA Langley is currently engaged in a comprehensive research program to improve the stall/spin characteristics of general aviation airplanes. Part of this program has included systematic flight tests of a fully instrumented airplane to determine the effects of various tail, wing, and fuselage modifications, and variation of inertia, center-of-gravity, and control positions on the spin and recovery characteristics. Airplane equipment, onboard instrumentation ground equipment, test area, and test procedures have been combined to provide a safe, practical means for conducting research in preplanned hazardous conditions. Configuration changes produced spins varying from easily recoverable to unrecoverable, and wind section design significantly influenced airplane stall, spin, and recovery characteristics.

Stough, H. P., III↗

NASA NTRS1980

Effects of discontinuous drooped wing leading-edge modifications on the spinning characteristics of a low-wing general aviation airplane

Wind tunnel and flight tests were conducted to determine the effects of several discontinuous drooped wing leading-edge configurations on the spinning characteristics of a light, single-engine, low-wing research airplane. Particular emphasis was placed on the identification of modifications which would improve the spinning characteristics. The spanwise length of a discontinuous outboard droop was varied and several additional inboard segments were added to determine the influence of such leading-edge configurations on the spin behavior. Results of the study indicated that the use of only the discontinuous outboard droop, over a specific spanwise area, was most effective towards improving spin and spin recovery characteristics, whereas the segmented configurations having both inboard and outboard droop exhibited a tendency to enter a flat spin.

Dicarlo, D. J.↗

NASA NTRS1979

The effects of configuration changes on spin and recovery characteristics of a low-wing general aviation research airplane

A fully instrumented, low-wing, single-engine general aviation airplane has been spin tested. Several tail configurations, wing leading-edge modifications, fuselage modifications, moment-of-inertia variations, center-of-gravity positions, and control inputs have been tested to determine their effect on spinning and spin recovery. Results indicate that wing airfoil design can significantly influence airplane spin and recovery characteristics and can overpower the effects of tail design. Results also point out a need to determine limitations of such factors as Reynolds number in model spin test techniques and high angle-of-attack aerodynamics.

Stough, H. P., III↗

NASA NTRS1979

Spin flight research summary

An extensive general aviation stall/spin research program is underway at the NASA Langley Research Center. Flight tests have examined the effects of tail design, wing leading edge design, mass distribution, and minor airframe modifications on spin and recovery characteristics. Results and observations on test techniques are presented for the first airplane in the program. Configuration changes produced spins varying from easily recoverable slow, steep spins to unrecoverable, fast flat spins.

Patton, J. M., Jr.↗

NASA NTRS1978

A flight evaluation of a trailing anemometer for low-speed calibrations of airspeed systems on research aircraft

Research airspeed systems on three low-speed general aviation airplanes were calibrated by the trailing anemometer method. Each airplane was fitted with an NASA pitot-static pressure tube mounted on either a nose or wing boom. The uncalibrated airspeed systems contained residual static-pressure position errors which were too large for high-accuracy flight research applications. The trailing anemometer calibration was in agreement with the tower flyby calibration for the one aircraft for which the comparison was made. The continuous deceleration technique for the trailing anemometer method offers reduced test time with no appreciable loss of accuracy for airspeed systems with pitot-static system lag characteristics similar to those described.

Fisher, B. D.↗