Engineering Papers⌕ Search

Engineering topics

Stoeckl, C

Publications and source records attributed to Stoeckl, C.

79 records · Page 5

Shock Ignition of Thermonuclear Fuel with High Areal Densities

In thick shell implosions, most of the kinetic energy is used to assemble the cold fuel rather than to heat the hot spot. A significant increase in the hot-spot compression and reduction of the driver energy required for ignition can be accomplished by launching a shock during the final stage of the implosion. In direct-drive inertial confinement fusion (ICF), the “ignitor” shock can be launched by a power spike at the end of the laser pulse. For targets with the same adiabat and implosion velocities, the laser energy required for ignition is significantly lower for shock-ignition ICF than for standard ICF.

Betti, R↗

Hohlraum Energetics and Implosion Symmetry with Elliptical Phase Plates Using a Multi-Cone Beam Geometry on OMEGA

Hohlraum energetics and implosion-symmetry experiments were conducted on the OMEGA Laser System using laser beams arranged in three cones and smoothed with elliptical phase plates. The peak radiation temperature (Tr) increased by 17 eV, with phase plates for gas-filled halfraums irradiated with 20 beams using a ~7-kJ shaped laser pulse (PS26), corresponding to a 44% increase in the peak x-ray flux. The improved coupling correlates with reduced, cone-dependent losses from stimulated Raman scattering (SRS) and stimulated Brillouin scattering (SBS). Phase plates reduce SRS and SBS by controlling the on-target laser-intensity envelope and the speckle modal power spectrum. An implosion symmetry scan was performed by varying the length and beam pointing of vacuum and gas-filled, thin-walled (3 um) Au hohlraums irradiated with 40 beams using a ~14-kJ PS26. Gated-x-ray (hv > 3 keV) images taken along radial and axial views of the self-emission from Ar-doped, D2-filled, plastic-shell implosions quantified the indirect-drive-implosion symmetry. A shift in symmetry was observed between vacuum and gas-filled hohlraums having identical beam pointing. The ratio of x-ray drive at the poles of the capsule relative to the waist increased for the gas-filled hohlraum. Levels of hard-x-ray production (hv > 20 keV) and SRS were reduced with trace amounts of high-Z dopants (i.e., Ne, Kr) in the hohlraum plasma, while the peak Tr increased ~5 eV.

Regan, S P↗

Rayleigh-Taylor Growth Stabilization in Direct-Drive Plastic Targets at Laser Intensities of ~1 x 10^15 W/cm^2

Direct-drive, planar-target Rayleigh-Taylor growth experiments were performed for the first time to test fundamental physics in hydrocodes at peak drive intensities of ignition designs. The unstable modulation growth at a drive intensity of ~1 X 10^15 W/cm^2 was strongly stabilized compared to the growth at an intensity of ~5 x 10^14 W/cm^2. The experiments demonstrate that standard simulations based on a local model of electron thermal transport break down at peak intensities of ignition designs (although they work well at lower intensities). The preheating effects by nonlocal electron transport and hot electrons were identified as some of the stabilizing mechanisms.

Smalyuk, V A↗

OMEGA EP High-Energy Petawatt Laser: Progress and Prospects

OMEGA EP (extended performance) is a petawatt-class addition to the existing 30-kJ, 60-beam OMEGA Laser Facility at the University of Rochester. It will enable high energy picosecond backlighting of high-energy-density experiments and inertial confinement fusion implosions, the investigation of advanced-ignition experiments such as fast ignition, and the exploration of high-energy-density phenomena. The OMEGA EP short-pulse beams have the flexibility to be directed to either the existing OMEGA target chamber, or the new, auxiliary OMEGA EP target chamber for independent experiments. This paper will detail progress made towards activation, which is on schedule for completion in April 2008.

Maywar, D N↗

Cryogenic Target-Implosion Experiments on OMEGA

The University of Rochester’s Laboratory for Laser Energetics has been imploding thick cryogenic targets for six years. Improvements in the Cryogenic Target Handling System and the ability to accurately design laser pulse shapes that properly time shocks and minimize electron preheat, produced high fuel areal densities in deuterium cryogenic targets (202+/-7 mg/cm^2). The areal density was inferred from the energy loss of secondary protons in the fuel (D2) shell. Targets were driven on a low final adiabat (alpha = 2) employing techniques to radially grade the adiabat (the highest adiabat at the ablation surface). The ice layer meets the target-design toughness specification for DT ice of 1-um rms (all modes), while D2 ice layers average 3.0-um-rms roughness. The implosion experiments and the improvements in the quality and understanding of cryogenic targets are presented.

Harding, D R↗

The Role of Fast-Electron Preheating in Low-Adiabat Cryogenic Implosions on OMEGA

The compression in direct-drive, low-adiabat spherical implosions was studied using cryogenic D2 targets on the 60-beam, 351-nm OMEGA laser in the range of laser intensities from ~3 x 10^14 to ~1.5 x 10^15 W/cm^2. The neutron-burn–averaged areal densities decreased as the laser intensity increased. This decrease in areal density is highly correlated with the increased hard-x-ray signals, caused by hot electrons generated by the two-plasmon-decay instability. The areal-density reduction up to ~2, observed in the experiments, requires a preheat energy of ~60 J (~0.3% of total laser energy), which is consistent with the estimated preheat levels inferred from the hard-x-ray signal levels. Mitigating the generation of fast-electrons results in high areal densities which are close to the 1D predictions.

Shvarts, D↗

Modeling High-Compression, Direct-Drive, ICF Experiments

The success of direct-drive-ignition target designs depends on two issues: the ability to maintain the main fuel entropy at a low level and the control of the nonuniformity growth during the implosion. Modelling the ICF experiments requires an accurate account for all sources of shell heating, including the shock heating, radiation and suprathermal electrons preheat, and small-scale perturbation growth. To increase calculation accuracy, a new heat-transport model has been developed and implemented in the 1-D hydrocode LILAC. This model includes both the effect of the resonance absorption and the nonlocal thermal transport. The OMEGA experiments designed with the help of the new model have achieved high-areal-density pR > 200 mg/cm^2) fuel assembly in the low-adiabat cryogenic shell implosions.

Goncharov, V N↗