Engineering topics

Stirn, R. J.

Publications and source records attributed to Stirn, R. J..

At least 37 records · Page 2

NASA NTRS1979

High-efficiency thin-film GaAs solar cells

GaAs chemical vapor deposition (CVD) growth on single-crystal GaAs substrates was investigated over a temperature range of 600 to 750 C, As/GA mole-ratio range of 3 to 11, and gas molefraction range 5 x 10 to the minus 9th power to 7x 10 to the minus 7th power for H2S doping. GasAs CVD growth on recrystallized Ge films was investigated for a temperature range of 550 to 700 C, an As/GA mole ratio of 5, and for various H2S mole fraction. The highest efficiency cell observed on these films with 2 mm dots was 4.8% (8% when AR-coated). Improvements in fill factor and opencircuit voltage by about 40% each are required in order to obtain efficiencies of 15% or greater.

Stirn, R. J.↗

NASA NTRS1978

A Schottky-barrier solar cell on sliced polycrystalline GaAs

Antireflecting-metal-oxide-semiconductor (AMOS) technology has been applied to sliced wafers of polycrystalline GaAs having grain sizes of about 100 microns. Simulated AM1 sunlight efficiencies up to 14% were obtained, and studies using the scanning electron microscope showed that grain boundaries have a minimal effect on short-circuit current density. However, current-voltage characteristics show some influence on open-circuit voltage.

Yeh, Y. C. M.↗

NASA NTRS1978

Overview of novel photovoltaic conversion techniques at high intensity levels

The paper describes several photovoltaic devices currently under development that can operate under light intensities considerably higher than can silicon solar cells. The technologies discussed include GaAs heteroface solar cells, multi-color systems, thermophotovoltaics, and laser energy conversion. Array costs for the GaAs and multi-color elements are estimated.

Stirn, R. J.↗

NASA NTRS1978

Progress towards high efficiency polycrystalline thin-film GaAs AMOS solar cells

Results of Ge film recrystallization using focused laser beams and GaAs film growth on such layers in the making of high efficiency thin-film AMOS solar cells are discussed. Since a conversion efficiency of 14% was obtained for an AMOS cell fabricated on sliced bulk polycrystalline GaAs, high efficiency cells are being developed by chemically vapor-depositing GaAs films on previously recrystallized evaporated Ge films to minimize the grain boundary (GB) effects. Schottky barrier solar cells made on sliced polycrystalline GaAs wafers were studied to investigate the effects of grain boundaries on cell properties and the potential efficiency of GaAs thin-film cells. Ge film recrystallization and the chemical vapor deposition (CVD) of the 2 to 3 micron thick GaAs films are described. AMOS solar cells with 100 Angstrom thick Ag metallization were made on CVD GaAs/recrystallized Ge/W substrates with an energy conversion efficiency of 8%.

Yeh, Y. C. M.↗

NASA NTRS1977

High voltage, high current Schottky barrier solar cell

A Schottky barrier solar cell was described, which consists of a layer of wide band gap semiconductor material on which a very thin film of semitransparent metal was deposited to form a Schottky barrier. The layer of the wide band gap semiconductor material is on top of a layer of narrower band gap semiconductor material, to which one of the cell's contacts may be attached directly or through a substrate. The cell's other contact is a grid structure which is deposited on the thin metal film.

Stirn, R. J.↗

NASA NTRS1977

High efficiency thin-film GaAs solar cells

Several oxidation techniques are discussed which have been found to increase the open circuit (V sub oc) of metal-GaAs Schottky barrier solar cells, the oxide chemistry, attempts to measure surface state parameters, the evolving characteristics of the solar cell as background contamination (has been decreased, but not eliminated), results of focused Nd/YAG laser beam recrystallization of Ge films evaporated onto tungsten, and studies of AMOS solar cells fabricated on sliced polycrystalline GaAs wafers. Also discussed are projected materials availability and costs for GaAs thin-film solar cells.

Stirn, R. J.↗

NASA NTRS1977

Investigation of the double exponential in the current-voltage characteristics of silicon solar cells

Difficulties in relating observed current-voltage characteristics of individual silicon solar cells to their physical and material parameters were underscored by the unexpected large changes in the current-voltage characteristics telemetered back from solar cells on the ATS-1 spacecraft during their first year in synchronous orbit. Depletion region recombination was studied in cells exhibiting a clear double-exponential dark characteristic by subjecting the cells to proton irradiation. A significant change in the saturation current, an effect included in the Sah, Noyce, Shockley formulation of diode current resulting from recombination in the depletion region, was caused by the introduction of shallow levels in the depletion region by the proton irradiation. This saturation current is not attributable only to diffusion current from outside the depletion region and only its temperature dependence can clarify its origin. The current associated with the introduction of deep-lying levels did not change significantly in these experiments.

Wolf, M.↗

NASA NTRS1977

Technology of GaAs metal-oxide-semiconductor solar cells

The growth of an oxide interfacial layer was recently found to increase the open-circuit voltage (OCV) and efficiency by up to 60 per cent in GaAs metal-semiconductor solar cells. Details of oxidation techniques to provide the necessary oxide thickness and chemical structure and using ozone, water-vapor-saturated oxygen, or oxygen gas discharges are described, as well as apparent crystallographic orientation effects. Preliminary results of the oxide chemistry obtained from X-ray, photoelectron spectroscopy are given. Ratios of arsenic oxide to gallium oxide of unity or less seem to be preferable. Samples with the highest OVC predominantly have As(+3) in the arsenic oxide rather than As(+5). A major difficulty at this time is a reduction in OCV by 100-200 mV when the antireflection coating is vacuum deposited.

Stirn, R. J.↗

NASA NTRS1977

Optimum antireflection coating for Antireflection-coated Metal-Oxide-Semiconductor /AMOS/ solar cells

Consideration is given to the design of a single-layer optimum antireflection coating for AMOS (antireflection-coated metal-oxide-semiconductor) solar cells to match the entire sunlight spectrum. The energy conversion efficiency is maximized by maximizing the open-circuit voltage and the short-circuit current. The former is maximized by oxidation techniques and the latter is maximized by the light-coupling into the solar cell. With reference to the effective index of refraction as obtained by ellipsometry, examples of optimum antireflection coatings for 60-A Au-GaAs solar cells are presented.

Yeh, Y. C. M.↗

NASA NTRS1976

Practical antireflection coatings for metal-semiconductor solar cells

The metal-semiconductor solar cell is a potential candidate for converting solar energy to electrical energy for space and terrestrial application. In this paper, a method for obtaining parameters of practical antireflection (AR) coatings for the metal-semiconductor solar cells is given. This method utilizes the measured equivalent index of refraction obtained from ellipsometry, since the surface to be AR coated has a multilayer structure. Both the experimental results and theoretical calculations of optical parameters for Ta2O5 AR coatings on Au-GaAs and Au-GaAs(0.78)P(0.22) solar cells are presented for comparison.

Yeh, Y. C. M.↗

NASA NTRS1976

Photovoltaic conversion of laser energy

The Schottky barrier photovoltaic converter is suggested as an alternative to the p/n junction photovoltaic devices for the conversion of laser energy to electrical energy. The structure, current, output, and voltage output of the Schottky device are summarized. The more advanced concepts of the multilayer Schottky barrier cell and the AMOS solar cell are briefly considered.

Stirn, R. J.↗

NASA NTRS1976

Investigation of the double exponential in the current-voltage characteristics of silicon solar cells

A theoretical analysis is presented of certain peculiarities of the current-voltage characteristics of silicon solar cells, involving high values of the empirical constant A in the diode equation for a p-n junction. An attempt was made in a lab experiment to demonstrate that the saturation current which is associated with the exponential term qV/A2kT of the I-V characteristic, with A2 roughly equal to 2, originates in the space charge region and that it can be increased, as observed on ATS-1 cells, by the introduction of additional defects through low energy proton irradiation. It was shown that the proton irradiation introduces defects into the space charge region which give rise to a recombination current from this region, although the I-V characteristic is, in this case, dominated by an exponential term which has A = 1.

Wolf, M.↗

NASA NTRS1976

Single crystal and polycrystalline GaAs solar cells using AMOS technology

A description is given of current technology for fabricating single AMOS (antireflection-coated metal oxide semiconductor) solar cells, with attention given to thermal, plasma, and anodic oxidation, native oxide stripping, and X-ray photoelectron spectroscopy results. Some preliminary results are presented on the chemistry and electrical characterization of such cells, and the characteristics of cells fabricated on sliced polycrystalline GaAs wafers are examined. Consideration is also given to the recrystallization of evaporated Ge films for use as low-cost substrates for polycrystalline GaAs solar cells.

Stirn, R. J.↗

NASA NTRS1975

Low cost AMOS solar cell development

Recent developments at JPL have demonstrated that high conversion efficiencies are found with GaAs metal semiconductor solar cells when a particular heat treatment processing step is used to introduce an interfacial layer between the metal and the semiconductor. The new cell, called AMOS (Antireflection-Coated Metal-Oxide-Semiconductor), has open circuit voltages of 0.68-0.72 volts and efficiencies of 15% under terrestrial sunlight, as compared to values of 0.45-0.48 volts and 10%, respectively, for similar cells without an interfacial layer. Potentially higher efficiencies are feasible as further improvements are made in optimizing the interfacial layer effect and in increasing the blue response of the cells. A thin film AMOS cell is proposed that uses a thin recrystallized germanium (Ge) layer between a low cost metal substrate and the vapor phase epitaxially (VPE)-grown GaAs.

Stirn, R. J.↗

NASA NTRS1975

A 15% efficient antireflection-coated metal-oxide-semiconductor solar cell

A new effect is being developed which significantly improves the conversion efficiency of antireflection-coated metal-oxide-semiconductor (AMOS) solar cells. The effect, a marked increase in the open-circuit voltage, is produced by the addition of an oxide layer to the semiconductor. Cells using gold on n-type gallium arsenide have been made with efficiencies up to 15% in terrestrial sunlight. All processing steps are amenable to the use of low-cost polycrystalline films of GaAs in place of the single crystals now used.

Stirn, R. J.↗

NASA NTRS1975

Laser-to-electricity energy converter for short wavelengths

Short-wavelength energy converter can be made using Schottky barrier structure. It has wider band gap than p-n junction silicon semiconductors, and thus it has improved response at wavelengths down to and including ultraviolet region.

Stirn, R. J.↗

NASA NTRS1975

Schottky barrier solar cell promises improved efficiency

Higher current and higher voltage can be obtained by using Schottky barrier device with wide band-gap semiconductor as top layer and lower band-gap semiconductor underneath. Significant amount of solar radiation that is not absorbed by side band-gap material will be absorbed by narrow band-gap material.

Stirn, R. J.↗

NASA NTRS1975

Improved Schottky barrier solar cells

Schottky barrier (SB) solar cells have been fabricated for solar energy conversion using GaAs and GaAs 0.78P0.22. Conversion efficiencies of 9% for air mass zero and 12% for terrestrial sun were observed for antireflection coated GaAs0.78P0.22 SB cells. The corresponding efficiencies for GaAs SB cells were 7% and 10%, respectively. These efficiencies are for cells with no interfacial layer effect. The short circuit current density for GaAs SB cells has been improved. The use of an ellipsometer to determine the optimum antireflection coating parameters is illustrated.

Yeh, Y.-C. M.↗