Engineering topics

Staples, Edward J.

Publications and source records attributed to Staples, Edward J..

5 records

NASA NTRS1994

Versatile Dual-Channel Waveform Generator

Programmable waveform generator synthesizes two independent waveforms simultaneously at frequencies up to 250 MHz. Can be in phase or out of phase with each other. Use of commercial integrated circuits helps keep cost low. Operation governed by BASIC source code enabling any user equipped with suitable personal computer to specify waveforms. User can modify source code to satisfy special needs. Other applications include simulation of Doppler waveforms for radar, and of video signals for testing color displays and computer monitors. With eventual substitution of gallium arsenide integrated circuits for its present silicon integrated circuits, instrument able to generate waveforms with 14-bit precision and sample rates as high as 2 GHz.

Staples, Edward J.↗

NASA NTRS1992

Advanced satellite communication system

The objective of this research program was to develop an innovative advanced satellite receiver/demodulator utilizing surface acoustic wave (SAW) chirp transform processor and coherent BPSK demodulation. The algorithm of this SAW chirp Fourier transformer is of the Convolve - Multiply - Convolve (CMC) type, utilizing off-the-shelf reflective array compressor (RAC) chirp filters. This satellite receiver, if fully developed, was intended to be used as an on-board multichannel communications repeater. The Advanced Communications Receiver consists of four units: (1) CMC processor, (2) single sideband modulator, (3) demodulator, and (4) chirp waveform generator and individual channel processors. The input signal is composed of multiple user transmission frequencies operating independently from remotely located ground terminals. This signal is Fourier transformed by the CMC Processor into a unique time slot for each user frequency. The CMC processor is driven by a waveform generator through a single sideband (SSB) modulator. The output of the coherent demodulator is composed of positive and negative pulses, which are the envelopes of the chirp transform processor output. These pulses correspond to the data symbols. Following the demodulator, a logic circuit reconstructs the pulses into data, which are subsequently differentially decoded to form the transmitted data. The coherent demodulation and detection of BPSK signals derived from a CMC chirp transform processor were experimentally demonstrated and bit error rate (BER) testing was performed. To assess the feasibility of such advanced receiver, the results were compared with the theoretical analysis and plotted for an average BER as a function of signal-to-noise ratio. Another goal of this SBIR program was the development of a commercial product. The commercial product developed was an arbitrary waveform generator. The successful sales have begun with the delivery of the first arbitrary waveform generator.

Staples, Edward J.↗

NASA NTRS1992

Multi-user satellite communications system using an innovative compressive receiver

There is a need for an onboard simultaneous multi-channel demodulation system for a satellite communications system. Studies indicate that Convolve Multiply Convolve (CMC) filtering with surface acoustic wave (SAW) dispersive delay lines will eliminate the necessity of onboard satellite channelized filters of complex fourier transform processors. The reason for choosing the CMC technique is its ability to perform Fourier transformations in a shorter time with less space and power consumption than digital Fourier transform processors. Each ground terminal in this multi-users communications system is remotely located and operates independently; hence, a method of synchronizing the transmission of these users is presented which utilizes the existing Global Positioning System (GPS) system. Each ground user is equipped with a low cost ground terminal that has a synchronization subsystem attached to it. The system design of an onboard Multi-channel Receiver and Demodulator utilizes Quadrature Phase Shift Keying (QPSK) as the modulation technique. This technique provides the best figure of merit, i.e., the lowest transmitter power requirement per communication channel.

Staples, Edward J.↗

NASA NTRS1992

Multichannel demultiplexer/demodulator technologies for future satellite communication systems

NASA-Lewis' Space Electronics Div. supports ongoing research in advanced satellite communication architectures, onboard processing, and technology development. Recent studies indicate that meshed VSAT (very small aperture terminal) satellite communication networks using FDMA (frequency division multiple access) uplinks and TDMA (time division multiplexed) downlinks are required to meet future communication needs. One of the critical advancements in such a satellite communication network is the multichannel demultiplexer/demodulator (MCDD). The progress is described which was made in MCDD development using either acousto-optical, optical, or digital technologies.

Ivancic, William D.↗

NASA NTRS1991

One GHz digitizer for space based laser altimeter

This is the final report for the research and development of the one GHz digitizer for space based laser altimeter. A feasibility model was designed, built, and tested. Only partial testing of essential functions of the digitizer was completed. Hybrid technology was incorporated which allows analog storage (memory) of the digitally sampled data. The actual sampling rate is 62.5 MHz, but executed in 16 parallel channels, to provide an effective sampling rate of one GHz. The average power consumption of the one GHz digitizer is not more than 1.5 Watts. A one GHz oscillator is incorporated for timing purposes. This signal is also made available externally for system timing. A software package was also developed for internal use (controls, commands, etc.) and for data communication with the host computer. The digitizer is equipped with an onboard microprocessor for this purpose.

Staples, Edward J.↗