Engineering topics
Sprunt, S
Publications and source records attributed to Sprunt, S.
Self-assembly, condensation, and order in aqueous lyotropic chromonic liquid crystals crowded with additives
Dense multicomponent systems with macromolecules and small solutes attract a broad research interest as they mimic the molecularly crowded cellular interiors. The additives can condense and align the macromolecules, but they do not change the degree of covalent polymerization. We chose a lyotropic chromonic liquid crystal with reversibly and non-covalently assembled aggregates as a much softer system, reminiscent of 'living polymers', to demonstrate that small neutral and charged additives cause condensation of aggregates with ensuing orientational and positional ordering and nontrivial morphologies of phase separation, such as tactoids and toroids of the nematic and hexagonal columnar phase coexisting with the isotropic melt. Scanning transmission X-ray microscopy (STXM) with near edge X-ray absorption fine structure (NEXAFS) analysis as well as fluorescent microscopy demonstrates segregation of the components. The observations suggest that self-assembly of chromonic aggregates in the presence of additives is controlled by both entropy effects and by specific molecular interactions and provide a new route to the regulated reversible assembly of soft materials formed by low-molecular weight components.
Nanostructures of Liquid Crystal Phases in Mixtures of Bent-core and Rod-shaped Molecules
We report small angle x-ray scattering (SAXS) studies of isotropic, nematic, and smectic mesophases formed by binary mixtures of bent-core (BC) and rod-shaped (RS) molecules. While optical studies indicate that the components are fully miscible, SAXS reveals fascinating structures that are consistent with segregation on a nanoscopic scale. We find that tilted smectic clusters, which have been previously reported in both the nematic and isotropic states of the pure BC materials, are also present in mixtures with up to 50 wt% of the RS compound; this is consistent with previous dielectric and flexoelectric studies on such mixtures. Unexpectedly in this concentration range the clusters are present in the isotropic and in the induced smectic phase range, as well as throughout the nematic phase. The results in the smectic phase also reveal complex layering phenomena, providing important insight into the interaction between bent and rod-shaped molecules. These studies will be crucial in the design of promising new functional nanomaterials.
Bent core liquid crystal elastomers
Liquid crystal (LC) elastomers with bent-core side-groups incorporate the properties of bent-core liquid crystals in a flexible and self-supporting polymer network. Bent-core liquid crystal elastomers (BCEs) with uniform alignment were prepared by attaching a reactive bent-core LC to poly(hydrogenmethylsiloxane) and crosslinking with a divinyl crosslinker. Phase behavior studies indicate a nematic phase over a wide temperature range that approaches room temperature, and thermoelastic measurements show that these BCEs can reversibly change their length by more than a factor of two upon heating and cooling. Small-angle X-ray scattering studies reveal multiple, broad low-angle peaks consistent with short-range smectic C order of the bent-core side groups. A comparison of these patterns with predictions of a Landau model for short-range smectic C order shows that the length scale for smectic ordering in BCEs is similar to that seen in pure bent-core LCs. The combination of rubber elasticity and smectic ordering of the bent-core side groups suggests that BCEs may be promising materials for sensing, actuating, and other advanced applications.
Flexoelectricity of a Calamitic Liquid Crystal Elastomer Swollen with a Bent-core Liquid Crystal
We have measured the electric current induced by mechanical distortion of a calamitic liquid crystal elastomer (LCE) swollen with a low molecular weight bent-core nematic (BCN) liquid crystal, and have determined, for the first time, the bend flexoelectric coefficient e{sub 3} of such a BCN-LCE composite. In one method, we utilize air-pressure to induce a mechanical bend deformation and flexoelectric polarization in a BCN-LCE film, and then measure the polarization current as a function of time. An alternative technique uses a rotary-motor driven scotch yoke to periodically flex the BCN-LCE; in this case, the magnitude and phase of the induced current are recorded via a lock-in amplifier. The flexoelectric coefficient, e{sub 3}, was found to be {approx}20 nC/cm{sup 2}, and is stable in magnitude from room temperature to {approx}65 C. It is about one third the value measured in samples of the pure BCN; this fraction corresponds closely to the molar concentration of BCN in the LCE. The flexoelectric current increases linearly with the magnitude of the bend deformation and decays with frequency. These observations indicate a promising way forward towards producing very low-cost, self-standing, rugged electromechanical energy conversion devices.
Large Flow Birefringence of Nematogenic Bent-Core Liquid Crystals
We have found that bent-core liquid crystalline materials show exceptionally large intrinsic flow birefringence in their isotropic liquid phase. This effect is more than 100 times larger than typical values measured for low molecular weight liquid crystals. The specific flow birefringence (i.e., normalized by the flow viscosity) is an order of magnitude larger than in both side-chain polymeric as well as low molecular weight liquid crystals. We propose that this large enhancement for bent-core compounds may be attributed to nanoscale smecticlike clusters that persist above the nematic-isotropic transition temperature, and shear align under shear flow; however, this mechanism has not yet been definitively confirmed.