Engineering Papers⌕ Search

Engineering topics

Spisz, E. W.

Publications and source records attributed to Spisz, E. W..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

Assessment of satellite and aircraft multispectral scanner data for strip-mine monitoring

The application of LANDSAT multispectral scanner data to describe the mining and reclamation changes of a hilltop surface coal mine in the rugged, mountainous area of eastern Kentucky is presented. Original single band satellite imagery, computer enhanced single band imagery, and computer classified imagery are presented for four different data sets in order to demonstrate the land cover changes that can be detected. Data obtained with an 11 band multispectral scanner on board a C-47 aircraft at an altitude of 3000 meters are also presented. Comparing the satellite data with color, infrared aerial photography, and ground survey data shows that significant changes in the disrupted area can be detected from LANDSAT band 5 satellite imagery for mines with more than 100 acres of disturbed area. However, band-ratio (bands 5/6) imagery provides greater contrast than single band imagery and can provide a qualitative level 1 classification of the land cover that may be useful for monitoring either the disturbed mining area or the revegetation progress. However, if a quantitative, accurate classification of the barren or revegetated classes is required, it is necessary to perform a detailed, four band computer classification of the data.

Spisz, E. W.↗
NASA NTRS1978

Application of multispectral scanner data to the study of an abandoned surface coal mine

The utility of aircraft multispectral scanner data for describing the land cover features of an abandoned contour-mined coal mine is considered. The data were obtained with an 11 band multispectral scanner at an altitude of 1.2 kilometers. Supervised, maximum-likelihood statistical classifications of the data were made to establish land-cover classes and also to describe in more detail the barren surface features as they may pertain to the reclamation or restoration of the area. The scanner data for the surface-water areas were studied to establish the variability and range of the spectral signatures. Both day and night thermal images of the area are presented. The results of the study show that a high degree of statistical separation can be obtained from the multispectral scanner data for the various land-cover features.

Spisz, E. W.↗
NASA NTRS1973

Effect of contamination on the optical properties of transmitting and reflecting materials exposed to a MMH/N2O4 rocket exhaust

The changes are presented in spectral transmittance, and reflectance due to exposure of various optical materials to the exhaust plume of a 5-pound thrust bipropellant rocket. The engine was fired in a pulsed mode for a total exposure of 223.7 second. Spectral optical properties were measured in air before and after exposure to the exhaust plume in vacuum. The contaminating layer resulted in both absorption and scattering effects which caused changes as large as 30-50% for transmitting elements and 15% for mirrors in the near ultraviolet wavelengths. The changes in spectral properties of materials exposed to the exhaust plume for 44 and 223.7 seconds are compared and found to be similar.

Bowman, R. L.↗
NASA NTRS1973

Exhaust plume and contamination characteristics of a bipropellant (MMH/N2O4) RCS thruster

Results are presented for three recent tests in a series of thruster contamination experiments made in liquid helium-cooled environmental facility. The contaminating effects encountered on various materials, surfaces, and components, due to the exhaust products from a 5-pound thrust, bipropellant (MMH/N2O4) thruster are investigated. The angular distribution of plume effects around the periphery of the thruster established by transmittance changes of quartz samples over the wavelength range from 0.2 to 2.0 micrometer is studied, along with mass deposition rates at a specific location measured with a quartz crystal microbalance for three different experiments. Quadrupole mass spectrometer measurements of the exhaust products over the mass number range from 12 to 75; infrared transmittance measurements of contaminated samples for the wavelength range from 2.5 to 15 microns; and infrared transmittance measurements of residue from the thruster nozzle are also considered.

Spisz, E. W.↗
NASA NTRS1973

Plume mass flow and optical damage distributions for an MMH/N2O4 RCS thruster

The data obtained from two recent experiments conducted in a continuing series of experiments at the Lewis Research Center into the contamination characteristics of a 5-pound thrust MMH/N2O4 engine are presented. The primary objectives of these experiments were to establish the angular distribution of condensible exhaust products within the plume and the corresponding optical damage angular distribution of transmitting optical elements attributable to this contaminant. The plume mass flow distribution was measured by five quartz crystal microbalances (QCM's) located at the engine axis evaluation. The fifth QCM was located above the engine and 15 deg behind the nozzle exit plane. The optical damage was determined by ex-situ transmittance measurements for the wavelength range from 0.2 to 0.6 microns on 2.54 cm diameter fused silica discs also located at engine centerline elevation. Both the mass deposition and optical damage angular distributions followed the expected trend of decreasing deposition and damage as the angle between sensor or sample and the nozzle axis increased. A simple plume gas flow equation predicted the deposition distribution reasonably well for angles of up to 55 degrees. The optical damage measurements also indicated significant effects at large angles.

Spisz, E. W.↗
NASA NTRS1972

Improved transmittance measurement with a magnesium oxide coated integrating sphere

Simple and convenient technique has been found for extending transmittance measurement capability of conventional magnesium oxide coated integrating sphere system at low (near ultraviolet) wavelengths. Technique can be used to determine effect of contaminants on window materials and can also be used for measurements on thermal control coatings and telescope mirrors.

Bowman, R. L.↗
NASA NTRS1972

High intensity solar cell radiometer

Device can be employed under high intensity illumination conditions such as would occur in a close-solar-approach space mission or in monitoring high intensity lamps. Radiometer consists of silicon solar cells with thin semi-transparent coatings of aluminum deposited on the front surfaces to permit transmission of small percentage of light and reflect the remainder.

Brandhorst, H. W.↗
NASA NTRS1972

High solar intensity radiometer

Silicon solar cells are used to measure visible radiant energy and radiation intensities to 20 solar constants. Future investigations are planned for up to 100 solar constants. Radiometer is small, rugged, accurate and inexpensive.

Jack, J. R.↗
NASA NTRS1972

Environmental simulation from 0.01 to 100 solar constants

The design and development of two solar radiation simulators with an intensity variation ranging from 0.01 to greater than 100 solar constants under vacuum conditions are discussed. The characteristics of the simulators are presented in terms of spectral content, beam uniformity, and stability. Preliminary thermal radiative property data obtained at high temperatures are reported. The general operating characteristics of the simulator are automatic starting, control of both positive and negative electrodes, and uninterrupted operation for periods in excess of 24 hours.

Jack, J. R.↗
NASA NTRS1972

The effect of rocket plume contamination on the optical properties of transmitting and reflecting materials.

The preliminary results of plume contamination from a 5-pound thrust single-doublet, bipropellant rocket engine on the transmittance of quartz and the reflectance of a silicon monoxide overcoated aluminum mirror have been presented. Changes in quartz transmittance were found to be significant and were due to both absorption and scattering effects. Contaminant absorption effects were predominant at the short wavelengths and scattering effects were greatest in the visible wavelengths. Measured changes in mirror reflectance were due primarily to contaminant absorption. Scattering effects were found to be as much as 9% of the total reflected energy from the mirror. There were no noticeable chemical or erosion effects on either the quartz or the front surface mirror.

Jack, J. R.↗
NASA NTRS1971

Silicon solar cells as a high-solar-intensity radiometer

The characteristics of a conventional, 1- by 2-cm, N/P, gridded silicon solar cell when used as a radiometer have been determined for solar intensity levels to 2800 mW/sq cm (20 solar constants). The short-circuit current was proportional to the radiant intensity for levels only to 700 mW/sq cm (5 solar constants). For intensity levels greater than 700 mW/sq cm, it was necessary to operate the cell in a photoconductive mode in order to obtain a linear relation between the measured current and the radiant intensity. When the solar cell was biased with a reverse voltage of -1 V, the measured current and radiant intensity were linearly related over the complete intensity range from 100 to 2800 mW/sq cm.

Spisz, E. W.↗
NASA NTRS1971

Visible and near-ultraviolet spectra of low-pressure rare-gas microwave discharges

The spectral emission characteristics of three commercial low pressure rare gas discharge lamps wire obtained in the near ultraviolet and visible wavelength range. All three lamps show a definite continuum over the entire wavelength range from 0.185 to 0.6 micrometers. Considerable line emission is superimposed on much of the continuum for wavelengths greater than 0.35 micrometers. These sources were used to make transmittance measurements on quartz samples in the near ultraviolet wavelength range.

Campbell, J. P.↗
NASA NTRS1971

The effect of rocket plume contamination on the optical properties of transmitting and reflecting materials

The preliminary results of plume contamination from a 5-pound thrust single-doublet, bipropellant rocket engine on the transmittance of quartz and the reflectance of a silicon monoxide overcoated aluminum mirror are presented. Changes in quartz transmittance were found to be significant and were due to both absorption and scattering effects. Contaminant absorption effects were predominant at the short wavelengths and scattering effects were greatest in the visible wavelengths. Measured changes in mirror reflectance were due primarily to contaminant absorption. Scattering effects were found to be as much as 9 percent of the total reflected energy from the mirror. There were no noticeable chemical or erosion effects on either the quartz or the front surface mirror.

Jack, J. R.↗