Engineering topics
Spencer, D. A.
Publications and source records attributed to Spencer, D. A..
Definition of a Technology Validation Mission for P-band Reflectometry using Signals of Opportunity
Root-Zone Soil Moisture (RZSM) (moisture profile in the top meter of soil) and Snow Water Equivalent (SWE) (total snow pack water content) are identified as priority target variables in the ESAS 2017 decadal survey [1] with critical roles in hydrology and water management. RZSM estimates are vital for understanding multiple Earth system processes and forecasting (for example, droughts [2]). Simultaneous knowledge of surface and RZSM could enable a breakthrough in estimating key unobserved hydrologic fluxes and reduce uncertainty in net ecosystem exchange (NEE), carbon balance [3] discharge estimates, and crop yield forecasts [4] .With the high albedo and insulating properties of snow, monitoring, SWE accumulation would provide a key constraint on the potential runoff during spring ablation while monitoring SWE disappearance rates would provide a key constraint on SWE partition into runoff vs. infiltration/recharge. [5] demonstrated that knowledge of early-spring SWE generally contributes most to streamflow forecast skill in the Western U.S. SWE is also a source of water storage that provides the water resources during spring snowmelt. Despite such potentially transformative contributions, accurate RZSM and SWE measurements are unattainable with current technology. While active/passive L-band methods (e.g. SMAP, SMOS) can reliably retrieve surface soil moisture in the top 5 cm of soil [6], [7]. RZSM estimates are only available through model assimilation of brightness temperatures with a radiative transfer and land surface models [8]. SWE estimation uses multi-frequency passive microwave techniques (e.g. [9]-[11]), which have significant problems with deeper snow and in forested and mountainous environments [12]. Signals of opportunity (SoOp) in P-band (200-400 MHz) is a new remote sensing technique with the capability of estimating both essential hydrologic variables, RZSM and SWE, circumventing many of the aforementioned limitations under all weather conditions day and night. SoOp is the re-utilization of existing powerful satellite transmissions within bands allocated for communications or navigation. P-band SoOp sensitivity to soil moisture has been demonstrated in an airborne experiment over Oklahoma in 2016 [13]. Recent theory [14] and experiments [15] have also confirmed that the reflection coefficient phase is proportional to SWE.
2001 Mars Odyssey Project report
The Mars Odyssey orbiter was launched on April 7, 2001, and arrived at Mars on October 24, 2001. The orbiter carries scientific instruments that will determine surface elemental composition, mineralogy and morphology, and measure the Mars radiation environment from orbit. In addition, the orbiter will serve as a data relay for future surface missions. This paper will present an overview of the Odyssey project, including the key elements of the spacecraft design, mission design and navigation, mission operations, and the science approach. The project's risk management process will be described. Initial findings of the science team will be summarized.
2001 Mars Odyssey project report
Explore the source record for details and available documents.
2001 Mars Odyssey mission design
Six mission phases are defined to describe the periods of activities during the orbiter nominal mission.
Mission Plan for the Mars Surveyor 2001 Orbiter and Lander
The Mars Surveyor 2001 Project consists of two missions to Mars, an Orbiter and a Lander, both to be launched in the spring of 2001 for October 2001 (Orbiter) and January 2002 (Lander) arrival at Mars. The Orbiter will support the Lander mission primarily as a communications relay system; the Lander will not have direct-to-Earth communications capability. Science data collected from the Orbiter will also be used to aid in the geologic interpretation of the landing site, along with data from past missions. Combining the Orbiter and Lander missions into a single Project has enabled the streamlining of many activities and an efficient use of personnel and other resources at the Jet Propulsion Laboratory and at the spacecraft contractor, Lockheed Martin Astronautics.
Overview of the Mars Pathfinder Mission: Launch Through Landing, Surface Operations, Data Sets, and Science Results
Mars pathfinder successfully landed at Ares Vallis on July 4, 1997 and returned 2.3 Gbits of information during 3 months of surface operations of a lander, rover, three science instruments, engineering sensors and technology experiments.
Mars Pathfinder Atmospheric Entry Reconstruction
The primary objective of the Mars Pathfinder mission was to demonstrate an innovative, low-cost and reliable method for placing a science payload on the surface of Mars. This paper describes the results of an effort to access the spacecraft performance during Entry, Descent and Landing.
Mars Pathfinder Atmospheric Entry Navigation Operations
On July 4, 1997, after traveling close to 500 million km, the Pathfinder spacecraft successfully completed entry, descent, and landing, coming to rest on the surface of Mars just 27 km from its target point. In the present paper, the atmospheric entry and approach navigation activities required in support of this mission are discussed. In particular, the flight software parameter update and landing site prediction analyses performed by the Pathfinder operations navigation team are described. A suite of simulation tools developed during Pathfinder's design cycle, but extendible to Pathfinder operations, are also presented. Data regarding the accuracy of the primary parachute deployment algorithm is extracted from the Pathfinder flight data, demonstrating that this algorithm performed as predicted. The increased probability of mission success through the software parameter update process is discussed. This paper also demonstrates the importance of modeling atmospheric flight uncertainties in the estimation of an accurate landing site. With these atmospheric effects included, the final landed ellipse prediction differs from the post-flight determined landing site by less then 0.5 km in downtrack.
Aeroacoustics of advanced STOVL aircraft plumes
This paper summarizes a basic and well-controlled experimental study involving flow visualization and noise measurements to define the acoustic and flow fields of single plumes impinging on a simulated ground plane. The flow visualization was made by strobing a laser light source at the discrete frequencies generated by the impingement of the jets and measured by a nearfield microphone. This enabled visualization of instability waves generated by the interaction between the plumes and the sound generated during impingement, and also by dynamic coupling between the two plumes. These data were acquired as a function of distance between the ground and the nozzle exit. Nearfield acoustic data were acquired simultaneously. Data for nozzle diameters of 0.265 in. and 0.4 in. are described. For selected nozzles, effects of exit boundary layer characteristics and nozzle protrusion through a simulated aircraft body are also presented.