Engineering Papers⌕ Search

Engineering topics

Soumyo Dutta

Publications and source records attributed to Soumyo Dutta.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRSDate not supplied

Numerical Predictor-Corrector Based Guidance Scheme For Aero-Gravity Assist at Titan For Enceladus Missions

Aero-gravity assist is a spacecraft maneuver than can enable a vehicle to insert into an orbit of one planetary body using the atmosphere and gravity field of a secondary body, reducing the required propellant mass relative to a fully-propulsive orbit insertion. The Fully Numerical Predictor-Corrector Aerocapture Guidance algorithm was modified to work with a direct force control blunt body vehicle, executing an aero-gravity assist at Titan to enter a Saturnian orbit and conduct fly-by at Enceladus. Additionally, a proportional-integral-derivative controller was implemented to command sideslip angles for control of the orbital inclination. Numerical simulation showed the developed guidance scheme was capable of minimizing the energy and inclination error at atmospheric exit, allowing Saturnian moon tour trajectories and Enceladus exploration at a small delta-V cost, on the order of 100 m/s, in the nominal case.

Daniel Louis Engel↗
NASA NTRSDate not supplied

Numerical Predictor-Corrector Based Guidance Scheme For Aero-Gravity Assist at Titan For Enceladus Missions

Aero-gravity assist is a spacecraft maneuver than can enable a vehicle to insert into an orbit of one planetary body using the atmosphere and gravity field of a secondary body, reducing the required propellant mass relative to a fully-propulsive orbit insertion. The Fully Numerical Predictor-Corrector Aerocapture Guidance algorithm was modified to work with a direct force control blunt body vehicle, executing an aero-gravity assist at Titan to enter a Saturnian orbit and conduct fly-by at Enceladus. Additionally, a proportional-integral-derivative controller was implemented to command sideslip angles for control of the orbital inclination. Numerical simulation showed the developed guidance scheme was capable of minimizing the energy and inclination error at atmospheric exit, allowing Saturnian moon tour trajectories and Enceladus exploration at a small delta-V cost, on the order of 100 m/s, in the nominal case.

Daniel L. Engel↗
NASA NTRSDate not supplied

Guidance and Control Techniques for Titan Aerogravity Assist for Enceladus Observation

Enceladus is a prime scientific target due active geological features and evidence that liquid water might be present on this Saturnian moon. The surface of Enceladus is covered in active fissures known as “Tiger Stripes”. The plumes coming from these rifts were sampled by the Cassini mission, which detected carbon, hydrogen, oxygen, and nitrogen – all key signatures where life could exit. In order to access this moon, mission design using traditional fully-propulsive orbit insertion maneuvers is fuel expensive and time consuming, leading a prior study to rule traditional chemical and solar electric propulsion based missions infeasible. One alternative that enables this mission is Titan aerogravity assist, which is an aeroassist maneuver that combines atmospheric flight and gravity assist of Titan to allow a spacecraft to enter a planetary capture orbit about Saturn. This poster will look at the guidance and control techniques that are required to allow aerogravity assist to take place within Titan’s atmosphere.

Soumyo Dutta↗
NASA NTRSDate not supplied

Mars 2020 – Landing a 1-ton rover and helicopter in an ancient Martian Lake

The Mars 2020 spacecraft launched in July 2020 and landed the Perseverance rover and Ingenuity helicopter successfully in Jezero crater on Feb. 18, 2021. Mars 2020 is the first stage of the Mars Sample Return campaign that will bring back the first samples from another planet to Earth. The entry, descent, and landing (EDL) sequence of the Mars 2020 spacecraft largely leveraged the previous Mars Science Laboratory (MSL) mission from 2012. Mars 2020 retained most of the EDL sequences of MSL, including active maneuvering during hypersonic flight to accurately target the landing site and use of the Skycrane descent stage that slowly lowered the rover while hovering above the ground. But Mars 2020 also added Terrain Relative Navigation, a machine vision-based system that allowed the spacecraft to navigate using an on-board camera that mapped ground landmarks to an on-board map, allowing the spacecraft to safely land in locations that were too hazardous for any previous Martian mission. Come hear about the “Seven Minutes of Terror” and the eight years of effort that went into the engineering behind the spacecraft.

Soumyo Dutta↗
NASA NTRSDate not supplied

Post-flight Analysis of Atmospheric Properties from Mars 2020 Entry, Descent, and Landing

The Mars 2020 spacecraft landed the Perseverance rover and Ingenuity helicopter successfully in Jezero crater on Feb. 18, 2021. The entry, descent, and landing (EDL) sequence of the spacecraft largely leveraged the previous Mars Science Laboratory (MSL) mission. The atmospheric modeling approach for Mars 2020 was also borrowed from MSL, and consisted of utilizing two mesoscale atmospheric models of the landing site during the Martian season of landing, and using that data to create a statistical model of the pressure, density, temperature, and winds that Mars 2020 could have expected to encounter. Additionally, Mars 2020 contained an optical sensor - Landing Vision System (LVS) - that relied on taking pictures of the terrain, and was sensitive to the dust opacity of the atmosphere. This paper will briefly describe the pre-flight atmospheric models used for Mars 2020, but will focus on post-flight assessment of these models by comparing them to near-landing day orbiter sounder data and onboard atmospheric measurements. Suggestions for potential model changes will be also discussed.

Soumyo Dutta↗
NASA NTRSDate not supplied

Precision Landing Performance of a Human-Scale Lunar Lander Using a Generalized Simulation Framework

NASA has established goals of returning humans to Moon with an initial landing by 2024 and a subsequent sustained presence by 2028, which will require technological advances in spacecraft navigation to enable precision landing. The ability to assess the navigation performance of these new and existing technologies is critical to identifying areas of risk reduction and investment. To that end, the Safe and Precise Landing Integrated Capabilities Evolution (SPLICE) project has demonstrated that a detailed six degree-of-freedom integrated performance simulation framework can provide information on and assessment of expected navigation performance. This framework incorporates engineering models of the on-board spacecraft guidance, navigation, and control systems at varying levels of fidelity. Recent advances in the development of this integrated performance simulation permit running these systems “in-the-loop,” rather than assuming perfect knowledge of the spacecraft states. This development, coupled with fast simulation time and modularization of the various system models, enables a wide variety of system trades to be assessed at once. This paper presents a summary of the advances in the SPLICE simulation framework, updates to the spacecraft navigation models, and an application of the framework to characterize the precision landing performance of a human-scale lunar lander. A series of trade studies examining effects of ground state update qualities shows that given all other assumptions, sufficiently accurate Deep Space Network (DSN) measurements can enable safe and precise human-scale Lunar landings.

Spacecraft navigation↗
NASA NTRSDate not supplied

Mars Entry, Descent, and Landing Instrumentation 2 Trajectory, Aerodynamics, and Atmosphere Reconstruction

On February 18th, 2021, the Mars 2020 entry system successfully delivered the Perseverance rover to the surface of Mars at Jezero Crater. The entry capsule carried a set of instrumentation installed on the heat shield and backshell, named the Mars Entry, Descent, and Landing Instrumentation 2. The instruments include pressure transducers, thermocouples, heat flux gauges, and radiometers to measure the aerodynamic and aerothermodynamic performance of the entry vehicle. This paper describes the trajectory and atmosphere reconstruction results based on the pressure sensor measurements. The process uses a Kalman filter approach to estimate the freestream atmospheric properties from the pressure measurements combined with a model of the pressure distribution of the heatshield and other sensor inputs, including an inertial measurement unit and other on-board navigation sensors, and several external atmospheric observations. The results indicate upper altitude density was up to 150% higher than nominal, which is consistent with the observed early entry guidance start time. The density below 40 km was within 12% the pre-flight predictions. The reconstructed axial force coefficient was approximately 2% lower than the pre-flight prediction across the flight range.

Christopher D Karlgaard↗
NASA NTRSDate not supplied

Assessment of the Mars 2020 Entry, Descent, and Landing Simulation

On February 18, 2021, the Mars 2020 Perseverance rover successfully landed inside Jezero Crater at 18.44463 deg North latitude and 77.45088 deg East longitude. At 1026 kg, Perseverance is the largest, most sophisticated rover ever delivered to another planet. This event marked the ninth successful landing and fifth rover to be delivered at Mars. The Program to Optimize Simulated Trajectories II (POST2) is a trajectory simulation tool maintained by the NASA Langley Research Center. POST2 was the prime EDL performance simulation for Mars 2020. This tool has significant heritage on the previous Pathfinder, MER, Phoenix, InSight, and MSL landings. This paper presents a few initial comparisons between EDL flight telemetry and POST2 simulation predictions. These comparisons are important in order to understand how each of the individual models performed, as well as the integrated simulation as a whole. This information is fed forward to future missions, which benefit from the knowing where additional resources or study are needed and where uncertainties may be reduced to enable improved performance.

David W Way↗
NASA NTRSDate not supplied

Integrated Precision Landing Performance and Technology Assessments of a Human-Scale Mars Lander Using a Generalized Simulation Framework

Human-scale missions to Mars will likely require multiple landers delivered precisely to designated locations. The current NASA human Mars reference architecture assumes delivery of three 25 t payloads from a 1- or 5-Sol orbit to the surface with a landing precision of 50 m to ensure logistics are located near the habitat. While initial navigation estimates improve with on-orbit ground tracking, errors increase during post-deorbit coast. Likewise, Mars atmospheric variability and forecasting uncertainty means that the entry vehicle guidance, navigation, and control systems must be robust to accommodate landing during any time of day or Mars year, including during dust storms. Precision landing technologies are currently being assessed to determine if onboard navigation sensors are sufficient to enable the landing accuracy required or if additional navigation aids such as surface or orbiting beacons will be needed. This study evaluates the system performance requirements to meet the desired landing accuracy for the reference vehicle design and entry, descent, and landing concept of operations. A detailed six degree-of-freedom integrated performance simulation framework is used to perform the assessment and demonstrate that under current assumptions, onboard navigation sensors are sufficient to support precision landing.

spacecraft navigation↗
NASA NTRSDate not supplied

Post-flight Analysis of Atmospheric Properties from Mars 2020 Entry, Descent, and Landing

The Mars 2020 spacecraft landed the Perseverance rover and Ingenuity helicopter successfully in Jezero crater on Feb. 18, 2021. The entry, descent, and landing (EDL) sequence of the spacecraft largely leveraged the previous Mars Science Laboratory (MSL) mission. The atmospheric modeling approach for Mars 2020 was also borrowed from MSL, and consisted of utilizing two mesoscale atmospheric models of the landing site during the Martian season of landing, and using that data to create a statistical model of the pressure, density, temperature, and winds that Mars 2020 could have expected to encounter. Additionally, Mars 2020 contained an optical sensor - Landing Vision System (LVS) - that relied on taking pictures of the terrain, and was sensitive to the dust opacity of the atmosphere. This paper will briefly describe the pre-flight atmospheric models used for Mars 2020, but will focus on post-flight assessment of these models by comparing them to near-landing day orbiter sounder data and onboard atmospheric measurements. Suggestions for potential model changes will be also discussed.

Soumyo Dutta↗
NASA NTRSDate not supplied

Assessment of the Mars 2020 Entry, Descent, and Landing Simulation

On February 18, 2021, the Mars 2020 Perseverance rover successfully landed inside Jezero Crater at 18.44463 deg North latitude and 77.45088 deg East longitude. At 1026 kg, Perseverance is the largest, most sophisticated rover ever delivered to another planet. This event marked the ninth successful landing and fifth rover to be delivered at Mars. The Program to Optimize Simulated Trajectories II (POST2) is a trajectory simulation tool maintained by the NASA Langley Research Center. POST2 was the prime EDL performance simulation for Mars 2020. This tool has significant heritage on the previous Pathfinder, MER, Phoenix, InSight, and MSL landings. This paper presents a few initial comparisons between EDL flight telemetry and POST2 simulation predictions. These comparisons are important in order to understand how each of the individual models performed, as well as the integrated simulation as a whole. This information is fed forward to future missions, which benefit from the knowing where additional resources or study are needed and where uncertainties may be reduced to enable improved performance.

David Way↗
NASA NTRSDate not supplied

Aerocapture as an Enabling Option for Ice Giants Missions

Investigation of Uranus and Neptune, via orbiter and atmospheric probes, is required to answer pressing science questions that have been raised in previous Decadal Surveys. As the Ice Giants are the farthest planets from Earth, traditional fully-propulsive orbit insertion missions have transit times to the planetary bodies nearing 13-15 years and require a large amount of propellant, leaving less mass for the scientific payload (dry mass percentages of around 30-40%). Aerocapture uses aerodynamic forces generated by flight within a planetary atmosphere to decelerate and achieve orbit insertion. Although, aerocapture has not been used in the past, recent developments in thermal protection systems, guidance and control, and interplanetary navigation capabilities enable the use of rigid, heritage entry vehicle configurations already flown at other planetary bodies for Ice Giants aerocapture. With the addition of these recent capabilities, aerocapture can robustly deliver spacecraft to Ice Giant orbits, while substantially increasing on-orbit payload mass (more than 40%) and reducing the transit time by 2-5 years (15-30%) relative to fully-propulsive orbit insertion.

Soumyo Dutta↗
NASA NTRSDate not supplied

Flight Envelope Assessment of SmallSat Aerocapture Trajectories at Venus and Mars

Aerocapture is an increasingly studied orbit insertion concept for small satellite (SmallSat) missions beyond low Earth orbit (LEO). Compared to fully propulsive methods, aerocapture reduces the orbit-insertion propellant mass by approaching on a hyperbolic path and using the planetary atmosphere to reduce the vehicle’s velocity such that the final target orbit is achieved. This allows for an increase in payload mass delivered to orbit and a reduction in launch-to-orbit time. To analyze the feasibility at Venus and Mars, aerocapture flight envelope analysis is conducted by assessing the guidable trajectory space during atmospheric flight given entry conditions, vehicle properties, target parameters, and planet-dependent trajectory dispersions. The Program to Optimize Simulated Trajectories II (POST2) is used to simulate both ballistic and lifting aerocapture trajectories with SmallSat-compatible aeroshell designs. The entry flight path angle is optimized to achieve a final target orbit for lift up/down and max/min control configurations. When plotted, the resulting area between the steep and shallow trajectories forms a flight envelope with planet-dependent ±3σ atmospheric, aerodynamic, and delivery state dispersion profiles applied. The results presented in this paper show that SmallSat aerocapture is feasible for lifting aeroshell designs at Mars and Venus as well as ballistic vehicle designs at Mars.

Jack A. Joshi↗