Engineering Papers⌕ Search

Engineering topics

Soriano, Melissa

Publications and source records attributed to Soriano, Melissa.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2022

Mars 2020 Entry, Descent, and Landing as Observed by Radio Science Techniques at UHF and X-band Frequencies

On February 18, 2021, NASA’s Mars 2020 Rover “Perseverance” conducted the Entry, Descent, and Landing (EDL) sequence to land safely on the surface of Mars at Jezero Crater. Due to the criticality of the EDL sequence, redundant telecommunications strategies were utilized to observe the event. The rover transmitted an X-band (8.4 GHz) signal encoded with Multiple Frequency Shift Keying tones direct-to-Earth and a UHF (401.5 MHz) signal with 8 kbps encoded telemetry to orbiters, which relayed the signal back to Earth at X-band. NASA’s Deep Space Network complexes at Goldstone, California and Madrid, Spain received the direct-to-Earth X-band signal. Two of the largest steerable radio telescopes in the world, the 100-meter Green Bank Telescope in West Virginia and the Effelsberg 100-meter Radio Telescope in Germany also received the UHF carrier signal on Earth. During the EDL event, full spectrum recordings of the UHF and X-band signals were captured at these observatories using open-loop receivers. Real-time and post-processing signal analysis to determine power level, received frequency, and Doppler shift allowed determination of the spacecraft’s health and safety state during critical sequences, including event detection such as atmospheric entry, plasma blackouts, and parachute deployment. Simultaneous observations of the UHF and X-band radio links allow for redundancy in the event of a fault and greatly improve confidence in Doppler event detection.

Gladden, Roy↗
NASA NTRS2021

DSN Radio Astronomy Spectrometer

The Deep Space Network (DSN) enables NASA to communicate with its deep space spacecraft. By virtue of its large antennas, the DSN can be used as a powerful instrument for radio astronomy. In particular, Deep Space Station (DSS) 43, the 70 m antenna at the Canberra Deep Space Communications Complex (CDSCC) has a K-band radio astronomy system covering a 10 GHz bandwidth at 17 to 27 GHz. This spectral range covers a number of atomic and molecular lines, produced in a rich variety of interstellar gas conditions. A new high-resolution spectrometer was deployed at CDSCC in November 2019 and connected to the K-band downconverter. The system has two different firmware modes: 1) Using a 65k-pt FFT to provide 32,768 spectral channels at ~30.5 kHz (0.45 km/s velocity resolution) and 2) Using a 16k-pt polyphase filterbank (PFB) to provide 8,192 spectral channels with ~122 kHz resolution (1.8 km/s velocity resolution). Previous work extensively described the spectrometer system. In this paper we present added functionality and updates to the commissioned spectrometer. The changes include developments in system timing, metadata, firmware and data products.

Bradford, Brian↗
NASA NTRS2020

X- to Ka- Band Cryogenic LNA Module for Very Long Baseline Interferometry

We report a new result of a packaged low noise amplifier (LNA) module with wide bandwidth of 5 to 35 GHz with low noise temperature performance of 10 - 18 K, while operated at 10 K ambient. The LNA used 3-stages of sub-50 nm gate length, 100% indium channel content indium phosphide (InP) high electron mobility transistors (HEMTs). Wideband cryogenic LNAs are important for future radio astronomy observatories. To our knowledge these results represent the lowest noise achieved in a wideband amplifier from 5-35 GHz.

Fung, Andy↗
NASA NTRS2020

Detecting Juno’s ‘Heartbeat’: Communications Support during Critical Events of the Juno Mission

The first section of this paper summarizes the radio systems of the spacecraft, the antennas of the DSN, and signal processing performed in real-time on the ground to support the critical activities. The second section goes into detail on each of the critical events with details of the radio science support and results of each event. Finally, the paper is concluded with a discussion of future planned supports and capabilities of radio science support during critical events.

Jongeling, Andre↗
NASA NTRS2020

Europa Clipper Mission: Onward to Implementation!

Europa, the fourth largest moon of Jupiter, is believed to be one of the best places in the solar system to look for extant life beyond Earth, and the Europa Clipper Mission is preparing to investigate. Now entering the fifth year of life as a formal project, the Europa Clipper Mission has completed its major design phase and is preparing for implementation. The mission envisions sending a flight system, consisting of a spacecraft equipped with a payload of NASA-selected scientific instruments, to execute numerous flybys of Europa while in Jupiter orbit. The mission is being formulated and implemented by a joint Jet Propulsion Laboratory (JPL) and Applied Physics Laboratory (APL) Project team. At the Project Preliminary Design Review (PDR) in August 2018, it was determined that the unique integration of the REASON instrument’s antennas with the spacecraft’s solar arrays required additional time for maturity and review. The required maturity was demonstrated, and in June 2019 the Clipper Mission passed its Delta Preliminary Design Review, and formal confirmation for entry into Phase C was announced by NASA in August 2019. The earliest launch opportunity is now in July 2023, one year later than originally planned. The Project is now working toward its Critical Design Review in May 2020. This paper will describe the progress of the Europa Clipper Mission since January 2019, including maturation of the spacecraft, subsystem and instrument designs, the beginning of fabrication of engineering models and the first flight models, planning for the verification & validation phase, and planning for operations.

Jackson, Maddalena↗
NASA NTRS2019

Europa Clipper Mission: preliminary design report

This paper will describe the progress of the Europa Clipper Mission since January 2018, including maturation of the spacecraft, subsystem and instrument preliminary designs, issues and trades, and planning for the Verification and Validation phase.

Laslo, Nori↗
NASA NTRS2017

Development of an Ultra-wide band Receiver for the North America Array

The North America Array (NAA), also known as the next-generation Very Large Array (ngVLA), is a concept for a radio astronomical interferometric array operating in the frequency range 1.2 GHz to 116 GHz and designed to provide substantial improvements in sensitivity, angular resolution, and frequency coverage while reducing operational costs compared to the current Jansky Very Large Array (JVLA). At JPL, we are designing a single receiver package designed to operate across the 8 to 48 GHz frequency range, in contrast to the current JVLA, which covers this frequency range with five receiver packages. Reducing the number of receiving systems required to cover the full frequency range would reduce operating costs. We are developing a prototype integrated feed-receiver package with a system noise temperature that meets the requirements of the ngVLA/NAA primary science programs, with a design that meets the requirement of low long-term operational costs. The receiver package being developed at JPL consists of a feed horn, low-noise amplifier (LNA), and down-converters to analog intermediate frequencies. We report on the status of this receiver package development.

Lazio, Joseph↗