Engineering topics

Sollner, T. C. L. G.

Publications and source records attributed to Sollner, T. C. L. G..

4 records

NASA NTRS1988

Harmonic multiplication using resonant tunneling

This paper demonstrates the use of resonant-tunneling diodes as varistors for harmonic multiplication. It is shown that efficient odd-harmonic conversion is possible and that even harmonics do not appear because of the antisymmetry of the current-voltage (I-V) curve. It is also shown that, with the proper choice of resonant-tunneling structure and pump amplitude, most of the harmonic output power can be confined to a single odd-harmonic frequency. Fifth-harmonic multiplication was demonstrated with an output at 21.75 GHz and a power conversion efficiency of 0.5 percent, and a fifth-harmonic efficiency of 2.7 percent was achieved in a circuit simulation using an improved I-V curve.

Sollner, T. C. L. G.↗

NASA NTRS1987

Comment on 'Observation of intrinsic bistability in resonant-tunneling structures'

It is suggested that the intrinsic bistability observed by Goldman et al. (1987) occurred not because of charging of the well, as is claimed, but because of oscillations in the negative-resistance region. A typical I-V curve for a double-barrier resonant-tunneling (DBRT) diode which is known to be oscillating is presented. In a reply to this comment, Goldman et al. show that the series resistance (of about 100 ohms) in Sollner's sample leads to extrinsic, rather than intrinsic, bistability. It is furthermore suggested that the mere presence of an oscillation does not in itself exclude intrinsic bistability in a DBRT structure. It is also noted that the intrinsic bistability and buildup of negative charge-space in a DBRT structure well has been demonstrated experimentally by Payling et al. (1987).

Sollner, T. C. L. G.↗

NASA NTRS1987

Observation of millimeter-wave oscillations from resonant tunneling diodes and some theoretical considerations of ultimate frequency limits

Recent observations of oscillation frequencies up to 56 GHz in resonant tunneling structures are discussed in relation to calculations by several authors of the ultimate frequency limits of these devices. It is found that calculations relying on the Wentzel-Kramers-Brillouin (WKB) approximation give limits well below the observed oscillation frequencies. Two other techniques for calculating the upper frequency limit were found to give more reasonable results. One method employs the solution of the time-dependent Schroedinger equation obtained by Kundrotas and Dargys (1986); the other uses the energy width of the transmission function for electrons through the double-barrier structure. This last technique is believed to be the most accurate since it is based on general results for the lifetime of any resonant state. It gives frequency limits on the order of 1 THz for two recently fabricated structures. It appears that the primary limitation of the oscillation frequency for double-barrier resonant-tunneling diodes is imposed by intrinsic device circuit parameters and by the transit time of the depletion layer rather than by time delays encountered in the double-barrier region.

Sollner, T. C. L. G.↗

NASA NTRS1987

Millimeter-band oscillations based on resonant tunneling in a double-barrier diode at room temperature

A double-barrier diode at room temperature has yielded oscillations with fundamental frequencies up to 56 GHz and second harmonics up to 87 GHz. The output powers at these frequencies were about 60 and 18 microW, respectively. These results are attributed to a recent improvement in the material parameters of the device and to the integration of the device into a waveguide resonator. The most successful diode to date has thin (about 1.5 nm) AlAs barriers, a 4.5-nm-wide GaAs quantum well, and 2 x 10 to the 17th/cu cm doping concentration in the n-GaAs outside the barriers. This particular diode is expected to oscillate at frequencies higher than those achieved by any reported p-n tunnel diode.

Brown, E. R.↗