Engineering PapersSearch

Engineering topics

Smith, C.

Publications and source records attributed to Smith, C..

35 records · Page 2

Recent results and new hardware developments for protein crystal growth in microactivity

Protein crystal growth experiments have been performed on 16 space shuttle missions since April, 1985. The initial experiments utilized vapor diffusion crystallization techniques similar to those used in laboratories for earth-based experiments. More recent experiments have utilized temperature induced crystallization as an alternative method for growing high quality protein crystals in microgravity. Results from both vapor diffusion and temperature induced crystallization experiments indicate that proteins grown in microgravity may be larger, display more uniform morphologies, and yield diffraction data to significantly higher resolutions than the best crystals of these proteins grown on earth.

Delucas, L. J.

RL10A-3-3B high mixture ratio qualification program

The results of the high mixture ratio qualification testing of the RL10 engine for the Shuttle/Centaur program are presented. The objective of the engine qualification test was to demonstrate the suitability of the RL10A-3-3B engine for space vehicle flight by subjecting it to the testing specified in RL10A-3-3B Model Specification Number 2295 dated February 1986. The applicable section of the specification is presented. Due to payload volume advantages which can be achieved by increasing the operating mixture ratio of the RL10, a decision was made to qualify the engine to run at a higher mixture ratio. A program was created to qualify the RL10 engine for operation at 15,000 pounds thrust and a nominal 6.0 to 1 mixture ratio. This model of the engine was designated the RL10A-3-3B. The qualification program included three test series as follows: (1) hardware durability and limits test in which the engine completed 23 firings and 4605.7 seconds with 1588.7 seconds at less than 6.6 mixture ratio; (2) preliminary qualification test in which the engine completed 26 firings and 5750 seconds; and (3) qualification test in which the engine completed 26 hot firings and 5693.4 seconds with 905.9 seconds at 6.7 mixture ratio. Several changes in engine hardware were required for operation of the RL10A-3-3B engine in the Space Shuttle which include a duel pressure switch ignition, an oxidizer flow control, and helium plumbing changes.

Vogel, T.

The effect of personal equation on measurements of the solar semi-diameter by transit circle observers

Cape Observatory transit circle measurements of systematic trends in the semi-diameter of the sun (1834, 1861-1871, 1884-1892) are considered, and an analysis of Washington six inch observations (1899-1903, 1911-1918, 1956-1971, 1975-1981) is given. A discordance between horizontal and vertical results in Cape measurements implies that these measurements are inaccurate due to the use of personal equations. The Washington measurements consider observational corrections and instrumental techniques, and it is thus concluded that no secular change in solar diameter has occurred.

Smith, C.

The horizontal and vertical semi-diameters of the Sun observed at the Cape of Good Hope (1834 - 1887) and Paris (1837 - 1906): A report on work in progress

Cape and Paris meridian observations of the solar limbs which permit an estimate to be made of the solar semi-diameter were surveyed, sampled, and compared with Greenwich and U.S. Naval Observatory observations. Significant systematic errors were found in the Paris work and have been correlated with changes of instruments and observers. Results from the Cape series indicate that work should continue on the compilation of data from Cape observations of the Sun.

Smith, C.

Structure of correlation tensors in homogeneous anisotropic turbulence

The theory of isotropic tensors, developed by Robertson (1940), Batchelor (1946), and Chandrasekhar (1951), is extended to cover the general case of turbulence with a pseudo-vector-preferred direction, without assuming mirror-reflection invariance. Attention is focused on two-point-correlation functions, and it is shown that the form of the decomposition into proper and pseudo-tensor contributions is restricted by the homogeneity requirement. The somewhat unexpected result that the vector- and pseudo-vector-preferred-direction cases yield different results is presented: A pseudo-vector-preferred direction allows the correlation matrix one more functional degree of freedom than does the proper vector case. An explicit form of the two-point-correlation tensor in the presence of a uniform mean magnetic field is presented which may be appropriate for use in analysis of magnetic fluctuations in plasma containment devices or the interplanetary medium. A procedure for determining the magnetic helicity from experimental data is presented.

Matthaeus, W. H.

Experiment K305: Quantitative analysis of selected bone parameters. Supplement 2: Bone elongation rate and bone mass in metaphysis of long bones

The proximal humeral metaphysis of rats from time periods recovery plus zero days (R+0), recovery plus six days (R+6), and recovery plus twenty nine days (R+29) was analyzed. The volume of calcified cartilage and bone in flight and synchronous controls was reduced in groups R+0 and R+6, but was normal in group R+29. The number of functional bone cells (osteoblasts and osteoclasts) was decreased in proportion to the amount of bone in the early groups, and was normal in the last group. The fatty marrow volume was increased only in flight animals of groups R+0 and R+6, but was normal in the R+29 group. Accumulation of excess fatty marrow was seen only in flight animals. The decreased amount of bone and calcified cartilage is believed to be the result of a temporarily slowed or arrested production of calcified cartilage as a substrate for bone formation. This would have resulted from slowed bone elongation during flight and synchronous control conditions. Bone elongation returned to normal by twenty nine days after return.

Jee, W. S. S.

Evaluation of magnetic helicity in homogeneous turbulence

A technique for the measurement of magnetic helicity from values of the two point magnetic field correlation matrix under the assumption of spatial homogeneity is presented. Knowledge of a single scalar function of space, derivable from the correlation matrix, suffices to determine the magnetic helicity. The technique is illustrated by reporting the first measurement of the magnetic helicity of the solar wind.

Matthaeus, W. H.

The structure of correlation tensors in homogeneous anisotropic turbulence

The study of turbulence with spatially homogeneous but anisotropic statistical properties has applications in space physics and laboratory plasma physics. The first step in the systematic study of such fluctuations is the elucidation of the kinematic properties of the relevant statistical objects, which are the correlation tensors. The theory of isotropic tensors, developed by Robertson, Chandrasekhar and others, is reviewed and extended to cover the general case of turbulence with a pseudo-vector preferred direction, without assuming mirror reflection invariance. Attention is focused on two point correlation functions and it is shown that the form of the decomposition into proper and pseudo-tensor contributions is restricted by the homogeneity requirement. It is also shown that the vector and pseudo-vector preferred direction cases yield different results. An explicit form of the two point correlation tensor is presented which is appropriate for analyzing interplanetary magnetic fluctuations. A procedure for determining the magnetic helicity from experimental data is presented.

Matthaeus, W. H.

Isokinetic exercise: A review of the literature

Isokinetic muscle training has all the advantages of isometrics and isotonics while minimizing their deficiencies. By holding the speed of movement constant throughout the full range of motion, isokinetic training devices respond with increased resistance rather than acceleration when the power output of the muscle is increased. Isokinetic training is superior to isometric and isotonic training with respect to increases in strength, specificity of training, desirable changes in motor performance tasks, lack of muscle soreness, and decreases in relative body fat.

Olree, H. D.

Study of optimal training protocols and devices for developing and maintaining physical fitness in females prior to and during space flight

Pedalling a bicycle at least ten minutes a day at 85% of maximum pulse rate, three days a week for ten weeks will produce moderate increases in overall strength and physical work capacity in college-age females. The longer the training session, up to thirty minutes per session, the greater are the increases in physical work capacity that result when college-age females are trained three days a week for ten weeks at 85% of their maximum heart rate.

Olree, H. D.

An evaluation of the effects of bed rest, sleep deprivation and discontinuance of training on the physical fitness of highly trained young men

This experiment was conducted to determine what physiological effects result when highly trained subjects are confined to bed, deprived of sleep, or allowed to discontinue training. Results indicated: (1) There was a moderate increase in strength variables due to the training in this experiment but the stress which the subjects received caused a negligible change in strength variables. (2) The training program resulted in highly significant changes in specific bicycle ergometer variables indicating good increases in cardiopulmonary fitness. Five days of bed rest or fifty hours of sleep deprivation caused comparable drastic decreases in cardiopulmonary fitness. Post stress the subjects reverted to a normal daily schedule and after two weeks they had recovered about half of what they lost. (3) Cardiac output remains relatively constant at a constant work load, but stroke volume increases with conditioning and decreases with deconditioning due to stress.

Olree, H. D.

Counter and shift register Patent

Computer circuit performing both counting and shifting logic operations also capable of miniaturization and integration in basic circuits

Smith, C.

Computer circuit will fit on single silicon chip

A simplified computer logic circuit of two NAND/NOR gates and three additional inputs to accomplish the count and shift function is described. The circuit has capacity for parallel read-in, counting, serial shiftout, complement input and set and reset.

Smith, C.