Engineering topics

Smetana, F. O.

Publications and source records attributed to Smetana, F. O..

At least 37 records · Page 2

NASA NTRS1974

Industrial noise control: Some case histories, volume 1

A collection of solutions to industrial noise problems is presented. Each problem is described in simple terms, with noise measurements where available, and the solution is given, often with explanatory figures. Where the solution rationale is not obvious, an explanatory paragraph is usually appended. As a preface to these solutions, a short exposition is provided of some of the guiding concepts used by noise control engineers in devising their solutions.

Hart, F. D.↗

NASA NTRS1973

Point and path performance of light aircraft: A review and analysis

The literature on methods for predicting the performance of light aircraft is reviewed. The methods discussed in the review extend from the classical instantaneous maximum or minimum technique to techniques for generating mathematically optimum flight paths. Classical point performance techniques are shown to be adequate in many cases but their accuracies are compromised by the need to use simple lift, drag, and thrust relations in order to get closed form solutions. Also the investigation of the effect of changes in weight, altitude, configuration, etc. involves many essentially repetitive calculations. Accordingly, computer programs are provided which can fit arbitrary drag polars and power curves with very high precision and which can then use the resulting fits to compute the performance under the assumption that the aircraft is not accelerating.

Smetana, F. O.↗

NASA NTRS1973

New motor shaft angular accelerometer concept

Concept permits measurement of the acceleration of continuously rotating shafts without use of slip rings or telemetry and with little additional inertial load. Concept has application in servomotor control circuits and easy-to-fly airplane controls.

Smetana, F. O.↗

NASA NTRS1973

An analytical study of the response of a constant-attitude aircraft to atmospheric turbulence

A light airplane equipped with an automatic control system which drives large wing flaps and the stabilator so as to produce a constant pitch attitude in all flight modes was analyzed for its response to a specific gust. The aircraft was also equipped with a bank-angle steering, zero sideslip automatic control system which was studied for its effectiveness in suppressing a specific lateral gust. The gusts were assumed to be comprised of 200 lateral and 400 vertical sinusoids. Each was used to excite the controlled aircraft and the time response to the sum of all sinusoids was plotted. The assumption was that the gust may be treated as stationary in space but variable in time rather than the reverse. Results indicate that such a control system can suppress vertical gusts up to the limit of control authority. Either the lateral accelerations or the yawing velocity response to lateral gusts can be suppressed with this system but not both simultaneously.

Smetana, F. O.↗

NASA NTRS1973

A design study for a simple-to-fly, constant attitude light aircraft

The activities during a four-year study by doctoral students to evolve in detail a design for a simple-to-fly, constant attitude light airplane are described. The study indicated that such aircraft could materially reduce the hazards to light airplane occupants which arise from the high pilot work load and poor visibility that occur during landing. Preliminary cost studies indicate that in volume production this system would increase the cost of the aircraft in roughly the same fashion that automatic transmission, power steering, power brakes, and cruise control increase the cost of a compact car.

Smetana, F. O.↗

NASA NTRS1973

Equilibrium concentrations of N2H4 and its decomposition products at elevated temperatures and pressures

Liquid hydrazine is considered as a convenient source of hydrogen rather than just as a rocket fuel. For such purposes, the hydrogen is usually obtained by passing the hydrazine through a heated catalytic bed. One convenient measure of the effectiveness of a catalytic decomposition device as a whole is to compare the quantity of hydrogen produced with the equilibrium concentration of the gaseous species N2H4, NH3, N3, and H2 which would exist at the temperature and pressure found in various parts of the device. Calculations of the concentrations were carried out and are reported here. Following presentation of the results in both tabular and graphical forms is a comparison between the computed equilibrium concentrations and available experimental data.

Smetana, F. O.↗

NASA NTRS1972

A fast acting electrical servo for the actuation of full span, Fowler-type wing flaps in DLC applications: A detail design study

The philosophy and detail design of an electro-mechanical actuator for Fowler-type wing flaps which have a response time constant of 0.025 seconds are described. A conventional electrical servomotor with a power rating twice the maximum power delivered to the load is employed along with adaptive, gain-scheduled feedback and various logic circuits, including one to remove electrical excitation from the motor during extended periods when no motion of the flap is desired.

Smetana, F. O.↗

NASA NTRS1972

Flight testing techniques for the evaluation of light aircraft stability derivatives: A review and analysis

Techniques quoted in the literature for the extraction of stability derivative information from flight test records are reviewed. A recent technique developed at NASA's Langley Research Center was regarded as the most productive yet developed. Results of tests of the sensitivity of this procedure to various types of data noise and to the accuracy of the estimated values of the derivatives are reported. Computer programs for providing these initial estimates are given. The literature review also includes a discussion of flight test measuring techniques, instrumentation, and piloting techniques.

Smetana, F. O.↗

NASA NTRS1972

Riding and handling qualities of light aircraft: A review and analysis

Design procedures and supporting data necessary for configuring light aircraft to obtain desired responses to pilot commands and gusts are presented. The procedures employ specializations of modern military and jet transport practice where these provide an improvement over earlier practice. General criteria for riding and handling qualities are discussed in terms of the airframe dynamics. Methods available in the literature for calculating the coefficients required for a linearized analysis of the airframe dynamics are reviewed in detail. The review also treats the relation of spin and stall to airframe geometry. Root locus analysis is used to indicate the sensitivity of airframe dynamics to variations in individual stability derivatives and to variations in geometric parameters. Computer programs are given for finding the frequencies, damping ratios, and time constants of all rigid body modes and for generating time histories of aircraft motions in response to control inputs. Appendices are included presenting the derivation of the linearized equations of motion; the stability derivatives; the transfer functions; approximate solutions for the frequency, damping ratio, and time constants; an indication of methods to be used when linear analysis is inadequate; sample calculations; and an explanation of the use of root locus diagrams and Bode plots.

Smetana, F. O.↗

NASA NTRS1971