Skeen, Scott | Engineering Papers

DOE OSTI2024

Data assimilation for combustion ignition delay time simulation using schlieren image velocimetry

This study sought to improve the accuracy of simulating spray penetration and combustion ignition delay by means of data assimilation (DA). The simulations were conducted using the Reynolds-averaged Navier–Stokes (RANS) equations and assimilating the schlieren image data. In DA, an ensemble square root filter (EnSRF) was used to build the statistical model, making the simulation results more accurate without any change in the governing equations. Recognizing that the spray-cone injection angle has a large effect on penetration, we created ensemble members with different injection angles. And we applied the two-component velocity distribution calculated via SIV and updated both velocity and temperature by using a DA statistical model derived from RANS ensemble simulations. The ignition delay time is generally known to vary even under the same experimental conditions because it is influenced by many factors. In this study, we attempted the transient DA-assisted RANS simulation to predict the ignition delay time even when the temporal resolution and accuracy of the observation data ware insufficient. Our trials offer an example of how a combination of techniques can be effectively used to assimilate experimental data obtained under restricted conditions.

Combustion simulation↗

DOE OSTI2020

Combined Experimental/Numerical Study of the Soot Formation Process in a Gasoline Direct-Injection Spray in the Presence of Laser-Induced Plasma Ignition

Here, combustion issued from an eight-hole, direct-injection spray was experimentally studied in a constant-volume pre-burn combustion vessel using simultaneous high-speed diffused back-illumination extinction imaging (DBIEI) and OH* chemiluminescence. DBIEI has been employed to observe the liquid-phase of the spray and to quantitatively investigate the soot formation and oxidation taking place during combustion. The fuel-air mixture was ignited with a plasma induced by a single-shot Nd:YAG laser, permitting precise control of the ignition location in space and time. OH* chemiluminescence was used to track the high-temperature ignition and flame. The study showed that increasing the delay between the end of injection and ignition drastically reduces soot formation without necessarily compromising combustion efficiency. For long delays between the end of injection and ignition (1.9 ms) soot formation was eliminated in the main downstream charge of the fuel spray. However, poorly atomized and large droplets formed at the end of injection (dribble) eventually do form soot near the injector even when none is formed in the main charge. The quantitative soot measurements for these spray and ignition scenarios, resolved in time and space, represents a significant new achievement. Reynolds-averaged Navier-Stokes (RANS) simulations were performed to assess spray mixing and combustion. An analysis of the predicted fuel-air mixture in key regions, defined based upon experimental observations, was used to explain different flame propagation speeds and soot production tendencies when varying ignition timing. The mixture analysis indicates that soot production can be avoided if the flame propagates into regions where the equivalence ratio (Φ) is already below 2. Reactive RANS simulations have also been performed, but with a poor match against the experiment, as the flame speed and heat-release rate are largely over estimated. This modeling weakness appears related to a very high level of turbulent viscosity predicted for the high-momentum spray in the RANS simulations, which is an important consideration for modeling ignition and flame propagation in mixtures immediately created by the spray.

42 ENGINEERING↗

DOE OSTI2020

When do hydrocarbons dewet metal surfaces? The case of coronene on Cu(111)

Here, we have used scanning tunneling microscopy and density functional theory calculations to study molecular layers of coronene on Cu(111). The structure and stability of these layers is determined by the balance between coronene-substrate and coronene-coronene interactions. Here, we characterize this balance by measuring the maximum coverage before coronene dewets the substrate to form three-dimensional islands. We find that coronene molecules lie parallel to the substrate at the maximum coverage, in contrast to previous observations of tilted coronene on metal surfaces. We attribute this previously reported tilt to a metastability caused by an activation barrier to nucleate three-dimensional islands.

36 MATERIALS SCIENCE↗