Effect of nose bluntness on flowfield over slender bodies in hypersonic flows
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Singh, D. J..
Explore the source record for details and available documents.
A numerical study was conducted to address the structural stability of the oblique detonation wave. An attempt was made to isolate the structural instability predicted by Buckmaster's (1990) linear stability analysis. For this study a detailed viscous flowfield with finite-rate chemistry was computed past a 20-deg wedge. The finite-rate chemistry was modeled by using a seven-species and seven-reaction model. Instability modes were isolated by analyzing the Fourier power spectrum of the H2O mass fraction at selected sample stations. No unstable temporal modes with dominant frequency were isolated. It was concluded that the instability which is predicted by the Buckmaster work was a high-frequency low-amplitude phenomenon. For engineering purposes, the oblique detonation wave is a stable phenomenon as long as sufficient levels of overdrive are present.
Hypersonic flows over cones and straight biconic configurations are calculated for a wide range of free stream conditions in which the gas behind the shock is treated as perfect. Effect of angle of attack and nose bluntness on these slender cones in air is studied extensively. The numerical procedures are based on the solution of complete Navier-Stokes equations at the nose section and parabolized Navier-Stokes equations further downstream. The flow field variables and surface quantities show significant differences when the angle of attack and nose bluntness are varied. The complete flow field is thoroughly analyzed with respect to velocity, temperature, pressure, and entropy profiles. The post shock flow field is studied in detail from the contour plots of Mach number, density, pressure, and temperature. The effect of nose bluntness for slender cones persists as far as 200 nose radii downstream.
The effect of shock impingement on the blunt leading edges of the top and sidewall compression type inlet of a scramjet engine is studied numerically. The impinging shock is caused by the vehicle forebody. The interaction of this forebody shock with the inlet leading edge shock results in a very complex flowfield containing local regions of high pressure and intense heating. This complex flowfield in calculated by solving the Navier-Stokes equations using a finite volume flux splitting technique due to van Leer. To resolve the finer details of the flow structure as well as to predict the surface heat transfer accurately, adaptive grid technique is used in the analysis. Results of the present numerical study are compared with available experimental results.
A comparative numerical study of performance parameters of a similar and an opposite sweep sidewall compression inlet is made. The focus of the study is the investigation of the impact of alternate backward-forward sweep on the compression sidewalls as opposed to back-ward sweep on all the sidewalls. Two equivalent scramjet inlet configurations are designed for this purpose. These inlets have the same wetted areas of compression and expansion and same height and width; but in one inlet all the compression surface are swept back (similar sweep inlet) whereas in the other inlet, alternate surfaces are swept backward and forward (opposite sweep inlet). The cowl closure in both cases begins at the start of the throat region. A three-dimensional Navier-Stokes code is used to calculate the flow through these inlets. Results of these calculations are used to compare the two designs for their performance and flow quality. Effects of boundary- layer ingestion on the performance and overall flow features are also investigated.
A numerical study was conducted to investigate the effects of blunt leading edges on the viscous flow field around a hypersonic vehicle such as the proposed National Aero-Space Plane. Attention is focused on two specific regions of the flow field. In the first region, effects of nose bluntness on the forebody flow field are investigated. The second region of the flow considered is around the leading edges of the scramjet inlet. In this region, the interaction of the forebody shock with the shock produced by the blunt leading edges of the inlet compression surfaces is analyzed. Analysis of these flow regions is required to accurately predict the overall flow field as well as to get necessary information on localized zones of high pressure and intense heating. The results for the forebody flow field are discussed first, followed by the results for the shock interaction in the inlet leading edge region.
Analyses and numerical procedures are presented to investigate the radiative interactions of gray and nongray absorbing-emitting species between two parallel plates and in a circular tube. Laminar fully developed incompressible as well as entrance region subsonic flows are considered. The participating species considered are OH, CO, CO2, CH4, and H2O. Results obtained for different flow conditions indicate that the radiative interactions can be quite significant in fully developed incompressible flows. For subsonic flows, however, the flowfield is not changed significantly due to radiative interactions.
The effects of shock impingement on the inlet of a scramjet engine are investigated numerically. The impinging shock is caused by the vehicle forebody. The interaction of this forebody shock with the inlet leading edge shock results in a very complex fully three-dimensional flowfield containing local regions of high pressure and intense heating. In the present investigation, this complex flowfield is calculated by solving the thin-layer Navier-Stokes equations using a finite-volume flux splitting technique due to van Leer. For zero or small sweep angles a Type IV interaction occurs while for moderate sweep of about 25 deg, a Type V interaction occurs. Both Type IV and Type V interactions are investigated.
The influence of radiative energy transfer on the entrance region flow is investigated under supersonic and subsonic flow conditions in a channel. Two-dimensional compressible Navier-Stokes equations are solved numerically in conjunction with the radiative flux equations. The channel walls are assumed to be black. Nongray as well as pseudo gray gas models are used to represent the absorption-emission characteristic of the medium. The participating species considered are different amounts of water vapor in water vapor-air mixtures. Results obtained for different flow conditions indicate that the radiative interaction can moderately influence the overall energy transfer, but the flowfield is not changed significantly.
Explore the source record for details and available documents.
A parametric study has been conducted to determine the effects of nose bluntness on the enire flowfield over slender bodies under different hypersonic freestream conditions. The analysis is carried out for air under perfect- and equilibrium-gas assumptions. The analyses range from a few simplified approaches to the solution of the complete Navier-Stokes equations. Specific results obtained for spherically blunted cones and ogives demonstrate that there are significant differences in flowfield and surface quantities between sharp and blunted bodies. Depending upon the flow conditions and geometry, the differences are found to persist as far as 260 nose radii downstream.
The effect of shock impingement on the blunt leading edge of the inlet cowl of a scramjet engine is investigated numerically. The impinging shock is caused by the vehicle forebody. The interaction of this forebody shock with the cowl leading edge shock results in a very complex flowfield containing local regions of high pressure and intense heating. In the present investigation, this complex flowfield is calculated by solving the full Navier-Stokes equations using a finite-volume flux splitting technique due to Van Leer. Results are also obtained for the downstream effects into the inlet of the leading edge shock-shock interactions. Results of the present numerical investigation are compared with available experimental results.
The transient radiative interactions of nongray absorbing-emitting species in laminar fully-developed flows between two parallel plates are investigated analytically and numerically. The particular species considered are OH, CO, CO2, and H2O and different mixtures of these species. Transient and steady-state results are obtained for the temperature distribution and bulk temperature for different plate spacings, wall temperatures, and pressures. Results, in general, indicate that the rate of radiative heating can be quite high during earlier times. This information is useful in designing thermal protection systems for transient operations.
Analysis and numerical procedures are presented to investigate the transient radiative interactions of nongray absorbing-emitting species in laminar fully-developed flows between two parallel plates. The particular species considered are OH, CO, CO2, and H2O and different mixtures of these. Transient and steady-state results are obtained for the temperaure distribution and bulk temperature for different plate spacings, wall temperatures, and pressures. Results, in general, indicate that the rate of radiative heating can be quite high during earlier times. This information is useful in designing thermal protection systems for transient operations.
A general formulation is presented to investigate the transient radiative interaction in nongray absorbing-emitting species between two parallel plates. Depending on the desired sophistication and accuracy, any nongray absorption model from line-by-line models to the wide band model correlations can be employed in the formulation to investigate the radiative interaction. Special attention is directed to investigate the radiative interaction in a system initially at a uniform reference temperature and suddenly the temperature of the bottom plate is reduced to a lower but constant temperature. The interaction is considered for the case of radiative equilibrium as well as for combined radiation and conduction. General as well as limiting forms of the governing equations are presented and solutions are obtained numerically by employing the method of variation of parameters. Specific results are obtained for CO, CO2, H2O, and OH. The information on species H2O and OH is of special interest for the proposed scramjet engine application. The results demonstrate the relative ability of different species for radiative interactions.
A general formulation is presented to investigate the transient radiative interaction in nongray absorbing-emitting species between two parallel plates. Special attention is directed to investigate the radiative interaction in a system initially at a uniform reference temperature where suddenly the temperature of the bottom plate is reduced to a lower but constant temperature. The interaction is considered for the case of radiative equilibrium as well as for combined radiation and conduction. General as well as limiting forms of the govering equations are presented and solutions are obtained numerically by employing the method of variation of parameters. Specific results are obtained for CO, CO2, H2O, and OH. The information on species H2O and OH is of special interest for the proposed scramjet engine application. The results demonstrate the relative ability of different species for radiative interactions.