Engineering topics

Sines, G.

Publications and source records attributed to Sines, G..

4 records

NASA NTRS1979

Biaxial and uniaxial data for statistical comparisons of a ceramic's strength

The uniaxial and equibiaxial tensile strengths of a brittle material were measured in bending. Equibiaxial tension was attained by concentric ring loading of disks and uniaxial tension by four-point line loading of plates. The two specimen designs give equal volumes, surface areas, and stress gradients. Ground surfaces and lapped surfaces were tested. The equibiaxial tensile strength of a dense alumina was lower than the uniaxial tensile strengths for both ground and lapped surfaces, 8.5 and 8.1%, respectively. The Batdorf theory of flaw statistics, in which biaxial tensile strengths can be predicted from the statistical distribution of uniaxial tensile strength measurements, agreed with the data.

Giovan, M. N.↗

NASA NTRS1978

A statistical, micromechanical theory of the compressive strength of brittle materials

A general theory of the compressive strength of brittle materials is presented. This theory proposes that failure is brought about by structural weakening from accumulated crack damage which increases with the stress level. The statistics of the flaw distribution and the mechanism of crack initiation and extension are important. A sample calculation using the theory is given to demonstrate its application

Adams, M.↗

NASA NTRS1978

Crack extension from flaws in a brittle material subjected to compression

The mechanisms by which cracks extend from flaws in brittle materials subjected to compressive loads are presented. Although it is recognized that most geological materials are neither dense nor single-phase, this experimental study and analysis are restricted to single-phase, dense materials in order to provide a model amenable to analysis and experimental confirmation. The flaws which occur in dense, single-phase materials are divided into three types, each type having different characteristics of crack extension. Experimental studies of crack extension from flaws introduced into blocks of polymethylmethacrylate plastic are described. The studies show that crack extension from three dimensional flaws is more complex than two-dimensional theories predict. The extension of secondary cracks may result in more damage than that which would be predicted by considering only the primary crack extension treated by current theories. The importance of the dynamic behavior of flaws which stick and then suddenly slip is shown.

Adams, M.↗

NASA NTRS1978

Compression testing of ceramics

The techniques for determining the compressive strengths of the rapidly developing family of super-strong, but brittle, materials is considered. The uniaxial column compression test is discussed, taking into account the loading block size mismatch, the loading block compliance mismatch, the load transmitting surfaces, and the eccentricity of loading. A description of the uniaxial hollow cylinder compression test is also provided, giving attention to premature failure from compliance tube splitting, stresses from compliance mismatch of the loading block, and premature failure from local rotations. The ring compression test is considered along with the hollow cylinder biaxial compression test.

Sines, G.↗