Engineering Papers⌕ Search

Engineering topics

Sholl, David S.

Publications and source records attributed to Sholl, David S..

At least 19 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Incorporating Diurnal and Meter-Scale Variations of Ambient CO 2 Concentrations in Development of Direct Air Capture Technologies

To be implemented on climate-relevant scales, direct air capture of CO 2 (DAC) will require large capital-intensive facilities and careful attention to cost minimization. In making decisions among potential sites for DAC facilities, all of the factors that will impact process cost and efficiency should be considered. In this paper we focus on a factor that has previously received little attention in the DAC community, namely variations in atmospheric conditions on hourly time scales and length scales of meters. We present data curated from extensive previous studies of biosphere-atmosphere fluxes with observations of CO 2 concentration, temperature, and relative humidity (RH) with hourly resolution from many sites in North America. These include locations where typical diurnal variations in CO 2 concentration during summer months exceeds 150 ppm. These variations are larger than the seasonal variations that exist between averaged CO 2 concentrations in winter and summer, and they are highly correlated with diurnal variations in temperature and RH. Diurnal variations are dependent on the height above ground at which CO 2 concentrations are measured, with smaller variations existing at heights of 10 m or more than at ground level. We illustrate the potential implications of these short-term variations for the operation and optimization of a DAC process with process-level calculations for a specific adsorption-based process using amine-rich adsorbents.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2024

Sub-Ambient Performance of Potassium Sarcosinate for Direct Air Capture Applications: CO 2 Flux and Viscosity Measurements

Absorption based direct air capture (DAC) technologies have garnered significant interest in recent years due to their scalability, competitive regeneration energy requirements, and low susceptibility to degradation. One of the key advantages of DAC lies in its flexible siting options and the potential to utilize low-value land. However, most of the research in this field has been focused on ambient climate zones (T > 20 °C), overlooking sub-ambient (–30 °C < T < 20 °C) regions, which comprise approximately 70 % of the Earth’s surface. To fully realize the potential of DAC, it is essential to understand how DAC solvents perform in these sub-ambient conditions before any large-scale deployment can be considered. Among DAC solvents of interest, potassium sarcosinate (K-SAR) has emerged as a promising candidate due to its high CO 2 capacity, fast uptake kinetics, compatibility with contactor packing materials, low volatility, good thermal and oxidative stability, and competitive regeneration energy requirements compared to current industry standards. This paper characterizes the CO 2 flux and viscosity of K-SAR at sub-ambient conditions and explores the potential of using ethylene glycol and triethylene glycol as additives to prevent solvent freezing in DAC applications. For 1 M K-SAR, the CO 2 flux ranges between 1.3 × 10 -5 and 8.0 × 10 -5 mol m –2 s –1 across a temperature range of –5 °C to 45 °C. Ethylene glycol is shown to effectively suppress the freezing point of K-SAR below –30 °C with volumetric loadings of the additive as low as 0.1. Here, a reaction model was developed to predict the CO 2 flux for 1 M K-SAR at different temperatures, demonstrating good agreement between experimental and theoretical fluxes.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2024

Exploitation of Pore Structure for Increased CO 2 Selectivity in Type 3 Porous Liquids

CO 2 capture requires materials with high adsorption selectivity and an industrial ease of implementation. To address these needs, a new class of porous materials was recently developed that combines the fluidity of solvents with the porosity of solids. Type 3 porous liquids (PLs) composed of solvents and metal–organic frameworks (MOFs) offer a promising alternative to current liquid carbon capture methods due to the inherent tunability of the nanoporous MOFs. However, the effects of MOF structural features and solvent properties on CO 2 –MOF interactions within PLs are not well understood. Herein experimental and computational data of CO 2 gas adsorption isotherms were used to elucidate both solvent and pore structure influences on ZIF-based PLs. The roles of the pore structure including solvent size exclusion, structural environment, and MOF porosity on PL CO 2 uptake were examined. A comparison of the pore structure and pore aperture was performed using ZIF-8, ZIF-L, and amorphous-ZIF-8. Adsorption experiments here have verified our previously proposed solvent size design principle for ZIF-based PLs (1.8× ZIF pore aperture). Furthermore, the CO 2 adsorption isotherms of the ZIF-based PLs indicated that judicious selection of the pore environment allows for an increase in CO 2 selectivity greater than expected from the individual PL components or their combination. This nonlinear increase in the CO 2 selectivity is an emergent behavior resulting from the complex mixture of components specific to the ZIF-L + 2'-hydroxyacetophenone-based PL.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2024

Magnetic nanoparticle‐induced sorbent regeneration for direct air capture

Direct air capture (DAC) is a promising technology for decarbonization through the removal of CO 2 from the atmosphere. In many DAC processes, the regeneration energy used to restore the capture capacity of sorbents accounts for a significant fraction of the energy required by the whole process. Here we report an effective and scalable sorbent regeneration method for liquid DAC solvents based on magnetic nanoparticles (MNPs) heating with AC magnetic fields. MNPs can be directly heated to provide uniform and rapid volumetric heating, as we demonstrate by promoting the release of captured CO 2 from an aqueous solution of potassium sarcosinate. Our results showed that 90% of the solvent can be regenerated within 7.5 min of heating through proposed technique. The MNPs and solvent are found to be stable during the regeneration process and the MNPs showed long-term stability in the CO 2 -saturated solvent. Cyclic experiments showed that the nanoparticles can be reused for multiple cycles without performance deterioration. The process is operated in a noncontact mode through electromagnetic waves, making it an adoptable approach for existing carbon capture systems. The MNPs heating provides an effective regeneration strategy for liquid solvents used in carbon capture processes, in particular for DAC.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2024

The Open DAC 2023 Dataset and Challenges for Sorbent Discovery in Direct Air Capture

Direct air capture (DAC) of CO 2 with porous adsorbents such as metal-organic frameworks (MOFs) has the potential to aid large-scale decarbonization. Previous screening of MOFs for DAC relied on empirical force fields and ignored adsorbed H 2 O and MOF deformation. We performed quantum chemistry calculations overcoming these restrictions for thousands of MOFs. The resulting data enable efficient descriptions using machine learning.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2024

A US perspective on closing the carbon cycle to defossilize difficult-to-electrify segments of our economy

Electrification to reduce or eliminate greenhouse gas emissions is essential to mitigate climate change. However, a substantial portion of our manufacturing and transportation infrastructure will be difficult to electrify and/or will continue to use carbon as a key component, including areas in aviation, heavy-duty and marine transportation, and the chemical industry. In this Roadmap, we explore how multidisciplinary approaches will enable us to close the carbon cycle and create a circular economy by defossilizing these difficult-to-electrify areas and those that will continue to need carbon. Here, we discuss two approaches for this: developing carbon alternatives and improving our ability to reuse carbon, enabled by separations. Furthermore, we posit that co-design and use-driven fundamental science are essential to reach aggressive greenhouse gas reduction targets.

09 BIOMASS FUELS↗
DOE OSTI2024

Machine Learning and IAST-Aided High-Throughput Screening of Cationic and Silica Zeolites for Alkane Capture, Storage, and Separations

We present an approach for quantitatively predicting the temperature-dependent single-component adsorption behavior of linear alkanes in silica and Na-exchanged cationic zeolites using machine learning (ML) models trained from extensive molecular simulations based on force fields with coupled cluster accuracy. A high-performing classification model was developed to distinguish between instances with negligible and non-negligible adsorption. Subsequently, two ML models were trained to predict the single-component adsorption loading and the heat of adsorption at any pressure at 300 K for any zeolite topology and silicon-to-aluminum ratio. The ML models were trained on International Zeolite Association (IZA) zeolites, and their transferability to hypothetical zeolites was successfully validated. We then expand the power of these predictions to adsorbed mixtures at arbitrary temperatures by integrating them with the Clausius–Clapeyron equation and ideal adsorbed solution theory (IAST). This approach was validated and then applied to a temperature swing adsorption separation process to demonstrate its practical utility. We demonstrate how predictions from this ML-enabled approach can allow the selection of high-performing materials that are then validated using detailed molecular simulations based on quantitatively accurate force fields.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Discovering Dinuclear Dioxygen-Bridged Cobalt(III) Complexes for Selective Binding of O 2 from Air

The design and development of dioxygen activation in porous crystalline materials is a useful avenue for exploring selective adsorption of O 2 that shows significant potential to enable separations of O 2 and N 2 from air. Porous materials featuring redox-active metal centers have received attention regarding selective O 2 adsorption via chemisorption. Drawing inspiration from a dinuclear cobalt material ([(Co(III) 2 (bpbp)O 2 ) 2 bdc](PF 6 ) 4 (CSD code: GAMVIB; bpbp – = 2,6-bis(N,N-bis(2-pyridylmethyl)aminomethyl)-4-tert-butylphenolato; bdc 2– = 1,4-benzenedicarboxylato)) that displays reversible and selective O 2 adsorption, we focus on searching for potential O 2 -selective materials with dinuclear cobalt clusters that have dioxygen-bridged Co(III) complexes. We combine structure screening with a high-level hybrid periodic density functional theory (DFT) workflow to investigate O 2 and N 2 adsorption in materials from validated crystal structure databases (e.g., the CSD database). These calculations identify multiple materials that are predicted to have superior O 2 binding capability relative to GAMVIB. Grand Canonical Monte Carlo (GCMC) simulations based on DFT-developed force fields were performed for selected candidates to estimate the adsorption performance for O 2 /N 2 mixtures.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Computational Screening of Cationic Zeolites for n -Butane/Methane Separations Using Quantitatively Accurate First-Principles-Derived Force Fields

We developed force fields for linear alkanes in Na and Ca-exchanged zeolites based on periodic first-principles calculations with coupled cluster corrections. These force fields were validated by comparing the simulated adsorption properties with extensive experimental data. As an example of using these force fields, we screened silica and aluminosilicate zeolites for separation of n-butane/methane mixtures in several different separation processes. A key step in this screening was the use of an interpolation method to create accurate zeolite structures that take account of the lattice constant changes for different Si/Al ratios for a given zeolite topology. We focused on zeolite structures that have known synthesis routes, so the materials selected from our calculations can be tested experimentally. Several promising materials that show good separation performance were selected for more detailed simulations.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Quantum Chemical Simulations of CO 2 and N 2 Capture in Reline, a Prototypical Deep Eutectic Solvent

Deep eutectic solvents such as reline are an emerging class of low-cost, environmentally friendly solvents with tunable properties that are potentially applicable for the capture and separation of CO 2 . Experimental measurements showed that a reline-based membrane contactor can capture and separate CO 2 via physisorption through a dissolution process with 96.7% purity from a mixed gas containing CO 2 and N 2 (50:50% molar ratio). Here, we examine the nature of the interaction of CO 2 and N 2 with reline employing quantum chemical methods. We focus on explaining the mechanism by which CO 2 and N 2 bind to reline and the reason for the high selectivity for absorption of CO 2 compared to N 2 . We analyze the dynamics, energetics, and binding motifs for CO 2 and N 2 in reline employing density functional theory, density functional tight binding, and ab initio molecular dynamics. We also investigate the effect of reline on the vibrational spectra of CO 2 and reline. Our simulations indicate that the selective capture of CO 2 from the mixture of CO 2 and N 2 is due to the interplay between attractive electrostatic and charge polarization forces with opposing entropic effects, which shift the energetic balance and make the N 2 absorption unfavorable in reline.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
NASA NTRS2003

Chiral selection on inorganic crystalline surfaces

From synthetic drugs to biodegradable plastics to the origin of life, the chiral selection of molecules presents both daunting challenges and significant opportunities in materials science. Among the most promising, yet little explored, avenues for chiral molecular discrimination is adsorption on chiral crystalline surfaces - periodic environments that can select, concentrate and possibly even organize molecules into polymers and other macromolecular structures. Here we review experimental and theoretical approaches to chiral selection on inorganic crystalline surfaces - research that is poised to open this new frontier in understanding and exploiting surface-molecule interactions.

Review↗
NASA NTRS1993

Optimal resolution in maximum entropy image reconstruction from projections with multigrid acceleration

We consider the problem of image reconstruction from a finite number of projections over the space L(sup 1)(Omega), where Omega is a compact subset of the set of Real numbers (exp 2). We prove that, given a discretization of the projection space, the function that generates the correct projection data and maximizes the Boltzmann-Shannon entropy is piecewise constant on a certain discretization of Omega, which we call the 'optimal grid'. It is on this grid that one obtains the maximum resolution given the problem setup. The size of this grid grows very quickly as the number of projections and number of cells per projection grow, indicating fast computational methods are essential to make its use feasible. We use a Fenchel duality formulation of the problem to keep the number of variables small while still using the optimal discretization, and propose a multilevel scheme to improve convergence of a simple cyclic maximization scheme applied to the dual problem.

Limber, Mark A.↗